Having problems with your AOpen F57JS (Silver) 15 in. Flat Panel LCD Monitor ?

Monitor says powersaving mode then shuts off - AOpen F57JS (Silver) 15 in. Flat Panel LCD Monitor


Answers :

Try the monitor with another computer.
Does the computer give any beeps when it starts up. A single beep is normal, any more than that you need to let us know what the sequence is. If you are getting no beeps, you either do not have a speaker connected to the motherboard or it could be that the CMOS battery is dead. Most motherboards use a CR2032 button battery, but check to make sure.
Believe it or not it could just be as simple as the CMOS battery, I have seen this many times.
Repair Help & Product Troubleshooting for AOpen F57JS (Silver) 15 in. Flat Panel LCD Monitor

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Monitor says powersaving mode then shuts off - AOpen F57JS (Silver) 15 in. Flat Panel LCD Monitor


Try the monitor with another computer.Does the computer give any beeps when it starts up. A single beep is normal, any more than that you need to let us know what the sequence is. If you are getting no beeps, you either do not have a speaker co ... AOpen F57JS (Silver) 15 in. Flat Panel LCD Monitor

How do I open my HPw 1907 Monitor - HP w1907 LCD Monitor


Start by removing the base. There are 3 screws. First pull the base\015\012plate off. Then remove 2 screws. Next remove the little rubber insert\015\012in the center of the base bracket. You will need a long phillips to get\015\012to the 3rd screw. S ... HP w1907 LCD Monitor

How do you take apart an HP w1907 monitor? I have one that the picture only stays on for a split second at power up and then goes blank. I suspect a filter capacitor but can't take it apart to check.


Haha, been there. This ones a little tricky. Hope you have strong\015\012fingers. start by removing the base. There are 3 screws. First pull the\015\012base plate off. Then remove 2 screws. Next remove the little rubber\015\012insert in the center of ... HP f2105 21" LCD Monitor

Vx1932wm-3 monitor has stopped working properly,it will only stay on for around 2sec then lose digital signal and go black,same with analog.cant seem to make it stay on,the light on monitor is blue when it says lost signal, the graphics card is working fine 9400 series nvidia


I had the exact same problem. It's a bad capacitor on your power board. It's most likely the 1000uF 25v one towards the center of the board. I noticed it on mine because the top of the capacitor was pushed out more than usual and it has some residue, ... ViewSonic VX1932WM LCD Monitor

The monitor will not power on.


Lucky you - You bought an L1906 Monitor from HP and one day all of a sudden, the Green Power LED just didn't turn on anymore. The Monitor appears to be dead!\015\012\015\012Why? \015\012\015\012Well I suspect it is because HP ... HP L1906 19" LCD Monitor

Thanx for the advice


Are you using a vga to dvi adapter then? Even though this usually is not an issue with older flat panels I have seen this problem where only a dvi to dvi will work. Secondly, If the panel calls for those extra amps you do need them and a replacement ... MPC Computers Envision EN 7100s 17 in. Flat Panel LCD Monitor

Monitor stays on for a few seconds then goes out


This problem is very often caused by dry electrolytic capacitors on the inverter board. If you have some skill with soldering you could try to change them. When buying new ones ask for LOW-ESR capacitors for switching mode power supplies (SMPS) and 1 ... Acer AL1711 17" Flat Panel LCD Monitor

Ac power cord for HP vf51 flat panel monitor


Good Day Tricia,\015\012\015\012I had to pull up you owner's manual to get the spec's on your cord, so if you need the manual follow this link:\015\012\015\012 ... ViewSonic VA720 17" LCD Flat Panel Monitor

LCD Screen blinks on & Off at start up up-to about 10 minutes


Okay, forgive me if I go over covered ground but reading the post, I only see your responses, not what was recommended. From everything I've seen the problem lies in one of the following areas.\015\012\015\012\015\012 ... ViewSonic VX922 19" Monitor Flat Panel

LiquidVideo L17LCD2 17 in. Flat Panel LCD Monitor - Power Issues


Firstly stop turning it off and on because you will blow something else like a power board then it will be a big paper weight.next get a torch and when it is powered on and supposed to be showing images, shine the torch at the screen.if y ... Liquid Video L17LCD2 17" Flat Panel LCD Monitor

Dell 1908s LCD monitor (new)


Return the LCD to seller and ask for replacement. LCD colors should be even from top to bottom. test it with plain color as a background such as blue so you can easily see the faded portion. ... Computer Monitors

Problem with Dell 2100FP LCD monitor


Hi,\015\012 Dell support , would recommend you to buy a new monitor because , they donot do any repairs on the LCD monitors., except for exchanging them, if they are in warranty. You can try the following people , they do repairs on dell flat ... Dell UltraSharp 2001FP 20.1" LCD Monitor

Monitor powers on for approx 8 secs then standby.Series of vertical stripes on panel but no image.Guessing the lcd is at fault?


When I applied the solution below, I go stripes when poorly reconnecting the logic board to the plate, and the plate ability to do it job can be effect by bits going on the inverter, wavely screen output etc. The lcd is an assembly kit inside have a ... iiyama ProLite E434S 17" LCD Monitor

LCD Screen blinks on & Off at start up up-to about 10 minutes


Hemante, you should look for electrolytic verticle can type capacitors whose tops are not flat but slightly swollen. Also check all the soldering for COLD or THERMALLY FRACTURED solder joints on the bottom of the inverter board that powers the CCF tu ... Computer Monitors

Input Signal Out of Range


I have been having the same problem with my hpvs17 monitor when i start to use my web browser on linux distros. Now, for the next few days i am going to try my system on a regular crt monitor. if the monitor does not crash, than i will have to say th ... HP Vs17 17" LCD Flat Panel Monitor

Dell E152 Flat Panel screen is REALLY dim.


I haven't seen this particular monitor. It may have deeply recessed black screws, or possibly even Torx screws. Try a #2 Phillips and see if it engages firmly. If not, try a T-10. Once you get inside, you will need to remove the power supply and main ... Dell E172FP 17" LCD Flat Panel Monitor

Gateway FPD 1830 18.1 in. Flat Panel Problem


Usually in these cases the power supply would be the issue, but you say the OSD window shows up clearly, So the LCD panel is good and the Power Supply /inverter depending on which your FPD has.FPD 1830 should have 3 boards(logic, Inverter, Powe ... Gateway FPD 1830 18.1" Flat Panel LCD Monitor

DVI problem with latest drivers


Do you mean GA-7VAX? Make sure you update all your drivers from here: http://tw.giga-byte.com/Support/Motherboard/Driver_Model.aspx?ProductID=1392 ... Dell UltraSharp 1900FP 19" Flat Panel LCD Monitor

Cleaning monitor I just need to know how to clean my new monitor. Do I use window cleaner?


I dont know which type you have but here is how to clean either:\015\012\015\012CRTs \015\012Those big chunky CRT monitors have glass screen wh ... Mag Innovision LT782S 17" Flat Panel LCD Monitor

My l g monitor screen suddenly turned into pinkish colour..i dont know whats the problem..i did degaus also but no use..


Dear Sir \015\012Welcome to Fixya Customer Support \015\012We will Help You\015\012Generally this problem arises due to faulty monitor Signal cable or by broken fins of VGA cable.check your monitor connectors for bent or broken pins ... Computer Monitors

Dell E173FPc 17" TFT when turned on goes black


Hi Gaz,First, verify the monitor is functional.Monitor STFC (Self Test Feature Check) Turn off the monitor Plug the monitor power cord directly into the wa ... Dell E173FPc 17" TFT LCD Flat Panel Monitor

Bluish screen -


Is it a greenish blue?..... if so you have lost your red signal..... check your monitor connectors for bent or broken pins...... usually happens after swapping cables or monitors on a computer..... you could also have a bad cable or monitor.....\015\ ... MPC Computers Envision EN 5100e 15" Flat Panel LCD Monitor

Screen So Bright I Can Barely See Anything...


Unfortunately the problem is the monitor has gone bad, more specifically and likely is the backlight which is used to light up the monitor. You could fix it by replacing the LCD, but you can get monitors cheaper than a replacement LCD so it wouldn't ... Computer Monitors

Monitor malfunction--back lighting?


To open,remove base.place monitor lcd side up, the silver screen frame comes off,try opening above logo,get it started and it comes right off.it's your inverter,the thingy that your backlights plug into. ... Computer Monitors

I cannt find driver for monitor LG L1953S - LG L1953S - flat panel display - TFT - 19" (Black, Silver) LCD Monitor


Actually, you should be able to use the monitor without installing a driver. If it isn't recognized automatically, just set the resolution to 1280*1024 pixel and set the screen refresh rate to 60Hz:In Windows XP right-click on the desktop, open ... LG L1953S - flat panel display - TFT - 19" (Black, Silver) LCD Monitor
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.9434 seconds