Having problems with your Compaq Deskpro EN PC Desktop ?

Micronpc Clientpro Three beeps on start. moniter does not come on has good video board

\015 Micronpc Clientpro Three beeps on start moniter does not come on has good video board\015

Answers :

Remove the Ram and clean the memmory slot and refix the Ram. If still the problem exist reolace the memmory by a new one.
Check to be sure RAM is seated correboot up.ctly. If it is replace with known good RAM and re-try
Repair Help & Product Troubleshooting for Compaq Deskpro EN PC Desktop

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Micronpc Clientpro Three beeps on start. moniter does not come on has good video board


Remove the Ram and clean the memmory slot and refix the Ram. If still the problem exist reolace the memmory by a new one. ... Compaq Deskpro EN PC Desktop

Computer Does not Boot correctly, Monitor is Black.


Very interesting...Might try the following...\015\012- Video. Yes, almost garuntee that it is either the video card/onboard or the cable. Look at the cable and cable connectors and see if one of the pins has been shoved in. This is common. O ... PC Desktops

HP Pavilion DV6000 screen wont turn on and gives three beep error


HOW TO FIX YOUR DV6000/DV9000/DV2000All the Problems described in the previous posts are Graphics Related..Faulty Nvidia Chip..Both Intel And AMD Based Motherboards..Though More Common on the AMD..The symptoms of the Lap ... HP PC Laptops

Black screen flashes after initial power up


This happened to me, and I fixed it, so read on! Switch on... green LED for a couple of seconds, Brief flash of light with display working, the total shutdown. Switch off, repeat but press the front panel power button as soon as the green LED comes ... Sony SDM-HS73P 17" LCD Monitor

Pc starts and runs but wont boot up monitor shows no signal


1) When you turn on the computer, watch and listen for: a) power supply fan, (power is on) b) chassis lights (power is on) c) ticking sound during memory test (the BIOS POST is running) d ... HP PC Desktops

Gateway GT5240E desktop won't power up


More like the video card. I now have the same problem after 5 years. I noticed that when I played games the computer would freeze up. Then it got to the point where it would not start. I replaced the power supply thinking it was the problem but agian ... Gateway FX4710-UB003A Core 2 Quad Q9300 6GB DDR2 640GB NVIDIA GeForce 9800 GT Windows Vista... PC Desktop

No display ok my pc stop working all together it wouldnt even come on so i got a new power supply now it on but i got no display nothing on siganl what do i do


So turning on the computer doesn't bring the monitor out of standby? Just to be sure, try turning the monitor off, then on again and the Pc on at the same time. If you see any writing on the screen, that will be good news.\015\012\015\012Make sure ... E-Machines C1641 PC Desktop

Poweredge1300 no post


Good news, you can save the machine, although it may take a while. There are a few ways to do this. If you are lucky enough that the boot sector of your BIOS didn't get corrupt and your computer still posts and you can put in a floppy. Then all you ... Dell PowerEdge 1300 Server

Video card problem?


I may get a little detailed with my solution, as I want you to have all the information I feel is relevant. The fix may be something you wish to attempt, or at the very least, you'll have the knowledge of what is going on.I believe it is a prob ... HP Pavilion ze2000 Notebook

On boot up ,during 'post' the laptop (acer 5100) beeps twice(2 short beeps) and advises that there is a resource conflict. It then advises to press f1 to continus loading windows and promptly hangs! Any ideas please?


Check this list\015\012\015\012These audio codes are a little more detailed then the AMI codes. This BIOS emits three sets of beeps. For example, 1 -pause- 3 -pause 3 -pause. This is a 1-3-3 combo and each set of beeps is separated by a b ... PC Desktops

Samsung Synchmaster 940N fault


I've had the same problem with mine and just fixed it (well, it's still working now, so fingers crossed).The problem is the high-voltage supply to the backlight is breaking down due to a discharge path somewhere.I took my moni ... Samsung SyncMaster 940N Flat panel Monitor

My hp pavilion a6403w pc monitor does not start up when i turn my computer on. Do you know anything about a possible download thta might of caused this?


Ok,whew! I finally figured out what was wrong with my MCP73M02H1 motherboard.First, the problem. I have a HP A6403w pavilion desktop with the above mentioned motherboard. When booting the computer, it would start up, flash the lights on the keybo ... HP w19 19" LCD Monitor

Bios problem Power On Self Test (POST) Beep Codes and Bios Error Messages


Standard Original IBM POST Error Codes1 short beep\011Normal POST - system is ok2 short beeps\011POST Error - error code shown on screenNo beep\011Power supply or system board problemContinuous beep\011Power supply, system board, or ... PC Desktops

Blank monitor screen


It appears that this motherboard has an on-board video port, I would recommend unplugging the video card and try using the on-board video. Make sure that when you do this, the BIOS POST screen shows, if it stops making the beeps, but still doesn't s ... ASUS Computer Monitors

No display-- i would start my hp dv2 and only the blue led is on but there is no display whatsoever in the monitor/screen


Your computer has memory problems. 1st check video. If video is working, you'll see an error message. If not, you have a parity error in your memory. Check your memory. Reseat them and try rebooting your computer. If this doesn't do it, the memory c ... HP Pavilion Notebook

I have the same problem!


Hi Robert,\015\012\015\012The monitor is on protect mode because an internal fault had been detected.\015\012\015\012To start unplug monitor from power and from computer and test computer with different monitor to find out if it is ... Microtek C893 18.1" Flat Panel LCD Monitor

Monitor turns on then goes dark


Either the power supply board is failing and needs repair or a bad bulb in the screen is causing it.You would have to open it up to get a better idea.Here's some info:\015\012\015\012MAKE\015\012SURE ALL POWER is DISCONNECTED ... ViewSonic VX715 17" LCD Monitor

Power up replaced power supply, still won't power up. possible motherboard?


Does this mean no power at all, or just that the computer won'tpost.Do any of the fans spin ?Do the hard drives spin up and make noises?Do any lights come on?Is the cord OK?Is the rear power switch in the ON ... E-Machines eMachines Desktop PC

The power light blinks solid blue every four seconds or so (it?s off in-between). The screen is blank. None of the buttons on the side function (such as ?menu?). I have a second similar monitor from the computer in the other room I?m using to type this proving the video card and cable are fine. We?ve always (as in years) left the monitor on (w/ a screen saver) but for whatever reason turned it off for four days when we went away recently. The monitor would then not turn back on. After leaving th


Hello,\015\012Two days ago I received a Gateway 900w FDP1975W Monitor from a friend. He told me that he would have to let it rest and it would work for about a hour or so and flash green with lines, then Flashing blue power light, then nothing. ... Gateway FPD1975W 19" LCD Monitor

COMPUTER Sir nice to see ur specialty on the expert's lounge! What is the best combination when assembling your own PC with regards to all its components giving the user the best option.


I start out on the Asus site. I ask the customer what they need the computer to do. Then I look up the chipsets on the motherboards to see what they are capable of. If you want good graphics for photo programs, or gaming, you would want a good gra ... Intel (RK80532PG0881M) Pentium 4, 3 GHz Processor

Won't turn on - power led comes yellow & blinking


Please perform the steps mention:\015\012\015\012Disconnect the Power cable / A/c adapter/Battery from computer. \015\012Disconnect External peripherials. \015\012Hold down the power button on the computer for 10 seconds. ... Dell OptiPlex SX270 PC Desktop

Dell Inspiron 530 mobo dead, beeps 2x, no video fans ok


The two beep code means no memory was detected. This might mean bad memory, memory that's loose in its socket, or a system board problem.Make sure all the memory is firmly seated and latched into the sockets.If you have only o ... Dell Inspiron 530 Desktop Computer

Not getting on


 Ensure that all cables are correctly connected and pushed in firmly. On some systems the mouse and keyboard connectors are very similar and next to each other. Ensure that the mouse cable is plugged into the mouse socket and the keyboard cable ... HP Compaq Presario V2000 Notebook

Screen shrinks monentarily then zooms in untill screen is blank, then turns off.


OK PEOPLE I GOT THE SOLUTION TO THE MAG INNOVISION LT916S GOING BLACK AFTER ANY LENGTH OF TIME BEING ON!!! I JUST REPAIRED MINE TODAY! THE PROBLEM IS THE CAPACITOR BANK IN THE POWER SUPPLY PART THERE ARE 6 CAPACITORS I HAD A FEW LEAKY ONES "NOT GOOD" ... LG Flatron 915FT 19" CRT Monitor

I'm having problems starting my desktop computer. After I push the power button, I hear the computer working but it doesn't fully com on. There's no display on the monitor and I continue to hear the computer working and working.


When you say you hear the computer working and working do you mean that the fans are going and the lights are on? \015\012 \015\012i ask this because the fans and power lights can come on just from the powe ... PC Desktops
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.7851 seconds