Having problems with your ASUS F3Jm Notebook ?

My asus F3j Series have a problem. monitor always shuts down. when i boot the computer monitor starts but 3 second later shuts down.

Answers :

Repair Help & Product Troubleshooting for ASUS F3Jm Notebook

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Cannot get new Motherboard to boot up in Normal Mode

What u may have done is wwhen u were installing the new board, gave a static shock to the system...that will cause only the fans to come on and nothing more...this is a bad problem bc u cannot fix it...if u figure out something else is wrong, and it ... Gateway PC Desktops

My asus F3j Series have a problem. monitor always shuts down. when i boot the computer monitor starts but 3 second later shuts down.

... ASUS F3Jm Notebook

Pc won't boot ...

It seems to be an issue of a loose Hard drive connection.. you can open up a tower and re-connect the cable. ... HP Compaq Presario SR2150NX PC Desktop

My Fujitsu Siemens Scaleo P tower fails to boot up, sometimes shuts down after a few seconds, no output to monitor. Can you help My computer works fine untill one morning it shut down with no warning. Naturally I let the pc cool down because it is re known for over heating to quickly. A hour later I started it back up and a quick message was displayed say CPU Over heat then it shut down. I left it for a day and I turned it back on and within a few seconds the exact same thing happened. I clean

Start it up with the side of and watch the fan if it starts up and then stop or it sops the sarts again slowy and see if you can feal fan draft quite alot and put a house fan in front of side of pc as im 100%sure your fan is not cooling it and if you ... Fujitsu Siemens PC Desktops

DELL Inspiron 5150 isnt booting

If it doesn't respond at all with no ram or hdd, it is likely that the board is in fact dead.....sorry. When you say you found a broken pin, I assume you mean one of the contacts from the power jack to the main board had a cracked solder joint and yo ... Dell Inspiron 5150 Notebook

Beep problem Dell Dimension 4700

Beep problem update - Dell 4700. Last night started computer - cold boot. The screen had just started to light up and then went black and computer started beeping in an interrupted sequence. Fan speed increased considerably (suggesting overheat?) Shu ... Dell Dimension 4700 PC Desktop

Monitor reads: PC entering power saving mode then shuts off;PC on

First do not take the hard drive out and put it in another computer. It is configured to run in the computer it's in.\015\012\015\012Next, you probably did have a power surge either from your power supply or the power in your home. It s ... HP Pavilion a810n (PP164AA) PC Desktop

Monitor says no signal

Is this a brand new system? What is the make/model?\015\012\015\012This is a peculiar problem, as the computer was working fine for several months after you purchased the computer, then suddenly started this behavior. The fact that you ... PC Desktops

E machine monitor turns itself off and on

The same thing happened to me today. I was just sitting in my room then i hear a click and the cpu is on it stays on for a while then cuts off. It then cuts on and off with few seconds in between. It then stays in that way cutting and off for about a ... E-Machines eMachines Monitor E15T4

HP m7060n Media Center PC had boot problem: now won't display any

Lets try to repair it using the windows installation disc. First things first, look at the motherboard down on the right lower side. I would like you to find the CMOS jumper, it will be three pins sticking up with a plastic jumper made of plastic fit ... HP Media Center m7060n PC Desktop

Monitor goes blank less than a second after turning on.

Sounds like either there is a bad connection from the computer to the monitor, or the monitor has a faulty power regulator, causing the monitor to overheat prematurely, and shut off. ... Proview PL926WBi 19" LCD Monitor

Screen Wiggles, CPU Shuts Self Off, Powers Up Very Slowly

#1 Sounds like a video card resolution setting problem. This can happen when the settings are too high for the monitor. What size is your monitor?\015\012\015\012#2 Sounds like hibernation. You can adjust the power settings if you right c ... Dell OptiPlex GX280 PC Desktop

Dell e510 won't make it to post

Unplug computer, disconnect all usb/monitor/internet, open it, hold power button until green led on the inside on the motherboard turns off, pop out the BIOS battery (looks like a big watch battery and use a small flathead screwdriver to depress the ... Dell Dimension E510 Dual Core 2.8 Ghz (847403171179) PC Desktop

No output on Monitor

You cleaned the computer case out with a can of compressed air for computers? You had the computer unplugged from the surge protector? You touched the metal frame of the open computer case, to relieve your body of static electricity?IF so ... AMD (90613) PC Desktop

Gateway FPD1530 loses image shortly after powering up.

Try booting into safe mode. press F8 while the computer is booting. see if everything stays normal. It should tell you that it booted into safe mode. Once there, change the resolution or the frequency of the display(also known as the refresh rate) by ... Computer Monitors

Monitor Display Problem.

The first Polyview has a power supply problem (a short) and locks out the power until it is unplugged. You need to check the voltages inside the Monitor to determine which component/s are faulty. I hope you know electronics if not leave it to the r ... Polyview V17E 17" LCD Flat Panel Monitor

Computer power on, monitor and fan issues

Replace power supply it is weak. ... Acer Aspire L100 PC Desktop

No Signal when desktop wants to load

This is exactly what is happening to my monitor but happens a bit faster. Once the drive starts then the monitor turns on and turns straight back off again. The monitor works on other people's computers (including the tech guy at the shop I bought i ... ViewSonic VA1916w LCD Monitor

Lcd monitor power light flashing with no img. seems 2 be frozen

The display is in safe mode and you will need to reset the display to get the display out of the safe mode. There are 2 different model revisions. Please choose the method that will match your revision. Depending on the revision of the monitor, one ... Planar PL1910M (Black) 19 in. Flat Panel LCD Monitor

I installed a new power supply and video card in my Compaq presario ( picked out for me by the Geek Squad at Best Buy) and now my monitor shuts itself off before booting up - what is wrong??

Are you able to get a image from the computer as it boots up and then it dissapears once windows starts? If so it sounds like it might be because the new video card is causing the problem because the drivers for the old video are trying to run. Go in ... HP Compaq Presario S4300NX (DF216A#ABA) PC Desktop

Monitor stuck in standby..?

* Did the beeps go away when adding the new video card?\015\012\015\012* Have you booted in "Safe Mode" (Press F8 before Windows starts).\015\012 In safe there are at least two options:\015\012\015\012 option - ... Computer Monitors

I turned on my Dell Dimension 4700 computer,but the amber light started to blink . I held the start up button for 5 seconds and the light went out. I tried to start it up again and got the same thing, blinking amber . I waited an hour, this time it booted up . Was on for 15 minutes and it shut down. Blinking amber light again. A week later it booted up. Was good for a few days, then same thing happened, blinking amber. 2 days later boots up again. That's why I'm typing this to you while it's sti

Vaughn it sounds like the power supply is going bad, try another known good working power supply. If that doesn't work then the motherboard would need to be replaced. If the power supply isn't giving the correct voltages that could cause the comput ... Dell Dimension 4700 PC Desktop

My Presario SR1750NX won't boot up

Hold the power button for 10 seconds it turn off ur cpu and then start the cpu and hold F5 key u get windows boot menu select safemode try to login after login check in the controlpannel poweroptions chek in advance option see the menu down wheather ... HP Compaq Presario Media Center SR1750NX (EL445AA) PC Desktop

Hi when starting up the laptop a screen comes up saying 'configuring updates stage 3of3 - 0% complete Do not turn off your computer. then it seems to restart and the same happens again. ca you help????

Use your OS disk to access the Vista repair tools.Even for those without an OS disc, Vista has repair tools built in.To access them, boot the computer, but when you see the “Microsoft (C)” with the moving lines, hold the ... PC Desktops

Computer ranbdomly shuts down

Your last question was very observant. NO, without an O/S, there is nothing to make a anti-virus program run.I suggest the problem in the beginning, was that the laptop was overheating. Once the processor becomes too hot, (Processors have ... HP Pavilion dv4015CL PC Notebook
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 1.0790 seconds