Having problems with your Dell UltraSharp 1704FPT 17" Flat Panel LCD Monitor ?

Dell 1907FPC Flat Panel Display went dead

\015 Someone was cleaning the windows in my apartment and sprayed water that went thru the back of my monitor while it was on.\015\012I tried to run it over the next couple days and it did start once.\015\012I diconnect it from the computer, and plug it thru the wall outlet, it came on, I tried it later it did not come on, then it came on but cannot turn it off with the button unless i unplug it.\015\012I took it apart and got to the two circuit board, one for the ac circuitry and the other for the USB, etc.\015\012I looked for a fuse but did not find any on the boards.\015\012What do I look for? I am very handy with a soldering iron and knows how to replace any component from a resistor to a cap, etc..\015\012Very much appreciated.\015

Answers :

Best case; Look for residue on the boards. The liquid conducts and will create paths of metal film. This can be enough to screw with the controls. Look for white or green powdery trails. You can clean this with distilled water and a soft brush a bit of white vinegar will help if its stubborn. Take care to flush off all the vinegar and keep it away from the LCD panel. Blow all the water off the boards and make sure they are totally dry before powering up.

Worst case; You may find leads eaten right off of the parts. You are up the creek.

Good luck
Repair Help & Product Troubleshooting for Dell UltraSharp 1704FPT 17" Flat Panel LCD Monitor

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dell 1907FPC Flat Panel Display went dead


Best case; Look for residue on the boards. The liquid conducts and will create paths of metal film. This can be enough to screw with the controls. Look for white or green powdery trails. You can clean this with distilled water and a soft brush a ... Dell UltraSharp 1704FPT 17" Flat Panel LCD Monitor

Black screen flashes after initial power up


This happened to me, and I fixed it, so read on! Switch on... green LED for a couple of seconds, Brief flash of light with display working, the total shutdown. Switch off, repeat but press the front panel power button as soon as the green LED comes ... Sony SDM-HS73P 17" LCD Monitor

Tear in lcd flat panel


If the scratch is in the frame surrounding the viewing area and the monitor still works, I wouldn't worry about it. However, if the scratch was caused by a drop, it is possible that an intermittent connection will eventually develop and make the moni ... Dell Dimension 4600 PC Desktop

DELL Inspiron 5150 isnt booting


If it doesn't respond at all with no ram or hdd, it is likely that the board is in fact dead.....sorry. When you say you found a broken pin, I assume you mean one of the contacts from the power jack to the main board had a cracked solder joint and yo ... Dell Inspiron 5150 Notebook

LCD monitor no display - flashing power button


Hate to criticize and then not help out. I have this exact same problem with one of my E152 Dell Displays. I have read around and this whole line of displays seemed to have trouble. I found many issues like this and no solutions. \015\012So ... Dell E152FPc 15" TFT LCD Flat Panel Monitor

Milk white screen.


Hi,\015\012You are having pixel problem..\015\012Pixel guidance will vary according to the flat panel purchased from Dell. E151FP This has a standard 2 bright pixel defect tolerance before Replacement will ... Dell E151FP 15" Flat Panel LCD Monitor

Suddenly crash and cannot reboot


If you have some power on the computer, then it could be possible that the LCD panel or video card is dead. To identify the issue, connect it to a external monitor and then start the computer. Press 'Fn' and 'F8' to toggle the display. If the display ... Dell Inspiron 6000 Notebook

Dell E152 Flat Panel screen is REALLY dim.


I haven't seen this particular monitor. It may have deeply recessed black screws, or possibly even Torx screws. Try a #2 Phillips and see if it engages firmly. If not, try a T-10. Once you get inside, you will need to remove the power supply and main ... Dell E172FP 17" LCD Flat Panel Monitor

Lcd flat panel goes dead when is used as primary display


Becuse u set primary disaply as 2nd .and alsio there is resolution problem.\015\012set that monitor with your frineds desktop and when u power up the computer Press F8 key then \015\012u got menu then go to enable VGA mode.then change yo ... PC Desktops

Problem with Fan - Dell Laptop Inspiron B130 ?


Hello,\015\012\015\012If the fan is dead, then the laptop will shut itself off after a short while to prevent heat damage. It is normal for the fan to spin up when you turn on the laptop and then stop turning. The fan will kick in again w ... Dell Inspiron B130 Notebook

I have a Dell monitor and the text is blurry and fuzzy, how do I fix this?


This is actually from dell support website.. hope it will correct your problem...\015\012\015\012\015\0121 Ensure the correct resolution is set for the monitor. Flat panel monitors display the sharpest, clearest images when set ... Gateway FPD2275W LCD Monitor

Dell c640 my daughter spilled water on the lap top while it was running. should I take it apart and see if i can fix it. of course I will need your help.


There may be dead integrated circuits on the main board since they often operate with extremely low currents and may not tolerate being subjected to voltages that could be applied via even very clean water; the stuff is conductive.\015\012\015\ ... Dell Latitude C640 Notebook

Monitor powers on for approx 8 secs then standby.Series of vertical stripes on panel but no image.Guessing the lcd is at fault?


When I applied the solution below, I go stripes when poorly reconnecting the logic board to the plate, and the plate ability to do it job can be effect by bits going on the inverter, wavely screen output etc. The lcd is an assembly kit inside have a ... iiyama ProLite E434S 17" LCD Monitor

Error: Cannot Display This Video Mode


You may have to boot into safe mode and reset the video settings to a safe setting like 1024x768.\015\012\015\012To get into safe mode, continuously press F8 while the computer is booting up.\015\012 ... Dell OptiPlex GX620 PC Desktop

Dell Vostro 1500 Repair manual and parts for backlight and inverter


You cannot replace the backlight. It is incorporated into the lcd panel and not available as a separate part. The inverter board is very easy to replace. It is located right behind the dell logo at the bottom centre of the display panel. Remove the s ... Dell Vostro 1500 Notebook

DVI output problems with Acer Veriton M464


If you are comfortable with opening the case, you can try this: Unplug the power supply, make sure are constantly grounded (touching metal)remove add-in video card. Locate the "Clear CMOS" jumper (usually 3 pins in a row with two shorted via a plas ... Acer PC Desktops

Thanx for the advice


Are you using a vga to dvi adapter then? Even though this usually is not an issue with older flat panels I have seen this problem where only a dvi to dvi will work. Secondly, If the panel calls for those extra amps you do need them and a replacement ... MPC Computers Envision EN 7100s 17 in. Flat Panel LCD Monitor

No picture or power green light just blinks - Sceptre X9G Komodo II (Black) 19 in. Flat Panel LCD Monitor


Carrizosas, Tell me more. How old? Approx. total "ON" hours of use? Did it display a "bright, crisp, full color text and graphics and pictures the day before? Does this unit have a lay on floor "BLACK BRICK" ac to dc supply, or only a 3 wire line cor ... Sceptre X9G Komodo II (Black) 19 in. Flat Panel LCD Monitor

I was tring to Connect Two Computers to One Monitor, but i didnt get it, does someone know how to do so? I bought a KVM switch, USB to use between a new Acer running Win XP and old Dell with Win 98. Could not get the Dell to show up on the monitor, although the correct light shows up on the KVM and the USB mouse lights up when the computer boots. -- Read a few minutes ago about a source switch and found that my flat panel has a menu item to switch from analog to digital input. Could that be the


I guessing that since **-one responded you've given up and returned the whole mess but what the hey.A lot depends on the KVM you're using. There are some high end units that will match different sources to the monitor but most work best ... AOC 19LVWK LCD Monitor

Dell Dimension 5100, Doesn't Boot Up, Display Lights Up "!, 2 3"


2 green lights usually indicate a memory problem, however, when you get 3 lights, RAM is good, but the BIOS is unable to hand off to the operating system.To test this, disconnect your hard drive (both ribbon and power) and connect the mon ... Dell Dimension 5100 (D51L1) PC Desktop

Dell 4700 sleep on bootup


Ok here's what i can suggest. Two things.1. Check your power settings by going to the Control Panel and then going to Power Options. Take a look at the power schemes..specifically the option where it says turn of monitor...you can select the ... Dell Dimension 4700 PC Desktop

Display after rain went black


If your video output works fine when connected to an external monitor, then the issue is with the LCD display panel. I’m afraid the only way to fix this is to have the LCD panel replaced. \015\012 ... Dell Inspiron 6400 Notebook

Computer compaq nc 6000 power off during working


Hi, If you feel the power adapter working fine with the diff unit its not an issue with the adapter,Now, if the unit is not powering on.just perform this:Take out the batter, adapter and make the unit stand alone a ... HP Compaq nc6000 Notebook

Hi. i am using Dell inspiron 6400. i have been using it for more than a year now. since yesterday i am experiencing a new kind of problem. my display was working fine untill yesterday. i have windows XP as well as ubuntu. in the boot menu, the option screes appears, for choosing ubuntu or windows. i normally use windows. but yeaterday, when the selection screen came on, the display went from black to reddish kind of colour, then pitch black. i immediately turned my laptop off. then later i resta


Sounds like you have a failing backlight. The flourescent tube at the bottom of the LCD that make the screen bright enough to see will change to a reddish tinge as it goes bad. Eventually the tube will not generate light at all and the screen will go ... Dell Inspiron 6400 Notebook

Dell 6000 laptop screen blanks out - bought new screen


Hi,ManualsBack to Contents PageDisplay Assembly and Display LatchDell Inspiron™ 6000 Service Manual ... Dell Inspiron 6000 Notebook
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.6474 seconds