Having problems with your Acer 22" X223w LCD Monitor ?

It says "no signal" even tho' i've installed monitor

Answers :

\015\012"No signal" error may be due to various reasons which include:\015\012
\015\0121. The cable is not attached securely to the VGA socket on either the computer or the monitor end. Remove the cable and reconnect it securely.\015\012
\015\0122. The cable or the cable pins are damaged. Check the cable for any visible damage or bent pins.\015\012
\015\0123. The video card or the on-board video of your PC has malfunctioned. Connect your monitor to another source to rule out this cause.\015\012
\015\012Also, please let us know your PC configuration, make and model and also the operating system. Thanks.
Repair Help & Product Troubleshooting for Acer 22" X223w LCD Monitor

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Emachine w3410 monitor says no signal

... E-Machines eMachines Desktop PC

My monitor says no signal

A friend gave me this computer because he got another and was tired of messing with this one ... he says he turned it off one night and it would never boot back up , sso i had a new 160 gig hd which is the same that was in it and i installed it think ... E-Machines eMachines Monitor E15T4

It says "no signal" even tho' i've installed monitor

Hi,\015\012\015\012\015\012"No signal" error may be due to various reasons which include:\015\012\015\012\015\0121. The cable is not attached securely to the VGA socket on either the computer or the monitor end. Remove the cab ... Acer 22" X223w LCD Monitor

I cannot restart my PC AllI get is a note saying NO SIGNAL ANALOG

I had a problem like that ,my tower got bumped and fell over. the heatsink and processor fell off. i had to remove processor (p4) from heatsink and make sure all the pins were straight and aligned properly. i cleaned both parts with alcohol. i then ... Gateway GT5058 Desktop PC

Monitor comes up shows "acer" then says no signal and goes black

The interface between the monitor and the cable might need replacement. Please check it. ... Acer AL2016 W 20" TFT LCD Monitor

I've been trying to use s-video cable to connect

\012\012At the rear or side of the PC there should be either or both of a 15 Pin DIN Plug, HDMI socket. or a Yellow RCA or 4 -7 pin DIN. Now IF these are present then YES you can connect to a TV. Now some TV' ... Acer Aspire 3690-2196 Notebook

Laptop to tv

\012Right, well, IF your TV has a DB15 Female Plug on it then you CAN, connect it up and it will work, as a second "Monitor". OR If the laptop, has a "Composite Video" a Yellow RCA socket, then you ... Acer Aspire 5500 5570-2609 Laptop

Dell 1600SC Server - trying to install a video card

Try repeatadely pressing delete on startup with the monitor cable attached to your onboard graphics socket but keep the new graphics card in. then you should go into the bios. change the graphics setting to your graphics car and then save and reboot. ... Dell PowerEdge 1600SC Server

EMachine stopped displaying video (card not working, just mobo)

Hi there\015\012\015\012I would say it's the graphics card that's failed. You might get the same beeps for faulty card as removed card....\015\012\015\012Take it to a shop where they can test a compatible card, before they se ... E-Machines eMachines Desktop PC

Acer al1716 monitor input not supported

Hi Budmrtn,Ive downloaded Football Manager 2010 and when i first started the game, everything was fine, UNTIL i decided to mess about the resolution settings on the game, and the next thing i know, i see INPUT NOT SUPPORTED.Iv ... Acer AL1716 17" LCD Monitor

Toshiba Satellite limitations on network adapters all wireless, need other

You need to log into the router setting by typing something like 192.168.*.* etc,check the right one for your router and enable some type of encryption like 128bits wep..Then your network is secured with a password which will stop anyone access.Now a ... Toshiba Satellite M40-S417TD Notebook

Adding a monitor to ibm thinkpad using ubuntu

When you connext an external monitor to the laptop, power up the monitor then power up the laptop. The video infomation should automatically divert to the extermal monitor. You can toggle between the external monitor and the LCD screen by pressinf th ... IBM ThinkPad G40 Notebook

My Acer AL1916W says No Signal but I have checked the cable and it is connected. We just had a new hard drive installed, could that be the problem?

Hello, Chef. If it doesn't ever come up at all, even on boot, try a different monitor (just \015\012for testing).If another monitor works, it could be the video card in the PC. You said that you just had a new hard ... Acer AL1916W 19" LCD Monitor

Have emachines T6528 graphics problem

If it doesn't boot at all .( this is the reason that you see that message on the screen it means that no video signal came out from the computer ) ..try to change the cable that leads from the pc to the monitor first ...and if the problem its still o ... E-Machines T6528 PC Desktop

My monitor is going on and off, even if its not connected to the computer. its stays on for 10 seconds saying no signal. then shuts off n comes on again right away for another 10 sec, ect.

Matteson1914, If unplugging from wall outlet and then plugging it back in 1 minute later will not stop (correct) the problem you have, then I would suspect (as always) the "switch-mode-power-supply" has a serious problem. Whenever an lcd with CCFL ba ... Princeton Digital VL1918 Monitor

I have a Philps Freevents company and my monitor is saying no signal and I have no image. I have checked all the connections & re-booted, but still no signal. I have even plugged the monitor into my brother's laptop and it worked! Please help

Possible Video card conflict in your PCTry swapping out the Video card with another one,,or if it's a built in Video card,,you can install an external card and you should be just fine. ... Computer Monitors

Monitor says no signal

Is this a brand new system? What is the make/model?\015\012\015\012This is a peculiar problem, as the computer was working fine for several months after you purchased the computer, then suddenly started this behavior. The fact that you ... PC Desktops

DELL Inspiron 5150 isnt booting

If it doesn't respond at all with no ram or hdd, it is likely that the board is in fact dead.....sorry. When you say you found a broken pin, I assume you mean one of the contacts from the power jack to the main board had a cracked solder joint and yo ... Dell Inspiron 5150 Notebook

Monitor goes into power saver mode

Take your Agp card with you to the shop. You do not need to go through Gateway, but there are serveal formats of AGP regarding the voltages.\015\012\015\012By the sounds of it you have the newer version of AGP so finding a replacement car ... Gateway 500 X PC Desktop

EMachine T6522 monitor says "no signal input" when turned on. tower switch light on and motor seems to be running. Nothing but above message on monitor. Checked both ends of cable and unplugged tower and plugged back in.

This could be an issue of a video card gone bad. I have experienced the same issue firsthand. This could also mean that no RAM is installed. If you have been using this computer previously, the second option is probably not even an option.\0 ... eMachines PC Desktops

Can't get screen display

Ok, the resolution the computer is using now is out of the range that is supported, try another monitor or try pressing F8 on the startup to get the advanced startup menu then select safe mode, in safe mode uninstall the driver you installed, this sh ... AcerPower 2000-UD431C - Core 2 Duo E4300 1.8 GHz (S6463626) PC Desktop

Monitor will sometimes show graphics, other times will say no signal found or be totally black. I've tried 2 different monitors, and same problem with both.

Either way, it appears as though whatever video hardware you are using is on it's way out, due to your having tried two different monitors with the same results. \015\012If you are using the onboard video, take a jaunt to your local computer pa ... Gateway GT4016 Desktop PC

Signal to monitor goes in and out, mostly out

Hopefully, it is just the on board video that has gone bad, and not the motherboard. When you install a video card on a PC, that has on board or integrated video, you will need to access the BIOS screen on start up and disable the on board video. T ... Gateway GT5220 PC Desktop

Tried Installing new Hard Drive, Now no picture

See the hardrive cables and also check that jumpers in hard drive just connect one hard drive at a time first ok set jumpers to master settings and then try if the problem persists Try changing RAM it is the main culprit if ur computer i ... E-Machines T4155 PC Desktop

E-machine T3085 video card problem?

Yeppers..that video card sounds bad..open up machine first, and make certain it's still seated properly.got backup for that E machine? ... PC Desktops
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.9798 seconds