Having problems with your Dell E153FP 15" LCD Monitor ?

Dell powers on no display on monitor its a nec monitor it says no signal

Answers :

Hi try this :
\015\012Monitor Problems:
\015\012- Check the monitor if turned on.
\015\012- Check all the LED power on the monitor, if it has one.
\015\012- Adjust brightness and contrast controls all the way to the maximum.
\015\012- Check the video cable from the monitor to the computer to be sure if it is properly connected.
\015\012- Check the power cable. If it is connected properly at both ends.
\015\012- Try different monitor on your computer. If it does not work, the display card is likely at fault. Replace the display card.
\015\012- Try your monitor on a different computer. If it does not work, replace the monitor or have it repaired by a trained technician.
\015\012- It may be that the display card is defective. Try a different card. If it works the first card may be bad.
\015\012- Try the suspected bad card on another computer. If it displays the same thing it is conclusive that the card is bad.
\015\012- Try adjusting the control knobs located on either the front or back of the monitor. It maybe necessary o open the monitors casing to get the proper adjustment controls. In this case be very careful because there are high voltages in the monitor.
\015\012- The voltage may be fluctuating due to so many appliances or electric devices on he same branch circuit.
\015\012- Turn off other appliances and peripherals, such as printers, external modem, refrigerator, microwave oven, transformer, etc. and see if that solves the problem. If the problem persists, try swapping out the display cards. If changing the monitor solved the problem, repair or replace the monitor.
\015\012- If the monitor is still under warranty, bring it back to the dealer for adjustment. If the you want to do it your self, bare in mind that this is potentially dangerous procedure because it must be done while he monitor is on and there is very high voltages around the picture tube.
\015\012 - Open the monitor casing and loosen the clamp holding he coils around he picture tube. You can loosen them (usually there’s a wing nut) and a rotate the coil assembly until the picture strengthens.
Repair Help & Product Troubleshooting for Dell E153FP 15" LCD Monitor

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dell 2407WFP Monitor losing signal and having colored line artifacts

... Dell UltraSharp 2407WFP 24" LCD Monitor

No Signal I just plugged the ACER AL1912 to replace a working Dell monitor. The monitor powers up and I get the ACER logo to pop up, but moments later I get a box to pop up saying no signal then the monitor shuts down

Not all monitors can display the same resolutions. You may have has the Dell monitor set at something the Acer can not handle. Try rebooting and if you can see the Dell startup screen press F8 as soon as it disappears. This will give you the Windows ... Acer AL1912 19" LCD Monitor

Nvidia Vetro Geforce 6800GT on E510? Need help setting up max displays MD 219 dual displays

... Max Displays MD-219 (Gray) 19 in. Flat Panel LCD Monitor

Dell powers on no display on monitor its a nec monitor it says no signal

Hi try this :\015\012Monitor Problems:\015\012\015\012THE COMPUTERS SEEMS TO BE WORKING, BUT THE SCREEN IS BLANK.\015\012- Check the monitor if turned on.\015\012- ... Dell E153FP 15" LCD Monitor

Dell Inspiron Vostro 530s won't boot.

Hi,I work for Dell, If the power button led light is flashing amber or amber (the Power supply is faulty) The Yellow light you saw inside the motherboard is the "Flea Light" (that is one way you could check if there is still power on the ... PC Desktops

When I turn boot up my gt5220 the monitor briefly flashes and then goes into power saving mode- desktop stays on, fans running and all, until turned off by holding power button down or unplugging it.... my gateway 820GM started doing the same thing, monitor just going into power saving mode.... but the monitor is fine, works on a dell desktop, and the dell monitor works on my gateway- so does an older EV700 monitor....WTF??? video card? motherboard? driver update? power source? heard 15 differen

In this case if you monitor say no input or no signal it means the\015\012monitor connector cord are not connected properly to the motherboard.\015\012Or if you have a video card you need to plug your monitor connector to\015\012the video card. Becau ... Gateway GT5220 PC Desktop

Dell E228WFP Monitor failure

To me, that's an XP driver issue. If the screen turns on at all, then goes dark during XP boot, that's nearly a ringer for drivers. Out of range on the Hz? Tried booting in safe mode to see if it loads with standard win drivers? That migh ... Dell E228WFP LCD Monitor

LG 2542T goes dark after showing "analog power saving mode" message

If it is saying analog signal power saving... I am wondering do you have it hooked into you computer with the white DVI cable?Is there an option on your monitor to switch modes? Analog-Digital? If you are using the white DVI cable to hoo ... LG L1717S-BN 17" LCD Monitor

NO SIGNAL What do I do?

These messages are normal when the computer truly goes into suspend mode or loses the video signal (such as when the computer is suddenly turned off).If the monitor displays any of these messages when the computer should be displaying vid ... HP PAVILION A6230N DESKTOP PC

Old monitor not recognized by new computer, stuck in power save.

... Dell UltraSharp 1704FPT 17" Flat Panel LCD Monitor

I have a nec LCD2070nx Power light is on

Hi:\015\012Your monitor has a problem on its inverter board. It is an electronic component failure, and often it cost's more to fix it than to buy a new LCD monitor . ... NEC AccuSync LCD71VM 17" LCD Monitor

Will not restart, has been deadlocked in power safe. I pressed any key and moved the mouse. Nothing.

Sounds to me that Windows is setting your computers\015\012video controller to output a video signal whose timing is not\015\012compatible with your display. You may be able to boot Windows in safe\015\012mode and then be able to pick a compatible vi ... Dell Dimension 8300 PC Desktop

Lcd monitor power light flashing with no img. seems 2 be frozen

The display is in safe mode and you will need to reset the display to get the display out of the safe mode. There are 2 different model revisions. Please choose the method that will match your revision. Depending on the revision of the monitor, one ... Planar PL1910M (Black) 19 in. Flat Panel LCD Monitor

My monitor says there is no signal from my new Dell Studio

I had the same problem and i used the DVI cable and it worked! The VGA slot on the computer was covered and it had a x on it. Maybe they didn't want us to use it... ... Dell Studio Slim-Tower Desktop Computer

Computer monitor comes on for 1 seconds, flashes "analog power save mode" and then goes black.

Most monitors will say "Power save mode" when they can tell through residual voltage that the signal lead is plugged into a machine, but there's no picture being transmitted. The four states of a monitor are:* Off entirely.* Switch ... PC Desktops

AcerAL1714 LCD Not Connecting With DELL Inspiron 15 Vista Laptop

There is a symbol of Two monitors on F3 Or F4 button 1. Press Fn key and hold it 2. by holding Fn key press F3 key Your monitor will start displaying ... Acer AL1714 17" LCD Monitor

Gateway LCD powers on but has no picture

I have a Gateway FPD1730 LCD monitor. When I plug it into my Gateway 500x desktop the power light turns green and then says "Power Saving Mode" and then it goes black. It will occasionally flash on and have a picture and then go off. When I unplug th ... Sceptre X9G Komodo IV 19" Flat Panel LCD Monitor

PC or monitor, signal problems

Your monitor is telling you it's on it's last legs..either that or your compaq has a bad video section. either is more vital than a video cable being loose. ... PC Desktops

I turn on the desktop and the monitor only says no input signal input2: HD15 go to power save what do i do?

Hi jiheeahn! I wiull be glad to assist you. lets isolate the issue. The reason why the monitor says no signal input2: hd15 got to power save. the connection from the monitor to the desktop computer is disconnected or its not connected to the right in ... Sony SDM-HS73P 17" LCD Monitor

Acer LCD Monitor - Stuck Displaying green

Cant say for sure. The display seems to be working, and the computer signal seems to be the problem. It could be a faulty cable. Check the pins on the cable monitor and see if they are bent, etc. If the connectors are Ok, it could be the conver ... Gateway FPD2275W LCD Monitor

Dell latitude d500 had a power socket problem, but now resolved pc will not boot-up, drive spins-up, then nothing, completely dead display i think most likely scenario is mobo is fried, but open to suggestions how tio get this working again

Laptop is dead. How to troubleshoot the problem.\015\012In this post I’ll explain h ... Dell Latitude D500 Notebook

Can't find video signal

If screen says "Signal cable not connected " all the time till power led switches to Amber chances are monitor is ok and problem is with graphic card or cpu.Connect to Known working CPU and confirm that monitor is the problem.\015\012If same pr ... BenQ FP731 17" LCD Monitor

I have a red vertical line on my dell inspiron laptop.How do I remove it?,please

Try connecting an external monitor to the Dell Inspiron 9300and see if the vertical line is also present on the monitor. If themonitor display is fine, then your laptop’s LCD display panel isdefective. If the monitor also displays the ver ... Dell PC Laptops

I need to find the VGA controller for the Dell 2005FPW monitor

You can use on all vga cards(you dont need any special controler), this monitor has a USB hub\015\012and its is detected normaly on winxp or above, and the vga cards detect the monitor auto.\015\012i give you the monitor ... Dell UltraSharp 2005FPW 20.1" LCD Monitor

Blank Laptop Screen

The same thing began to occur on my (old as the hills) Dell Inspiron 2650 about 2 months ago. I have tried updating the BIOS to the newest Dell has for this laptop but it didn't help. I also tried to update the video drivers (no help), regressing t ... Toshiba Satellite 1410-S173 Notebook
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.9230 seconds