Having problems with your AMD eMachines Desktop System w/ 17'' CRT Display, 2.0 GHz Athlon 64 3000+ (W3400) ?

I have an emachine W3400. When you turn the power

\015 I have an emachine W3400. When you turn the power on, it comes on, fans run, for about 3 seconds. Then it cuts off, but the blue E blinks. I have tried to make sure I'm running proper electrical unit, made sure everything was seated properly....any other suggestions before I scrap it? Also, I removed the hard drive and used a tether to try and remove my files. There were pictures on there that are not on there anymore....any suggestions on what might have happened to them?\015

Answers :

Pc turns on but monitor keyboard mouse dont work i hold power button 5secounds or more the pc still dose not turn off till i un plug cable
Yes, your problem is an hardware problem but its not a external electricity problem.
\015\012this is d problem...
\015\012the power pack to your emachine is bad, i should have said almost but the fact is it is bad and needs to be changed...try this and it will work for you thanks.
Repair Help & Product Troubleshooting for AMD eMachines Desktop System w/ 17'' CRT Display, 2.0 GHz Athlon 64 3000+ (W3400)

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Emachine t5026 on and right off

Hi maybe you could try these steps I'm always doing when I experience the same problem as yours. This is only according to my experience fixing desktop computers.1. Try to disconnect all the connection at the back of your computer tower t ... PC Desktops

No power on my emachine

The power supply might be okay but the system board could be bad and not turning the power supply on when you press the power button.On this page:http://www.helpwithpcs.com/courses/power-supply-basics-inc-pinouts.htmabout midw ... E-Machines eMachines Refurbished EMA SYSTEM BOARD MODEL T2984 eMachines (102257) PC Desktop

EMachines T6528 desktop will not boot up

The power supply fan runs from either 5V or 12 so that only tells you that the voltage for fan operation is present.\015\012\015\012If you don't have a multimeter already, I would highly advise that you buy one.\015\012They are available for &l ... E-Machines eMachines Desktop PC

EMachine will not turn on.

Sounds like the power supply is faulty. Power supplies are very dangerous to try and repair, even for qualified technicians. I would also suggest not trying to plug it in or turn it on until the new power supply is in place. Faulty power supplies ... E-Machines eMachines Desktop PC

Emachine with XP home edition doesn't start

Hi hearalso, down to the basic's. Replace power cord. \015\012No help there than, remove the case's side panel to expose the motherboard. (Normally it is the left side panel while facing the front of the PC.)\015\012Look closely for a sma ... E-Machines eMachines Desktop PC

Emachine T2542 Won't power on

It looks like your computer's power supply unit is gone. This is common with the eMachine T2542 series. Unfortunately, sometimes this destroys your motherboard as well. ... E-Machines eMachines Desktop PC

EMachine T2824 does not turn on. Power cord/power supply seems O.K.

There are just too many eMachine models to be familiar with every one, however, as a preliminary inspection, remove the side panel, and turn the computer on to see if you see a green "Health" light. This will give you an initial clue as to how to pur ... E-Machines (T2824) PC Desktop

Emachine desktop The computer worked fine one day and the next day when we went to turn it on it would not power up. The monitor comes on and on the monitor screen it said monitor working fine check hard drive. Well I can't check anything because the tower has no power. The light around the button doesn't come on and you can't hear any kind of fan starting. Called emachines and the only thing they could tell me was to change outlets, did that, turn power off (no power) leave unplugged for 3 minu

I understand that your cpu is not turning on and the repairer confirmed that it is the issue with the mother board. I suggest you to please check the smps fan spinning or not. If its spinning then then the issue could be with the mother board. If not ... E-Machines eMachines Desktop PC

I am looking for a wiring diagram for my emachine front power switch

Power Supply Types \015\012\015\012There are two basic types of power supplies. There are AT power supplies, which are older and in older computers, and ATX power supplies, which you will find in virtually every new c ... E-Machines eMachines Desktop PC

When I turn it on, only the fans run. I cannot hear the hard drive run and the hard drive light on the bezel is solid yellow

EMachines were designed to be Budget computers. As such the company used cheap Power Supply's. Cheap components within the power supply have failed. The power supply only has enough power to light, lights, and spin fans.Solution is to rep ... E-Machines T6216 (827103077834) PC Desktop

Emachine D2880 no power clarification

Your getting power to your PSU, via the green light on your mobo. \015\012verify the PSU has a green light(most emachines do) \015\012it sort of sounds stupid but, check the connection of the cable coming from the front of the case(the wi ... E-Machines eMachines Desktop PC

When i turn on my emachines 420 at the mains, the led power light comes on, but it wont do anything else including turning on or off

Hello there,this sounds like a problem with your power supply unit inside the computer,emachines are always blowing there power supply because the one that comes with the computer just is not powerful enough.If you are confident enough around electri ... E-Machines eMachines Desktop PC

I have an emachine W3400. When you turn the power

Pc turns on but monitor keyboard mouse dont work i hold power button 5secounds or more the pc still dose not turn off till i un plug cable ... AMD eMachines Desktop System w/ 17'' CRT Display, 2.0 GHz Athlon 64 3000+ (W3400)

T2085 will not turn on

It is fairly easy to replace the power supply, a few screws to remove the power supply then it is just a matter of unplugging all the power connections from the old one, swapping out the supplies and matching the power connections up with the s ... E-Machines eMachines Desktop PC

My e-Machine W3115 automatically shuts down multiple times

1) Computer off, and unplugged from power. (Unplug from the surge protector FIRST, then unplug the power cable out of the power supply)2) Work on a table where you have plenty of room.Open the computer case. (Rear of computer, ... eMachines W3115 PC Desktop

Emachines W3052 Gets stuck on logo screen when starting up.

My computer does a similar thing, the issue with mine is the mother board which requires everything to be at a certain temperature. Let it run on the start screen for a couple minutes and hit the reset button. If it doesn't boot up you're going to ha ... E-Machines W3052 PC Desktop

Emachine not turning off.

You can checkit by unhooking it on the inside from the mobo panal just remember where it ogoes back take a small flat head and cross the two prongs it comes of off then shut it down if it works look on ebay for a complete front panel with switch or o ... E-Machines eMachines Desktop PC

Emachines , shutting off on it's own?

While it is possible the power supply could be going bad, usually it would not work intermittently like this.\015\012\015\012Most likely the motherboard is starting to go bad, I would do a quick visual inspection for any buldging or leaki ... E-Machines eMachines Desktop PC

Emachine Turns Off

This is the best way to tell. If your system is shutting down on you by behaving like your shutting it down thru windows then it could be a spyware, virus trojan issue going on. If thats the case then run your virus program and see what it finds and ... PC Laptops

Itt urns on but it stays on the emachine bootup

We can only try for a power drain for this issue,\015\012\015\012all you have to do is unplug the power cable from the computer and battery too, then press and hold the power button for 40sec( without battery and power chord), then connec ... E-Machines M5414 Notebook

Emachine tower won't turn on

Smps it is on cpu. where u connect power supplty cable it is 1 square box.it is on top[ of cpu back side. ... E-Machines eMachines Desktop PC

T2642 eMachine - does not turn on

... PC Desktops

T2542 Emachine Is there anyway I can a schematic that shows me how to start troubleshooting the power supply. I turned everything off and unplugged it replaced the power supply with a new one and get a yellow light. The fan came on for a good 3 to 4 seconds but then turned off. any suggestions

It's hard to troubleshoot a power supply. They are very dangerous and contain electricity for some time after turned off. If your new one isn't solving your problem it makes me think it's not the power supply unless it's not powerful eno ... E-Machines eMachines Desktop PC

EMachine T3958 Won't start - Please help

The green LED indicates that the standby voltage is present which is what provides the power so the front button can tell the unit to turn on fully.\015\012At that point, there are 3 possibilities; the power supply has a fault and won't turn on ... E-Machines eMachines Desktop PC

Emachines problem... PSU works but comp doesnt turn on

Hi,\015\012I don't want to tell you a color because it could be different than the actual. Look at the front of the computer and trace the wire that goes to the switch and follow it to the mother board. If you have a volt meter you could measure the ... E-Machines eMachines Desktop PC
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.5561 seconds