Having problems with your Dell PC Desktops ?

I turned the monitor to the left too far and it came off the stand- i can not get to stay on the stand


Answers :

Dear Davidmagen1,
\015\012
\015\012You said "i turned the monitor to the left too far and it came off the stand- i can not get to stay on the stand"
\015\012
\015\012If there are no openings on on the bottom of your monitor then use rubber cement to reattach the montor. The only surefire way to have a permanentlrey fixed monitor is to buy a new one. if it is a back projecting monitor then you shouldnt really need the stand.
\015\012
\015\012------------------------------------------
If i was helpful please rate me positively
Repair Help & Product Troubleshooting for Dell PC Desktops

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I turned the monitor to the left too far and it came off the stand- i can not get to stay on the stand


Dear Davidmagen1,\015\012\015\012You said "i turned the monitor to the left too far and it came off the stand- i can not get to stay on the stand"\015\012\015\012If there are no openings on on the bottom of your monitor ... Dell PC Desktops

Moniter stays blank


I used to repair LCD flat screen from Dell. I am not sure that my method might be applicable to your CRT monitor. Anyway this is how to examine what wrong with the monitor. You have to\015\012check if you can see the image on the screen or not after ... Relisys RLT1720 17" LCD Monitor

Monitor stays on for a few seconds then goes out


This problem is very often caused by dry electrolytic capacitors on the inverter board. If you have some skill with soldering you could try to change them. When buying new ones ask for LOW-ESR capacitors for switching mode power supplies (SMPS) and 1 ... Acer AL1711 17" Flat Panel LCD Monitor

Syncmaster paower button blinking and no display


First of all plug another monitor to the VC on your PC and do the same for the SamSung"I over heat"SyncMaster2 053BW. \015\012 \015\012\015\0 ... Samsung SyncMaster 204B 20.1" LCD Monitor

Monitor turns off after 2secs power light on


Oct 23, 2009- This is how it went for me..I have a Samsung SYNCMASTER ... Samsung SyncMaster 914V 19" LCD Monitor

Samsung syncmaster 245b plus


Oct 23, 2009- This is how it went for me..I have a Samsung SYNCMASTER ... Samsung 226BW Monitor

Hi, I'm having an issue with a Samsung monitor. On


Oct 23, 2009- This is how it went for me..I have a Samsung SYNCMASTER ... Samsung SyncMaster 920NW Monitor

Power save I have my laptop computer hooked to a monitor because the screen does not work on my laptop. The monitor suddenly went into power save mode and I can't get it off. Can you tell me what I need to do?Thank you!


Your laptop normally has a power profile that shuts the monitor off in order to extend the life of your battery and your LCD panel (which isn't working, of course). If you don't want it to manage your settings for you, simply change the power profil ... Dell Inspiron 2200 Notebook

Need to remove front bezel to install a touch screen panel onto a samsung 226bw monitor, cant figure out how to seperate the parts


- This is how it went for me..I have a Samsung ... Samsung 226BW Monitor

Relisys tl 766 monitor


I have a Dell E171FPB monitor that had the \015\012same problem with the Main Menu coming up and I thought I would tell you \015\012what I did to fix the problem.\015\012\015\012\015\012\015\0121. I shut down the PC.\015\012\015\01 ... Relisys TL 766 Monitor

Samsung syncmaster 730b blinking. switches from


Oct 23, 2009\015\012- This is how it went for me..I have a Samsung SYNCMASTER ... Computer Monitors

Samsung syncmaster 953bw


Oct 23, 2009- This is how it went for me..I have a Samsung SYNCMASTER ... PC Desktops

My 110v PC was plugged in 220v


There is no such thing as plugging something into 220v. That is the voltage at which your power supply will provide power to your computer. What you did was give your computer more power than it needed and you most likely burned out the mother boar ... E-Machines eMachines Desktop PC

Dell XPS 400 tower does not power up monitor?


The “self test” on the monitor displays when not plugged into a computer. This means that it’s working. The LED error code 2 and 4 means the video subsystem has a problem. Either your video card is bad or bad memory module. ... Dell XPS 200 PC Desktop

How to remove stand from iiyama E2607WDS monitor


One can only remove the plastic neck of the stand by removing not only its four visible screws, but also the two screws at the invisible inside of the neck. To get to these, you have to remove the neck together with its metal foot. To do so, you shou ... iiyama Computer Monitors

Faulty Monitor? I bought one of these Xerox flat panel 19 inch monitors to replace my convention Sony unit about 4-5 months ago. It has worked just fine until about 7 days ago. Are there any known problems with these Xerox units? I turn my computer off during the day, when I am at work. I also turn my computer off during the night when I am asleep. At those night times I also turn the 'blue power button' on the monitor off as well, as it will flash annoyingly in the room if left in the 'stand


I have also fixed my wife's Xerox monitor Thanks to all the posts on this website !!! I just fixed it yesterday. It was fairly easy.\015\012\015\012 I layed my on a clean towel. Like they said remove ... Xerox XG-91D 19" LCD Monitor

I have a Cornea 1702. It just stopped working altogether. It doesn't even show the menu nor does it search for a signal as it used to while scrolling thru options or select input! I think it's fried, but I remember some time ago i thought it was all done then it started working again. any thoughts?


OK, first off, I'd like to say that I've never worked on the Cornea 1702, but most monitors follow similar designs, especially generic brand monitors.So there are a few things I need to know: What exactly happens when you press the ... Cornea CT 1700 17" Flat Panel LCD Monitor

Toshiba Sattelite M45-S165 Power button or ? failure


You seem to have hit the nail on the head. Yes, the power on button seems to have gone. That is why nothing happens when you press this button. The lights coming on meas that the charger is doing its work and the switch is not. Please get the power o ... Toshiba Satellite A105 Notebook

Power button stuck


I have fixed three of these power supplies for Dell 1905FP. Once you get the power supply out like stated above. There are three capacitors the have bulges. Replace them with the exact same Farad rating and your finished. This is a common fault of th ... Dell UltraSharp 1905FP LCD Monitor

Gateway lp2207 appears power supply has burn out...is worth repair any suggestion on repair


Actually the problem is one of the capacitors on the power supply.\015\012\015\012 \015\012\015\012I have the same monitor Gateway LP2207 and just replaced the capacitor.\015\012\015\012 ... Gateway GT4010 (RBGT4010) PC Desktop

When I turn on my Sceptre monitor it stays on for a few seconds


This seems to be a comman fault with alot of monitors, the problem is caused by faulty componants on the power board called capacitors.If you have soldering skills and a bit electronic knowledge its an easy repair and one that you could t ... Sceptre Computer Monitors

Right half of screen is Black with a White vertical stripe


Yeah, I have this exact same problem, except my mom slammed my laptop shut in frustration around half an hour ago, so that's why it's like this. The right half of my screen is black with two colorful stripes (mostly white), but the left half is visi ... HP Compaq FP 7317 17" Flat Panel LCD Monitor

Sony hmd-a400 monitor


Next time you get it running, right click my computer>properties>hardware tab>device manager and look for your monitor on the 'Monitors' '+' sign and right click>delete.\015\012\015\012Also check 'Display adapter' see if the correct driver is display ... Sony HMD A400/L (Blue, Silver) 19 in.CRT Conventional Monitor

My friend gave me a new Samsung 953bw monitor and said that it did not work. It acts like no power is connected. My guess is it maybe a fuse inside. How do you get it open without damage?


I have repiared those boards , but I haven't taken this model apart yet so here are some general notes. \015\012\015\012If you get stuck, email me notes\015\012or pictures to [email protected]\0 ... Samsung 953BW LCD Monitor
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.8648 seconds