Having problems with your Balance CM2017 17" Monitor ?

Power supply dead

\015 The power supply on my balance monitor died, no output. It is rated at input 110-240 VAC 47-63Hz 1.5A Max OUTPUT 19 VDC/ 3.2 A 61W MAX\015

Answers :

Search San Diego Craigslist for my posting today... (will ship if you don't mind the cost)\015\012
\015\012posted for sale in San Diego - Computers & Tech\015\012
\015\012or you can email [email protected]
Dear,
\015\012
\015\012i think u saw the information pasted on the back side of monitor...
\015\012dead means that something is wrong inside...
\015\012initially, you have to check the power cable and availability of mains in the socket..
\015\012if all are fine then we will go inside..
\015\012
\015\012after removing the cover carefully, check the mains fuse that is near the power cable socket where the power plug inserts...
\015\012if fuse is fine then check the mains capacitor and then further....
\015\012Maybe the problem pin points here and u solve the issue..
\015\012
\015\012goodluck...
\015\012
\015\012hopefully, it will fix the issue so rate it ...
Repair Help & Product Troubleshooting for Balance CM2017 17" Monitor

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Front panel Ac Switch failing to start computer.


Try these steps.\015\012If Power supply light does not turn on (or no power supply LED)\015\012Perform the following steps, in order, until power is restored or it is determined that there is a hardware failure:\015\012NOT ... Compaq Presario SR1000T (568657) PC Desktop

After press push buttom , power not on , fan not on ... as dead


It might be the power supply that is dead or motherboard or together. 1. Try to disconnect all the connection at the back of your computer\015\012tower then press the power button of your computer for 15 seconds to\015\012drain the remain ... Dell Dimension 1100 PC Desktop

Dead Toshiba A100 laptop computer


In order to replace the power jack in your laptop you’ll have to remove the jack from the motherboard as I explained in the previous post:  ... PC Desktops

No power power switch does not respond. checked all power to computer. All connections good and active. Unit is comopletely dead. Monitor goes on, plugged in separately. I hear power swith clicking,but no power to computer. I have nioticed that when i pressed the power switch over the past it appeared to get stuck. I also noticed that the last timeI tried to power on the computer,the switch light cameon for asplit secon, and then nomore power to cpu completely dead. The day before, everything wo


Most times when this occurrs, there is a problem with the power supply inside the unit. It is possible that the motherboard is not telling the power supply to turn on. Any time the computer is plugged in, the power supply provides 5V as a standby v ... HP Pavilion A520n (DW233A#ABA) PC Desktop

Philips CRT Monitor 107 E66 SMPS dead Pls any one


Hello, welcome to Fixya!Your monitor is having a power fault \012because it is not switching on. The monitor might have worked fine in \012the past, but that's electronics for you. Power surge, irregular power \012supply, excess power supply, ... Computer Monitors

I have a cisnet computer as of yesterday it would not turn on. i have unplug it for a whole day and turned it on, but did not get any results. thank you!


It is possible that your power supply is not working anymore - that happens sometimes. This is how I would test it:\015\012\015\012Unplug the power cable\015\012 Open the computer housing (look i ... PC Desktops

Try to turn on computer and the fan blows, but light jiggles and nothing happens. Hard drive shot or processor or ...???


Sounds like the power supply or the motherboard. If you have another computer available, you can test the power supply. Just "borrow" the power supply from the other computer. If it still won't come on, then the motherboard might be bad and you'll ne ... E-Machines etower 600is PC Desktop

When i try to trun on my computer the fan doesnt stop so nothing goes to the screen


Sounds like the power supply or the motherboard. If you have another computer available, you can test the power supply. Just "borrow" the power supply from the other computer. If it still won't come on, then the motherboard might be bad and you'll ne ... E-Machines eMachines Desktop PC

Emachine w2646 won't power up


The damage would not be visible. 9 times out of 10, a dead power supply does no damage to the motherboard. You might try posting a request on freecycle.org for a working power supply from a used (dead) computer. That way you could find ou ... E-Machines eMachines W2686 PC Desktop

I have a HP Compaq Dc7600 sff. The computer made a popping noise and went dead. I waited a few minutes to see if it would restart. It did not restart. No power at all.


At this point I would take the diagnoses further. This of course depends on you, and if you feel comfortable with the procedure.However I would like to back up for a moment, and would like you to check that the computer is indeed getting ... HP Compaq dc7600 Small Form Factor PC Desktop

Toshiba a105, wont power up, clicking sound


I seem to have the same problem. I have an a105-4134. Ive had since June of 2006 and ive kept it clean and have replaced several components throughout its life.I was working on it few days ago until it just shut off. Confused, I press the ... Toshiba Satellite A105 Notebook

Compaq Presario M2000 DEAD


My power plug that goes in the computer gets hot enough to melt the plastic ring on the end of the plug. so i am going to get a new power board and try that. ... Compaq Presario M2000 Notebook

Will not boot. Turns off after 5 seconds


I would check your memory sticks i had the same problem and it was my ram.they get full and ware out ... HP Compaq nx9420 Notebook

I am working on an HP Pavillion a1220n Desktop and I am getting different bootups each time. First we had a visual (video), but when we enter bios, the computer would not freze up, but simply just reboot itsself, and it would reboot everytime by itsself, no matter where you were at from 15-20 seconds after booting up. So I removed the CPU/FAN and Heatsync and they were covered with dust, I cleaned the dust off, and plug it back in, and now when I turn it on, the fans are running in the back, b


You didn't break the computer, They did.(EDIT: This is a long solution. I detailed it out, because I thought you would want this knowledge. I apologize for the length of it, however)Computers MUST have the inside cleaned out o ... PC Desktops

P4 PC with Antec power supply won't start when cold


I haven't heard of a sensor that keeps it from starting when too cold. Usually in electronics, if it is a cold problem, there is a cold solder joint somewhere. When you apply heat, the joint solder expands enough to make contact and once electricity ... PC Desktops

My eMac will not turn on. I had it in the "sleep mode" and there was a short power outage in the Los Angeles area. Later when I came to my Mac, I couldn't get it to turn on. Is there a fuse that's replaceable or a reset button that should be pressed? Please help. Thanks, Reggie


Hi!\015\012 \015\012There is a power supply failure, please check the power supply--\015\012\015\012Step 1: Plug the PC into an electrical outlet r ... PC Desktops

Dead ECS G733 laptop


Jimbo6:\015\012\015\012your G733 may have two problems:\015\012\015\0121. power adaptor which should have an OVC of 19-20v in order to charge the battery of 14.8v.\015\012\015\0122. while you clean the button, you ... EliteGroup ECS G733 Notebook

Laptop dead, powercable ok. but the cable into the socket loose.


If you have digital multimeter, and a little background in electronics. See the power supply tag. It bears some important specification like Output voltage and if it is a DC voltage and polarity. Commonly it is near 20Vdc output setting the multimete ... NEC Versa VX Notebook

My PC is dead


Actuall the best thing to do is Get a new card and a power supply... Its not hard to fix the power supply... just connect the new power supply cables to where the old power supply cables were... If you just fit them to the same place it should be OK. ... Medion MD-1704 PC Desktop

T2085 will not turn on


Replacing a power supply is a rather simple affair. Just make sure that the new one purchased has the correct power connectors for your computer. The motherboard will probably have either a 20 or 24-pin connector. Many new power supplies will work ... E-Machines eMachines Desktop PC

My Toshiba Satellite 2415-S205 is dead as door nail, no lights, etc. I checked power supply, power jack and connection on board, all is OK. Now what, send into the shop for repair? Ted


Here are some suggestions I compiled, some you have done, thought I would throw it out there for you...\015\012\015\012 ... Toshiba Satellite 2415-S205 Notebook

No power on my nc6120


You are most likely dealing with a laptop whose power supply has blown/quit working. You are probably going to have to get someone to change out your power supply, or you might just have to buy a new laptop, depending on how old your laptop is, and ... HP Compaq nc6120 Notebook

HP Desktop power up problem


Bad ram probably, units do that all the time at my job. Most of the time, it is the power supply that does not have enough power to invest into all hardware that makes your pc. even if you had a 400watts power supply, the next time you are buying a p ... HP Pavilion a305w (DM181AR) PC Desktop

Emachine W2646--lights blinking on keyboard,pwr lamp on speaker on,power button on tower YELLOW,NO response! unplugged several hours,now dead,as if unplugged! This happened overnight while shut off completely,no one touched.


If you have a Yellow light on power supply, chances are you have blown the power supply.\015\012Even with a PC unplugged in a Bad Storm, I have seen many PC's and Laptops with Supplies shoot.\015\012If you ... E-Machines eMachines Desktop PC

Have a Dell XPS 200. Computer was on overnight when our power went out and then came back on. It was plugged into a power strip with surge protector. Now it will not turn on, no power, no lights, no fan comes on. It's just dead. Unplugged it, plugged directly into wall, turned the switch on the back of & on. NOTHING. What could cause this? Power supply, mobo? Could the bios battery cause this? Thanks!


Most probably, the fuse in the power supply has been burnt out when the power came back. Surge protectors only protect against voltage surges, not against rise in electric current (Amperes). The fuse inside your computer's power supply protects again ... PC Desktops
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.4185 seconds