Having problems with your Compaq MV 540 15" CRT Monitor ?

CRT Monitor Stuck In Stand-By

\015 I have a Compaq MV540 monitor that gets a signal from my computer but stays in stand-by mode when connected to either the motherboard or video card. It will work fine on other computers however.\015

Answers :

So the monitor is not bad try to disable the video card from bios if possible and firstly remove all external devices (USB's) and gets the safemode meny and select vga mode and disablem the video drivers and uninstall and reinstall the drivers
Repair Help & Product Troubleshooting for Compaq MV 540 15" CRT Monitor

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

CRT Monitor Stuck In Stand-By

So the monitor is not bad try to disable the video card from bios if possible and firstly remove all external devices (USB's) and gets the safemode meny and select vga mode and disablem the video drivers and uninstall and reinstall the drivers ... Compaq MV 540 15" CRT Monitor

The brightness/contrast adjustment screen pops up randomly and often. It then scrolls through the 3 options and the only way to remove it is to turn off the monitor. How do I make it stop?

Sounds like your buttons are stuck. Try loosening them up by pressing them, then popping them out again with some sort of pin or needle.If all your buttons seem fine and pop in and out normally, then its probably a problem with the connec ... Dell Computer Monitors

1907 Monitor Stand

For the hp x1907 we purchased recently there is no release it is just really hard to straighten, it has to be tight because you wouldn't want a wobbly stand ... HP Compaq WF1907 Monitor

The Red Colour Loss On My Samsung SyncMaster 753 DFX

My Dear Friends,I Understood the problem.I will explain it a little briefly.There is an Integrated Chip (IC) inside the monitor which gave RED, GREEN and BLUE ( Primary Colours) to the CATHODE RAY TUBE (CRT) otherw ... Samsung SyncMaster 753 DFX 17" CRT Monitor

My on-screen menu pops up and stays on. This occurs even when the monitor is cold. It started after I made it the second monitor on a Dell 8400 system.

Hi loarn, Try this things..,\015\012\015\012Check the button on the crt for the on screen menu,.. \015\012check if it is still in good condition make sure it's not stuck,\015\012\015\012then if the button is in good cond ... HP Compaq FS7600 17" CRT Monitor

Relisys 17in tft monitor

Hi everyone, i have a relisys monitor and had this exact same problem where the menu screen comes on and then cycles through the various options until it gets stuck in a loop within the colours settings. - the solution i found ... Relisys TL 766 Monitor

VX922 19" Monitor -Terrible customer service by ViewSonic

The only advice that I have on this issue would be to call ViewSonic again and as soon as you get a Rep on the phone you need to ask for a supervisor. In the event that the supervisor is not helping you ask to speak to his supervisor. Make a point to ... ViewSonic VX922 19" Monitor Flat Panel

Sir Help me with my Compaq monitor MV520 it won't turn the power led flashing orange to green continously

It could be th epower supply and it could be the monitor.\015\012power ON button should not flash orange regardless what you do. it should stay green. then orange. not orange to green to orange.\015\012try the monitor on another PC if yo ... Compaq MV 540 15" CRT Monitor

Input select screen is poping out by itself and anoying me.

One of two things:1) The input button is stuck and is staying pressed down, making the input select screen pop-up, in which case I would suggest wiggling it and making it un-stuck (Thats the technical term by the way :) ).OR ... BenQ FP931 19" LCD Monitor

Lcd screen stuck in external screen mode

How to use the function (Fn) keys on the keyboard - ThinkPad T40, T40p, T41, T41p, T42, T42p, T43, T43p \015\012 \015\012Switching the display output location.Switch between the computer display and ... IBM ThinkPad T41 Notebook

Remove base how to remove Acer X191WSD 19? monitor from the base

Okay for anyone who still needs info on this, I just got off the phone with ACER. It's VERY easy as it turns out. The "cowling" or plastic cover over the hinge where the stand enters the back of the monitor just LOOKS like it's part of the back of ... Acer AL1916W 19" LCD Monitor

My friend gave me a new Samsung 953bw monitor and said that it did not work. It acts like no power is connected. My guess is it maybe a fuse inside. How do you get it open without damage?

I have repiared those boards , but I haven't taken this model apart yet so here are some general notes. \015\012\015\012If you get stuck, email me notes\015\012or pictures to [email protected]\0 ... Samsung 953BW LCD Monitor


Havent you got a person or a friend that has a puter to test the monitor??? This would be the best way as it could be the crt on the monitor or the crt driver board but before we go there we should make sure where the problem lies. Good Luck ... NEC AccuSync 900 19" CRT Monitor

Moniter stays blank

I used to repair LCD flat screen from Dell. I am not sure that my method might be applicable to your CRT monitor. Anyway this is how to examine what wrong with the monitor. You have to\015\012check if you can see the image on the screen or not after ... Relisys RLT1720 17" LCD Monitor

Monitor tilts down

It's not a great solution, but I just stuck a really small cardboard box between the stand and the monitor. I think there's some sort of spring inside that breaks/comes loose. I took off the monitor (for another repair, this time the power supply, bl ... Samsung SyncMaster 910T 19" LCD Monitor

Cannot run a monitor on Aser Aspire SA80

Try pressing the F8 key when the computer starts to boot up. When you get to the safe mode screen, select Enable VGA mode. Evidently your friend's monitor can support resolutions and/or refresh rates that yours does not. Oh and one more thing, ple ... PC Desktops

Toshiba desk-top screen is quite dim. why?

1. adjust the monitors brightness and contrast\015\0122. adjusting the brightness and contrast with your video card software\015\012\015\012if that fails\015\012\015\0121. decide if the monitor is worth the money to repa ... Computer Monitors

Osd lockout flashing in the middle of my screen

This has most likely annoyed many of you at some point. You turn on\015\012your monitor one day and see a jeering message telling you something\015\012about an “OSD Lockout”. It doesn’t allow you to change any of your\015\012monitor ... HP w1907 LCD Monitor

Syncmaster paower button blinking and no display

First of all plug another monitor to the VC on your PC and do the same for the SamSung"I over heat"SyncMaster2 053BW. \015\012 \015\012\015\0 ... Samsung SyncMaster 204B 20.1" LCD Monitor

The monitor would not turn on. Only the orange LED does.

1. Make sure the monitor cable is fully plugged into the computer.\015\0122. If the new monitor works fine, The connection between the previous monitor and the PC was bad. Reconnect the original monitor to the PC and make sure that the connection is ... Hitachi CM772 19 in.CRT Conventional Monitor

LCD Monitor picture cutting out occasionally.

Your CCFLs might be going bad. CCFL stands for \015\012Cold cathode fluorescent lamps. These are the lamps that provide backlight for the LCD Monitor.\015\012These lamps do not last forever, and are a very common part to go bad.\015\012The circuit ... NEC LCD1712 17" Flat Panel LCD Monitor

How to fix a dell monitor dimension 2400 power button broken

The last guest left us hanging with, "easy fix" so, I ventured ahead to see what I could see by opening up my lcd, which was a puzzle in itself. After UNPLUGGING the monitor and removing the stand and the 4 obvious screws in the back, turn the monit ... Dell Dimension 2400 PC Desktop

Compaq FS7600 Monitor adjust menu stuck onscreen and all adjustments turn to highest settings

Sounds like a button is stuck. And other people are having the same problem.One thing you could try is turn the monitor off, press all the buttons at once and turn it back on while holding the buttons in. This might error out the ... HP Computer Monitors

Viewsonic PT775 CRT won't accept VGA input

Sounds like it's time for a new monitor to me. The fact that it has been acting up and works on and off is a sure sign that it was going downhill. ... ViewSonic PT775 Monitor

No sound through external speakers

Although some monitors have built in speakers, most people have stand alone speakers. If the old monitor had built in speakers and now it is unplugged you won't hear sound. Even if the speaker cable is still plugged into the sound output on the bac ... Acer PC Desktops
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.5687 seconds