Having problems with your Acer Computer Monitors ?

LG FLATRON L1922P MONITOR STUCK IN ANALOG MODE

\015 \015\012COMPUTER SHUT DOWN DUE TO POWER INTERRUPTION. WHEN POWER WAS RESTORED THE MONITOR WOULD NOT COME BACK ON FOR THREE OR FOUR DAYS. JUST KEPT FLASHING POWER SAVER MODE. NOW BACK ON BUT IS STUCK IN ANALOG MODE.\015

Answers :

Probably itz either minor case of software corruption/improper ground/cpu fan..
or major case of faulty or defective main board/ram/addon/daughter cards..

assuming that ur not using any backup devices such as ups/inverter/cvt so on..as u didn't mention..
also assuming that the bios has not been flashed in a wrong way..

..plz do check the following as in order:..
the Hardware part:..
1)a)\015\012in power-on mode, open/unplug the data/vga cable of the monitor from\015\012cabinet..see if raster or 'osd' is appearing on the monitor screen..if\015\012so monitor is ok..else replace the monitor and see..[not applicable in\015\012case of laptop]..
b) in case of laptop try to get output from\015\012external display unit/monitor using vga port..if there's proper display\015\012in there..the problem is probably with either the 'lcd' or 'ccfl' or\015\012'inverter circuit'..

2) if u hv a graphics card, replace with a standby or onboard and see..[not applicable in case of laptop]..

3) unplug mains supply..pick open/remove the cmos battery..check (above +3v)..resit..

4)\015\012see if the ram(s) is loose/faulty..open clean/remove carbon &\015\012or oxide formed on the teeth with an eraser n resit it..or replace with\015\012a standby n see..

5) a) see if ur hdd is noisy or emitting any 'ticking' noise (like 'tuk tuk' or 'kirr kirr')..
b) or if the system is not supporting either the newly installed device or itz software/driver /firmware
if so, u need either a fresh os installation or ur hdd is likely to b replaced..

6) remove/clean dust\015\012neatly..dust is non-uniform in nature n may cause\015\012jam/short circuitry/excess resistance n many more..resulting an increase\015\012in heat..

7) open the CPU Heat-Sink with fan out of the\015\012socket..put some "Heat Sink Compound" (available in local electronics\015\012chip level spare market)between the cpu/processor and the CPU Heat Sink\015\012*** fan..resit/fit it tightly in position..

8) on main/mother\015\012board..see with a debug card for mb error..may b short..look for\015\012defective capacitors(espabove1000mfd)/mosfets..go through the mb's\015\012south bridge n the circuit lie around atx connector..the crystal clock\015\012generator (if cpu isn't heating up)..

9) [in case of desktop] the\015\012smps itself may b defective/faulty..check the outputs of smps viz. 0v\015\012(black~ground); +12v(yellow); +5v (red, green~ps-on, violet~pg&\015\012grey~sb); -12v (blue);-5v(white); +3.3v(orange)..the 'oscillator and\015\012error amplifier ic',or pwm switching regulator circuit..look\015\012for defective protector-transformer/resistance (esp 4.7k)/mosfet..
check the battery n adapter [main power], in case of laptops..

if u r not a professional, seek advice of ur system admin/vendor....
Repair Help & Product Troubleshooting for Acer Computer Monitors

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

LG FLATRON L1922P MONITOR STUCK IN ANALOG MODE


Probably itz either minor case of software corruption/improper ground/cpu fan..or major case of faulty or defective main board/ram/addon/daughter cards..assuming that ur not using any backup devices such as ups/inverte ... Acer Computer Monitors

LG Flatron W2252TQ Monitor stuck in digital power saving mode


Raymond, (did) you solve the problem?i've got exactly the same problem and i've read more similar complaints on the internetgriris ... LG W2252TQ Monitor

LG Flatron W2252TQ 22'' monitor not working in digital mode


Try to set your screen resolution to maximum using Display Settings in windows. Besides, are all software drivers for this monitor loaded and properly installed? Right click My Computer=>Properties. select hardware => device manager. Make sure ... LG W2252TQ Monitor

Lg monitors my monitor is in analog power saving mode how can i I just bought a LG Flatron W1952TQ computer monitor. I attached it to my computer and monitor displayed nothing, unless the 'source' button is pushed. The monitor promptly exhibits a ANALOG POWER SAVING MODE message and goes black. Same problem with the same monitor(LG Flatron W1952TQ)...Tech support told me that I need to change the resolution to 1440x900 to fix the problem. Unfortunately I am not given that option in my settin


... LG Flatron L1750S 17" LCD Monitor

LG monitor stuck in analog mode


... LG L196WTQ Monitor

LG screen goes in stand by. I was using two monitors for several months, everything OK, now I decided to get a new LG Flatron instead of one of the monitors... and only this one goes in safe mode!! Two screens plugged in: Philips analogical working fine no problems. New LG Flatron digital goes in power save mode after few minutes Tried to plug in ONLY the LG, same problem after few minutes. Philips monitor no problems. So it HAS to be a screen function or problem of the LG? Computer: AMD + 3Ghz


Oke having a similar problem atm, this is what i have found so far. was trying to help a friend who has bought the same 19" LG monitor. When i connected the monitor to her PC i noticed that it was not the same connection as the previous one but it ha ... LG 19" Widescreen Flat Panel LCD Monitor

SVA Monitor stuck in Analog Mode or Sleep Mode


Actually it was quite easy. I rebooted my computer in "safe mode" by restarting it and pressing the F8 key. At the start up windows gives you an option to toggle down to "enable VGA mode" and select it. After that, my computer recognized my monitor a ... SVA-USA SVA VR 15A 15" Flat Panel LCD Monitor

Flatron monitor I have a flatron monitor that keeps going on and off. At the top of the monitor is displayed ANALOG, Then it also says power saving mode. How do I turn this off? My son gave me the monitor without a manual. thanks


You need to check the monitor cable if it is correctly connected to the motherboard port. If the analog display or no signal it means the monitor cable should bot connected. If you have a video card in your motherboard you can plug your monitor cable ... LG Flatron F700P 17" CRT Monitor

LG FLatron W2252TQ Not working properley in DIgital mode.


... Computer Monitors

Kittens were playing pounce/hide and seek around my computer. The LG LCD monitor (L227 WTG) now staying in analog power saving mode and I can do nothing! Right before it got stuck in that, the color went from a sunset of pinks, blues and corals to black clouds and green. :-( Now I can't even get that far to be aggravated by the color changes. I don't know what the kittens did, but my computer does not like it! Help?! Please!


Check to insure that the connections are all securely connected, they could have bumped one loose. Also a lot of monitors have dual inputs, one for analog and the other digital. There is usually a button on the the front of the monitor that allows ... Computer Monitors

Monitor shuts off during boot. Let the machine boot full up, hit the power button, the monitor flashes windows for a split second, and goes back to power saving mode


Hey there Celius,Chances are the 'Refresh Rate' somehow got set too high for the monitor. On flatscreens , the result is a black screen.If you have an old monitor (crt type) hook that up temporarily and reboot.\015\012 ... LG Computer Monitors

Analog Out Of range (LG Flatron L1750T)


Some games need high resolution. Monitor resolution not supporting for this game.\015\012Powersaver mode showing when the main PCB of the monitor failed. check this link to get the service center info ... LG Flatron L1750S 17" LCD Monitor

Analog- out of range


Boot PC into safe mode, (pressing f8 on startup) then go to display settings and switch resolution to 640x480 (basic setting)\015\012\015\012then reboot into normal mode, and then go to display settings and then choose an appropriate d ... LG Flatron L1951S-SN 19" LCD Flat Panel Monitor

Dell c521 seems to be wil not launch


Try to completely turn off the computer by pressing and holding the power button for at least 4 seconds. Disconnect it from the mains, wait for a few minutes and the connect and try to power on. If this alone helps, you might be right that it is not ... Dell Dimension C521 PC Desktop

Old monitor not recognized by new computer, stuck in power save.


... Dell UltraSharp 1704FPT 17" Flat Panel LCD Monitor

LG Flatron L1710S Monitor stuck in Power Save Mode


Try wiggling the Cord on the backside of the monitor.. Not the Power Plug Cord, The Other Cord that attaches to the PC. Do this once the monitor turns off , grab ahold of the cord about 2 inches from the back of the monitor, then bend the cord to the ... LG Flatron L1710S 17" LCD Monitor

Monitor not work


Try starting your computer in VGA mode (one of the options available from the menu you get if you keep tapping F8 as the computer starts up). In this mode the monitor should work well enough to get to the right resolution. Go to the display settings ... LG Flatron 995FT 19" CRT Monitor

Analog power save mode


I had the same problem with the same screen as you.i connected the usual blue plug on my pc, and i got the same message as you did.i finally realised that i connected it on the on-board graphics card(VGA?)i added a new plug(adaptor) ... LG Flatron L1951S-SN 19" LCD Flat Panel Monitor

Stuck in power save mode


Have you have selected the input you are using? You can switch between analog and digital input. The monitor would stay in power save if the input other than the one you are using is selected.\015\012I believe the default input is DVI. Are you ... Princeton Digital VL1916 19" LCD Monitor

LG Flatron power save mode


I bet you plugged into the VGA output on your motherboard instead of your video card. I accidentally did this once myself. Look on back of the machine and see if there is more than one possible place to plug the monitor into. If that's n ... LG Flatron L1951S 19" LCD Flat Panel Monitor

LG stuck in powersave mode


Connect it to a different computer, e.g., a notebook computer,\015\012and set the screen-resolution to 800-by-600, and see if the monitor works.\015\012Change the screen-resolution to 1024-by-768, and try again.\015\012Change the sc ... LG W1942TQ-BF 19 inch Monitor

L222WT flatron 21.6 monitor is not working


Power saving is the default the monitor goes into if it doesn't get the correct signal down the cable wires of the computer. There might be three culprits:  (1) the cable between computer and display (most likely), (2) the display itself (unlike ... Computer Monitors

My monitor is stuck in Analog Power Saving Mode. When I hook it up to a different computer it works fine. When I hook it back up to my Dell Deminsion 4600c it goes back into power saving mode. How do I get it out of Power Saving Mode? Thanks for any help


You can find it in safemode press f5 in boot up. ... Dell Dimension 4600 PC Desktop

My flatron 1920P monitor is in power saving mode. How do I get it out of power saving mode?


It may stuck in the standby mode because it is not seeing the signal feeding it or there is problem in the power supply, look for burnt parts, bad capacitors, etc.\015\012 ... LG L1920P 19" LCD Monitor

I have just installed a crucial x1600 pro graphics card,when i fired up the computor the monitor displayed multi coloured vertical lines and a box appeared saying it was in analog mode, how do i configure the targa visionary monitor to digital mode. regds A Gough


I'm assuming "it" is the monitor rather than the video card, and that you are using some flavor of windows as your operating system. 1. Digital vs Analog mode is determined by the cable input plug on the monitor that use. Your cable fr ... PC Desktops
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.5611 seconds