Having problems with your Dell Dimension C521 PC Desktop ?

Not booting Power supply and CPU fans only runs when I disconnect 12v supply from Motherboard, I am getting nothing from monitor


Answers :

Listern to what ur beep codes say. one short-fine, one long & two short beeps-video failure, so on ... ... ...
Repair Help & Product Troubleshooting for Dell Dimension C521 PC Desktop

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My gateway g7-500 fails to start properly. Whemn power on I get a long beep followed by 2 short ones and the monitor screen remains black.


Cause:This issue can be caused by any of the below situations.\015\012 \015\012\015\012New hardware conflicting with old hardware.\015\012Bad or failing hardware device.\015\012 ... PC Desktops

Cannot get new Motherboard to boot up in Normal Mode


What u may have done is wwhen u were installing the new board, gave a static shock to the system...that will cause only the fans to come on and nothing more...this is a bad problem bc u cannot fix it...if u figure out something else is wrong, and it ... Gateway PC Desktops

Dell e510 won't make it to post


Unplug computer, disconnect all usb/monitor/internet, open it, hold power button until green led on the inside on the motherboard turns off, pop out the BIOS battery (looks like a big watch battery and use a small flathead screwdriver to depress the ... Dell Dimension E510 Dual Core 2.8 Ghz (847403171179) PC Desktop

No power, front panel light is always on


Run with the 4-pin ATX power cable unplugged? No, the power supply is just supplying power to the hardware components, that do not require much power. (Wattage) [Or the power supply doesn't have enough power now, due to a bad power rail, or mor ... PC Desktops

Dont get vidio at all see drives light up and can


Being able to open a cd or dvd drive only requires power to be going to that unit. The following assumes your monitor is working but is just not displaying anything.What you are describing sounds like you are having a hardware or BIOS iss ... HP Compaq Presario SR2013WM (RE468AA#ABA) PC Desktop

Can't set up network w linksys modem


Video card:Your computer has an integrated video card but has a "PCI Express" expansion slot for an upgrade. After the upgrade you will be able to play most games without the choppy frame rate...depending on what card you buy. Since ... PC Desktops

Dell Dimension 5100, Doesn't Boot Up, Display Lights Up "!, 2 3"


2 green lights usually indicate a memory problem, however, when you get 3 lights, RAM is good, but the BIOS is unable to hand off to the operating system.To test this, disconnect your hard drive (both ribbon and power) and connect the mon ... Dell Dimension 5100 (D51L1) PC Desktop

Monitor reads: PC entering power saving mode then shuts off;PC on


First do not take the hard drive out and put it in another computer. It is configured to run in the computer it's in.\015\012\015\012Next, you probably did have a power surge either from your power supply or the power in your home. It s ... HP Pavilion a810n (PP164AA) PC Desktop

Trubleshoot Motherboard what is mother board prob and how can find n fix them....


More than 70% of all computer problems are related to cabling and connections. Ensure all cables are connected and connected firmly. IDE and floppy ribbon cables and power cables can often go loose. Ensure microprocessor, memory modules, and adapters ... PC Desktops

Fitted a lexmark all-in-one printer to packard bell pc, worked ok (ish) then froze (the pc) -when switching on quite noisy (red light stays on on front) monitor when switched on has green light then automatically switches to amber after a few seconds - tried switching on and tapping both either f5 or f8 but cannot get safe mode - any advice please? thank you


I would hazard a guess at a possible power supply fan about to fail or cpu fan issue maybe causing an overheat problem.\015\012\015\012I have included information for both below\015\012\015\012disconnect the computer and take ... PC Desktops

My ibm thinkpad T40 powers on but does not post. No hard drive activity blank screen. But it was working fine 1 hour ago. Before this happen I was working in windows and the computer hung up. Then I rebooted and now get nothing but power lights. What could be the problem?


Hi.Try first disconnecting the power adapter, removing battery, waiting two minutes, and putting the laptop back together.That will drain power from main board (apart coin battery powering BIOS and some other circuit). This can fix ... IBM ThinkPad T40 2373 Notebook

Not turning on, has power and everything


Do any of the fans spin at all, as though it's attempting to boot up? If not, then double check your power supply to see if it has a switch on it and if it does then make sure it's switched into the ON position. If so, then I would recheck the power ... eMachines T3604 PC Desktop

Acer AM5641-U5520A will not


If you removed the memory modules and there is no change then I would start disconnecting one device at a time to see if that is causing the problem. Start by disconnecting the cd/dvd rom and then try booting the computer. Then try disconnecting any ... Acer AM5641-B5560A Desktop PC & Monitor BUNDLE

Laptop IBM ThinkPad. Black screen. Short beeps: 1+3+3+1


Hello,You can try the following steps: 1. Unplug the power from the laptop and remove the battery then press the power button of the laptop for 15 seconds2. Put the battery back in, turn on the laptop without plugg ... IBM ThinkPad T23 2647 Notebook

Turns on, no bios no screen, just beep.


Now the question is, when the computer first starts up and you hear the beep, that is where it will tell you what your problem is depending on the beep you get.One Long and one Short Beep = Motherboard issueOne Long and Two Short Be ... Gateway GT5028 PC Desktop

Wont boot up


We need to open the case and inspect the cables and cards and memory to make sure nothing has gotten dislodged. heres how to get into the case.\015\012Before Opening the PC\015\0121 Remove any diskette or optical disc (CD or DVD) ... Compaq Presario SR1810NX Sempron 3200+ 1.8 GHz Desktop PC ( Monitor Sold Separatley) (ER912AA)

I have a Boot Problem with my INTEL P4 3.0Ghz. 800Mhz FSB,1M L2 Cache, Socket 478 CPU


I have experienced something similar with my new Core2Duo processor and a fairly new Socket 775 processor. Troubleshooting it led me to believe the CPU simply wasn't compatible with the motherboard. \015\012\015\012Although it's a shot in the dark, I ... Intel P4 Prescott CPU 2.8A Ghz W/1MB CACHE 533FSB (CPUP428A1M)

ASAP! Power Problems. Please Help!


There could be several things causing this issue. The power surge could have damaged the main board, power supply, graphics card or on board graphics, cd-rom drive ect. The problem is that one of these things could be bad and you need to figure out w ... HP Compaq Presario SR1420nx (SR1420NXPS69AA) PC Desktop

Power outage,monitor wont power up,hope its not fried


I may or may not make your day. (But I wish you to know that I want to! lol!)I believe it's not your monitor, I believe it's your computer. (Oh, that helped, huh!) However, don't freak out yet, it maybe a simple fix.Let's test ... Gateway FPD2275W LCD Monitor

My computer comes on but my screen is blank - Gateway PC Desktops


Hi tytiyana..i am giving my sugggestions.Remedies. The remedies below should be performed \015\012\015\012 in order. NOTE:Turn off the computer after each step. Never work inside the \015\012\015\012 compute ... Gateway PC Desktops

Blinking on and off


No offense, Tyson, but would you mind explaining your question a bit better? You wrote "when i out the power cable in it"and that really confuses me. Did you unplug the power cable or did you plug it in?Also, how long ago did this happe ... E-Machines eMachines Desktop PC

Computer Does not Boot correctly, Monitor is Black.


Hmm it seems to be problem with Power Supply, but still if you can give a try connecting your system into other socket may be which is properly grounded one.\015\012\015\012if the above didn't fix your issue, i would suggest you to disassemble ... PC Desktops

Dell Dimension 5100 will not power up. Was working fine, turned power off, will not turn back on. Power supply tested OK, tried different power switch and ribbon cable connector, replaced mother board battery. Nothing worked. LED on motherboard indicates power.


Have you checked your monitor? Try your monitor on another PC and check it is OK. Once you change the MB battery you effectively "Kill" the PC, as all the settings in the BIOS are removed and must be reprogrammed. You must enter the BIOS, and select ... Dell Dimension 5100 (D51L1) PC Desktop

We recently had to disassemble our entire system. Now after moving the system, the tower lights but does nothing but blinks. We've tried detaching the power cord to reset it but that didn't help.


Perhaps the Ram Memory module/s, (Stick/s) are not fully seated in the ram memory slot/s. (Don't know if you have one, or more ram memory modules)Even if they appear to be seated by a visual inspection, the best method is to r ... Compaq Presario SR1103WM-B (PC183B#ABA) PC Desktop

Trying to find out what needs to be replaced on my dead computer (I think it may have been lightning / power failures that caused the desktop to die). I have power, but no beeping and no start-up. Fans power up, but nothing on the screen. Not sure if it is a power supply problem or a Motherboard problem. How can I find out what easily (ie I don't have any meter devices to check power) what the problem is? Motherboard is an IBM, 2.8 Ghz, with 2 Gig Ram, and 40gb Hard Drive. Moth


Not going to get far without a meter on this one.o.k.hopefully you have a little tech knowledge,first thing is to eliminate anything unnecessary,pull all pci cards including graphics and sound as long as you have onboard vga for monitor ,run one hard ... PC Desktops
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 1.1850 seconds