Having problems with your Dell PowerEdge 1800 Server ?

Flshing Red Light on Dell Poweredge 1800 Server

\015 I Have a Dell Poweredge 1800 server and the Green Light on the front face has recently changed to a Red Flashing Light. Everthing appears to be running ok but is the red light telling me that there is a problem?\015

Answers :

I finally made contact with our IT dept who were abole to carry out a remote diagnostic test.
\015\012Problem has now been identified (problem with tape drive)
Repair Help & Product Troubleshooting for Dell PowerEdge 1800 Server

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Flshing Red Light on Dell Poweredge 1800 Server

I finally made contact with our IT dept who were abole to carry out a remote diagnostic test.\015\012\015\012Problem has now been identified (problem with tape drive) ... Dell PowerEdge 1800 Server

Help with server boot problems flashing orange lights etc

Seems the RAID is broken. You may see which drive (hot swappable?) it showing an error code with its lights in front. If not, I would suggest re-seated all drives.If you see one that is not right, remove it all the way, while it is on, then pus ... Dell PowerEdge 4600 Server

In front pannel RED light is on and off what is the reasion

Dell poweredge servers having two power supply check you have given connection to the both power supply units and retart the server its turns to blue Thanks ... Dell PowerEdge 2600 Server

Beeping Upon Bootup

Hi,PE2400 using beep code and message error for troubleshooting.if you want accurate which part problem checking using Dell Diagnostic 32bit Diag. ... Dell POWEREDGE 2400 Server

Server is giving beep with red light on.

Hi Mirwais,\015\012The beeping problem could be an indication of a few issues. One of which could be that the hard drive is overheating and when you remove it for those ten or twenty minutes, the drive cools and the problem disappears until the ... Dell PowerEdge 1800 Server

No Boot on 1600sc

The easy answer is:\015\012\015\012Did you ensure the CPU fan connector is attached to the PROPER motherboard CPU fan power pins?\015\012\015\012The 2nd easy answer is:\015\012\015\012Are you sure your CPU is properly placed inside the socket? Could ... Dell PowerEdge 1600SC Server

Dell Poweredge 4300 Bootup problem after cmos battery replacement

Check the version for the Raid Controller. This may need to have the firmware to be upgraded. If the controller is removable, take the controller out and then see if the computer will continue past the bios. If the controller is built-in, then disabl ... PC Desktops

Flashing redlight on the front

Yes. Here are some things that could be an issue:\015\012\015\012a problem with power supplies, fans, system temperature, or SCSI hard drives.\015\012\015\012Install the Dell Open Manager software to run diagnostic. It will ... Dell PowerEdge 1800 Server

Beeping PowerEdge 1300

When a Dell server beeps in every 3-5 second that mean it comes from Raid controller.Dell calls PERC Controller.It usually reason of a disk failure.Install open manage server administrator on your server.See which disks ... Dell PowerEdge 1300 Server

Dell Poweredge 4300 will not boot up after cmos battery replaceme

Configure your System bios and reboot. Your Hard disk drive was not configured. Pl configure. it will work properly ... Computer Servers

Dell Poweredge SC1420 won't boot up

Amber lights are typically bad.\015\012\015\012Good news, Dell has lifetime phone support for their servers.\015\012\015\012Write down the Express Service Code and Service Tag number that is on the server chassis and call Dell ... Dell PowerEdge SC1420 (SC1420MIN) Server

Connect HP Proliant ML350 Server.

Hi,Please verify if your server power specs support 110 or 220 V. If you are in the US, eventhough you might have connected a 220V cable the line voltage can be 110.Check with your power company if they can provide you the necessary ... HP Compaq ProLiant ML350 G3 Server

Dell PowerEdge 2300 - Monitor, keyboard and mouse will not respond

It sounds like the power supply is failing.\015\012\015\012Failing power supplies will sometimes deliver just enough power to make the fans spin but not enough for the motherboard and drives to start.\015\012\015\012I hope thi ... Dell PowerEdge 2300 Server

Dell PowerEdge 1800

Probably a controller card failure- Shelon Padmore ... Dell PowerEdge 1600SC Server

ViewSonc VX924 LCD Monitor

Check the information at Viewsonic's website regarding their warranty:http://www.viewsonic.com/support/warranties/limited-warranty/If you have your proof-of-purchase and it shows the monitor is less than a year old, it would b ... ViewSonic VX910 19" LCD Monitor

Problems connecting to the internet

... Dell PowerEdge 1800 Server

Dell dimension 5510 it will not turn on, no

1/10th a volt? Nope.Bypass the Power On switch. See if you have a bad switch first.Then test the power supply. If the power supply comes on by bypassing the Power On switch, I'll bet you have a weak 12 volt voltage power rail. ... Dell Dimension E521 PC Desktop

I have a working Dell Poweredge 2650 with 2 x Xeon 1.8Gig processors, 5 x 36GB hard disks, running Windows 2003 Server. I have recently purchased a newer Poweredge 2650 with the same configuration except that it has 2 x Xeon 3Gig processors. I would like to transfer the OS and data from the ''old'' (slower) 2650 onto the ''new'' (faster) 2560 to improve general performance. The idea is to do it in one day, starting with the OS and data on the old 2650 and finishing the day with the OS and data

You should be able to do this by moving the drives all at once ALL DRIVES MUST BE PLACED IN THE SAME SLOTS 0,1,2,3,4, do not mismatch else it will be a nightmare ............HOWEVER BACKUP your data up if you are going this route,on paper it might s ... Dell Refurbished PowerEdge 2650 Server

Orange light on front of 2650 dell server - Dell PowerEdge 1800 Server

Review the server logs for output. Possible temperature warning. ... Dell PowerEdge 1800 Server

Poweredge 2600 power supplies in red

Possibly a power distribution board problem.PDB requires replacement. ... Dell PowerEdge 2600 Server

Dell poweredge 1800 scsi drive not found

Hi,check if the drive is showing in the bios of the server, shut down the server, take out the power cable, press and hold the power button so as to realease flea power, open the server, and reseat the data cable at both ends and if there ... Dell PowerEdge 1800 Server

Hi, we have an Dell PowerEdge 1800 Server, Today we relocated the server for that we shutdown the server and Relocated.When we the Start system nothing is displaying in the monitor. Keyboard light's were blinking when i start the system. First time i misplaced the power supply and UPS plug points and started the system. after 10 seconds i realised that i was wrong and switch the PC changed the plug points after i am facing the above problem. Please help Regards, Venkat

Hi,Most of the systems will not start back when the system shutdown happens due to some power conflicts.To resolve your issue, please follow the below steps:1. Make sure that all the connections to your server is proper now.2. ... Dell PowerEdge 1800 Server

It makes unexpectedly restart - Dell PowerEdge 6400 Server

This server should never restart as you describe \015\0121: Turn off remove all 3 power supplies clean, replace\015\0122: Clean the insides removes and reset each add-on card’\015\0123: Remove each of the SCSCI drive from the ... Dell PowerEdge 6400 Server

Monitor and keyboard will not respond

It only happens with your keyboard and mouse? or does it include your monitor too? if it does include you monitor then it is the video card. It is built in to your system and is causing the problem. I got the same issue before. My mouse doesn't work, ... Dell PowerEdge 2300 Server

Dell PowerEdege 1600SC not recognizing IO devices

Just go into the bios and insert the correct parameters. you shut it off before it could save the settings. Or hit fi on boot and it should take you into the bios and you cand sort it out in there. If you want an easy way, just do a system restore. S ... Dell PowerEdge 1600SC Server
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.7042 seconds