Having problems with your Dell Dimension 4600 PC Desktop ?

I have a dimenison 4600 that just beep and won't boot

\015 My son tore the computer apart and when i put it back together i can not get it to boot up. the computer beeps once then beeps three times and then beeps twice. nothing shows up on the screen. he took the read write cd out of the system and replaced it with a cd player\015

Answers :

Possibly a memory issue. Double check your memory is clipped in properly. If you have two sticks you should be able to run on just one to test and see if one is damaged.
Repair Help & Product Troubleshooting for Dell Dimension 4600 PC Desktop

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Wont boot up to bios


I have had TWO recent model NEC laptops with the same symptom in the past 5 months. I was quite surprised, since NEC is a quality product. But the problem was the DVD/CD-Rom, which is made by Philips (mine were Philips SCB5265 models, but there are o ... NEC Versa SX Notebook

Toshiba laptop l305d won't reboot to factory default


I never heard of holding the 0 key, but have you tried hitting F10 or F12? Normally when you first boot the computer you will see down in the bottom of the screen or on the top corner to press a certain key for system recovery and a certain key for ... PC Laptops

Is the 2400 Toast ???


Sounds like HDD and Cd-Rom are jumpered wrong (If on a PATA interface cable), make sure HDD is set to master, and cd-rom set to slave, alot of the early socket 775 board (mainly abit boards) initialised a few of its devices, shut down, and then start ... Dell Dimension 2400 PC Desktop

My matser hd oin is aet to master. My slave is set


The first thing you need to do is edit the boot.ini filehttp://support.microsoft.com/kb/289022This will explain how to do that.This part is only a ... Symantec Norton Partition Magic-8.0 (10256717) for PC

DELL INSPIRON 1501 won't BOOT...and LEDs flashing


Hi..This is an Hardware Failures: Doesn't Boot Up.First of all, most of the\015\012hardware failures that are going to be presented in this article\015\012require you to disassemble the l ... Dell InspironTM 1501 Notebook

Beeps 2 times & a warbling noise when trying to boot up - unplugging power lead & pressing ON/Off button & reconnecting power lead starts up OK - but it can be OK for several days & th


I think you have to check the connection cable from your HD ... HP Vectra VL420 Intel Desktop PC - Intel Pentium 4 1.6GHz, 256MB SDRAM, 20GB IDE HDD, CD-ROM, Integ

UNMOUNTABLE______BOOT_____VOLUME ***Stop: 0 X


It could be a problem with the harddrive and memories ,if you enter the DELL bios setup page when the computer starts up does it have an option to test the hard drive if so test it.Also if you have two memory sticks then try with only one and v ... Compaq Presario 2195US Notebook

My comp wont boot up


Several possibilities here, no quick solution.1. Could be the graphics card is dead or monitor unplugged. If its a PC and the box has been moved recently, the graphics card could have been dislodged in the slot. In any case check for signs tha ... PC Desktops

Pc starts and runs but wont boot up monitor shows no signal


1) When you turn on the computer, watch and listen for: a) power supply fan, (power is on) b) chassis lights (power is on) c) ticking sound during memory test (the BIOS POST is running) d ... HP PC Desktops

Getting power but wont boot up or anything


Pull out everything in the computer except what's required to boot...so any pci cards or video cards (if you have onboard video). you can also try pulling out the ram (while unpowered AND unplugged) and then booting to hear beeps...if you pull the ra ... E-Machines T2792 PC Desktop

I get a 1-3-3-1 error code beep on Toshiba Satellite M35x-S109


Well it sounds to me like it is your actual install, I suggest you that you do a factory restore, \015\012Toshiba laptops from mid 2007 onwards dont have a recovery disc supplied with a purchase of a laptop. Instead, Toshiba has added a ... Toshiba Satellite M35X-S109 Notebook

Dimension c521 computer gives a post error, floppy drive 0 error and keyboard error


Hi, The compute post tests the computer, insuring that it meets the necessary system requirements and that all hardware working properly before starting the remainder of the boot process. 1 Short Beep, Normal POST, computer ... PC Desktops

Stuck on BIOS Screen?


I would try to power off the machine completely and hold a key down on the keyboard and power on the computer while still holding down one key. Keep holding it (it might make an irritating beep sound, that is expected) . This is one trick that will a ... E-Machines eMachines Desktop PC

Beeps, wont boot up


Most of the time when it beeps, and there is nothing show on the computer screen, it is a RAM problem. A stick of ram may have gone bad. If you have two sticks of ram in the computer, you can try to remove one stick at a time to see which one might ... Dell Dimension 4700 PC Desktop

Won't boot yea my 3000 won't boot i'm fixing it for a friend i start it up it wont boo it says primary drive 0 not found below that its says Alert! os install mode enabled.Amount of available memory limited to 256 mb strike the f1 key to continue, f2 to run the setup utility at first i thought it was hard drive problem so i replaced it and i still get the same error please help i despertly need it


First go to the BIOS load optimal default or load setup default and restart the pc.If it wont work so go to BIOS AGAIN and make primary master HDD 0!\015\012\015\012If still wont work so just repair with original winxp cd\015\012\015\01 ... Dell Dimension 3000 PC Desktop

PC wont start/boot


Unplug all drive cables, backwards P-IDE can cause this issue. \015\012\015\012If this doesn't help remove the video card if possible \015\012If the motherboard is alive you should get a video beep.\015\012\015\012If you don't hear anyth ... eMachines D3415 PC Desktop

Monitor light blinks but no pic when booted up


I can try to help you,\015\012do you hear the boot beep sound?\015\012if you are not able to hear the beep sound then i suggest you to open the machine and check with the cmos battery if it is working or no.\015\012if your cmos battery is working the ... E-Machines eMachines Desktop PC

Problem with on my boot


If its 2 or 3 beeps its something in the MOther BOard thats failing... dependes on how many beeps.. but if it is a lots of beepings, its the keyboard that some key is stucked.. but usually.. the beeping that tells you that something on the MOBO ... Acer Aspire 1710 Notebook

Screen my laptop screen wont switch on it beeps three times continuousty,could please give me any help to fix this.I have a IBM thinkpad T22


According to the support website, it could either a memory (DIMM) or motherboard (System board) problem. See beep codes and what them mean here: http ... IBM ThinkPad T20 2647 Notebook

Hp 9695c wont boot only ht HP banner shows but wont go to the initialization


Press and hold down Shift key, when you hear the beep, until system boots.\015\012If you dont time it right you will get a keyboard error, dont worry, just press F1 key and immediately hold your Shift key again. \015\012Your system should ... HP Pavilion dv9000z Notebook

PC wont boot


1-3-3-1 Autosize DRAM\015\012 \015\012It is a memory problem.\015\012Have you added new memory? \015\012How many sticks of memory does your laptop have?\015\012If it has 2, take one out and ... Fujitsu Siemens PC Laptops

Pc boots but no display. tried a new video card, still wont work. ram or motherboard?


If you hear a "beep" sound when your PC boots, it means your video device is initialized successfully. And if there is no beep, then no video device is initialized or installed. If it beeps and no display, make sure that the VGA cable is connected to ... PC Desktops

Beeps 2 times & a warbling noise when trying to boot up - unplugging power lead & pressing ON/Off button & reconnecting power lead starts up OK - but it can be OK for several days & then repeats the p


The Cause of Problem:The Power Buttons\015\012electrical circle sometimes just braked it by one of sensors and the\015\012result is the 2 beeps and Power Supply is in protected mode error.The\015\012whole computer is tur ... HP Vectra VL420 Intel Desktop PC - Intel Pentium 4 1.6GHz, 256MB SDRAM, 20GB IDE HDD, CD-ROM, Integ

EMachine T3406 wont boot


Is there a post beep when the pc is switched on. check the memory if it is a beep beep beep sound , also disconect the hard drive, dvd drive, floppy, and any usb devices and see if it boots up. if that fails it does seem like the mother board, also c ... E-Machines eMachines Desktop PC

My acer travelmate wont boot just beeps 4 times i recently reinstalled XP Pro os on acer ferrari 4000 and have recieved this same problem 4 beeps and black screen.won't boot..bios or os. HELP


I long + 3 short beeps or 3 short + 1 long beeps indicates memory problem.\015\012The RAM module/s may need reseating to re-establish proper electrical contact.\015\012If it still doesn't boot up then :-\015\012Get the RAM module/s ... Acer Ferrari 4000 Laptop Notebook
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.6821 seconds