Having problems with your Dell UltraSharp 2001FP 20.1" LCD Monitor ?

How to disassemble monitor Dell 1800fp ?

\015 How to disassemble monitor Dell 1800fp ?\015

Answers :

Remove the base by the button release or 4 screws on the back. On the bottom of the monitor near the corners you will find two thin slots where you can insert a thin wide blade screwdriver or pry tool. Very gently pry the back from the bezel toward the center from both of these slots until the bottom is seperated, then contilue from the slots around the corners and up the sides until you have seperated the entire back from the bezel. Lay the monitor on the bezel and remove the back ( do not try to remove the bezel, at least not yet). Lift the tape that secures the ribbon cable from the bezel buttons to the logic board. Unplug the ribbon cable from the logic board by pulling on the connector (not the cable). Remove the cable covers from the back of the case (one has a screw, the other has a lift tab) and disconnect the lamp connectors and ribbon cable connectors (do not pull on the wires). remove four screws and lift the metal back from the screen.
Remove the base - either button release, or 4 screws. If there are any other screws in the monitor case, remove them.\015\012\015\012Depending on how old this model is, Dell monitors usually need to be pried apart, the front coming off and separating from the back. If this is the model with the vents on the top and bottom, this is a good place to start (separate the front from the back by prying it gently all the way around)\015\012\015\012If it's a newer model, similar to a 1905FP, the front bezel needs to be pried away from the back. The front bezel piece is only about 1/4" think, and you may be able to start opening it with a very thin but wide flat screwdriver.
Repair Help & Product Troubleshooting for Dell UltraSharp 2001FP 20.1" LCD Monitor

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dell 1800FP has slight yellow cast


Your Display cable (inside your monitor) needs to be replaced. (Or reseated)I would look on ebay to try and find the part and then take it to a local tech to replace it for you as I would not recommend anyone take apart a monitor (LCD OR ... Dell UltraSharp 1800FP 18.1" LCD Flat Panel Monitor

Dell LCD - Power problem


To my knowledge, there is no easy fix. If the LCD is not powering on and your AC adapter indicates there is power, then it is in the circuitry of the LCD assy and your best bet is a TV repairman.Odds are, that you can buy a replacement c ... Dell 1503FP 15" LCD Monitor

Dell UltraSharp 1800FP - display leak - blue craziness


That one is going to take component level troubleshooting.\015\012\015\012It could be the power suply, but I might first suspect the video board. ... Dell UltraSharp 1800FP 18.1" LCD Flat Panel Monitor

How to disassemble monitor Dell 1800fp ?


Remove the base by the button release or 4 screws on the back. On the bottom of the monitor near the corners you will find two thin slots where you can insert a thin wide blade screwdriver or pry tool. Very gently pry the back from the bezel toward ... Dell UltraSharp 2001FP 20.1" LCD Monitor

Dell 1800FP I need to know how to test for 5v and 12v of Power Supply for Dell 1800FP Do I touch ground w/ muti meter lead and then touch each output pin that goes to ribon cable? I am getting zero voltage. Even going across two pins at the same time, I am getting zero. I think the supply is bad but I am not sure I am testing it correctly. Any advice would be appreciated. Tripp English


What's wrong with your monitor? ... Dell UltraSharp 1800FP 18.1" LCD Flat Panel Monitor

Dell 1800FP - no power


Hi pcpiukIf you have a multimeter, and want to get into the electronics of it all, you could rip the covers off and sus it out. Here is a ... Dell UltraSharp 1800FP 18.1" LCD Flat Panel Monitor

1800FP image distorted


This is a little known porblem Dell has. Dell is not tell anybody.\015\012I don't know if this is going to fix the monitor for the long haul, but it should help in the mean time.\015\012grable the frame of monitor with both hands, apply s ... Dell UltraSharp 1800FP 18.1" LCD Flat Panel Monitor

Led flashing no picture


Disconnect the signal cable from the computer. if it shows color bars, it means your monitor is ok and your video card is faulty. if it still does the same thing. you need to reseat the video card if its not integrated. \015\012\015\012ho ... Dell 1800FP Monitor

Dell fp monitor


................. ... Dell UltraSharp 1800FP 18.1" LCD Flat Panel Monitor

Need Cyberdrive / khypermedia dvd cdx082d xp drivers


I think it may be the dm168d driver, but I cannot be sure from the info.http://www.cdrom-drivers.com/drivers/126/126445.htmAlso found a guy at the following link who has one or a very similar one.http://club.cdfreaks.com ... PC Desktops

My dell ultrasharp 1800fp monitor keeps flashing on and off, its not a power problem as the power button stays on and when i disconnect the the monitor cable from my pc the no signal message stays on the screen fine. it used tostay on on if left for about 10 mins. now it just blinks constant. any help on this would be great


Inside there is a IC chip on the power pack that goes bad, replacement is called for also look for bad capacitors when you are inside looking around, those need to be replaced as wellhope this clears things up. dells third party who built these ... Dell UltraSharp 1800FP 18.1" LCD Flat Panel Monitor

Installed windows 7 and since then it will not recognize my dell 1800fp driver in only reponds to a genieric that without any color problems i can only use 640 x 480. any ideas already tried update


Sounds like a definite driver problem. I'd check dell.com/support with the 1800FP put in should see a driver download for the windows 7 os. ... Dell UltraSharp 1800FP 18.1" LCD Flat Panel Monitor

Left half of screen is perfect. Right half of screen shakes


1800fp is LCD display , it doesn't depend on magnetic field ... Dell UltraSharp 1800FP 18.1" LCD Flat Panel Monitor

Dell ultrasharp blinks on and off


It could be a setting problem, power saver setting, or a mode that the monitor does not really support - things like refresh rate - or actual hardware.\015\012\015\012Easiest way is to borrow another like monitor, and say another video co ... Dell UltraSharp 1800FP 18.1" LCD Flat Panel Monitor

Monitor on but not working properly


Or you can reset the cmos jumper as well ... Dell UltraSharp 1800FP 18.1" LCD Flat Panel Monitor

Dell 1800fp lcd monitor keeps on flashing picture, then black, picture, then black. no matter what setting i put in the display settings , it keeps on flashing. what can i do?


... Dell UltraSharp 1800FP 18.1" LCD Flat Panel Monitor

Dell 1800FP monitor. Will not power up at all. Checked power cord on another machine, works fine. Monitor is from 2002, but was working perfect till yesterday. Is this worth fixing?


Take it apart and check the fuse. Sometimes is just a simple component damaged.Have it checked in a specialist electronics house if you prefer. ... Dell UltraSharp 2001FP 20.1" LCD Monitor

Dell 1800FP no power when plugged in, includes no LED


I had same problem. Changed power cable...nothing. Changed fuse (315mh-250v), reassembled and I am now looking at it! ... Dell UltraSharp 1800FP 18.1" LCD Flat Panel Monitor

Dell UltraSharp 1800FP is black on start up but green light is on


I had the same problem i found out it was the inverter i replaced it and it was like new. i do have 2 inverters if you are intrested ... Dell UltraSharp 1800FP 18.1" LCD Flat Panel Monitor

I have a Dell 1800FP monitor. I get no power lights at all


Hi,\015\012 finding the fault in power supply is bit difficult , as it either works or goes bad . You can check this website for reworked power\015\012supplies.\015\012 ... Dell UltraSharp 1800FP 18.1" LCD Flat Panel Monitor

Dell Ultrasharp 1800FP Power Saving Mode


Go to control panel>power option>power scheme.\015\012adjust the hard drive to 30 mins and everthing else 20 minutes.\015\012also, go to display and adjust the screen saver to be longer. up to 9999min. ... Dell UltraSharp 1800FP 18.1" LCD Flat Panel Monitor

1800FP Dell Monitor Light continuously blinks no picture


I have made a solution to this and it can be found on my website here:\015\012http://www.dorchestercomputerrepairs.com/1800.html\015\012Hope ... Dell UltraSharp 1800FP 18.1" LCD Flat Panel Monitor

Dell 1800fp I took my lcd monitor apart hoping the fuse was just blown but it wasn't, I then grabbed my multimeter to do some troubleshooting and I had my 120 volts A.C. but I checked at the pin connector p902 (gnd 5v gnd 12v) and I had no voltage as a matter of fact everything was grounded. Should I always have voltage at those points or only when the power button is pushed. (Oh Yea no led when plugged in also)


1. Replace IC901 (ICE2AS01)\015\0122. Check Q902 (11P60C2) could be S/C.\015\012 (both of the above seem to be available from China only.)\015\0123. Replace C905 (120mF, 400V.\015\0124. Replace bothof the snuber re ... Dell UltraSharp 1800FP 18.1" LCD Flat Panel Monitor

Ice 2as01 is broken again


Resolder diodes D903 and D906 in the secondary of power supply. The diodes are the two mounted to a heatsink. These are the reason the 2AS01 goes out in the first place. The solder joints on these two diodes breaks loose. If you don't solder them, th ... Dell UltraSharp 1800FP 18.1" LCD Flat Panel Monitor

Monitor is dead


I have made a solution for this for you which can be found on my website here:\015\012http://www.dorchestercomputerrepairs.com/1800.html\015\ ... Dell UltraSharp 1800FP 18.1" LCD Flat Panel Monitor
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.3139 seconds