Having problems with your PC Laptops ?

No go toshiba p30-110  will not boot pxe-e61 media test failure tried new hard drive still the same turn off network boot still the same put in new dvd still the same tried to boot from cd but no go any help thanks


Answers :

This error can be caused by one or more of the below possibilities.
\015\012
    \015\012
  1. Floppy or CD that is not bootable is currently in the computer. \015\012
  2. BIOS or CMOS setup is not setup properly. \015\012
  3. Hard disk drive does not have bootable files on it. \015\012
  4. The hard disk drive is bad or not connected properly.
\015\012Solution:\015\012Floppy or CD that is not bootable is currently in the computer\015\012\015\012Verify that no floppy diskette or CD is currently in the computer. If a diskette or CD is in the computer that is not bootable your computer may attempt to boot from that diskette or CD causing this error message.
\015\012BIOS is not setup properly\015\012\015\012Additional information and help with getting into BIOS or CMOS setup can be found on http://www.computerhope.com/issues/ch000192.htm
\015\012
    \015\012
  1. Verify that your hard disk drive is setup and detected properly in BIOS. You're computer should list a hard disk drive installed either under the main page or the drives page in BIOS. If BIOS indicates the drive is not installed or not detected skip to Hard Disk drive is bad or not connected properly. \015\012
  2. Verify the boot options are properly set in BIOS, almost all BIOS setups should contain options specifying how your computer boots. For example, most computers should have their boot options setup similar to the below example.

     - Floppy drive
     - CD drive
     - Hard drive
      \015\012
  3. Rest your BIOS to default values. Many BIOS will enable users to reset the values to the default settings. If you've tried the above options without success try resetting the BIOS.
\015\012Hard disk drive does not have bootable files on it\015\012\015\012It is possible that command.com or another bootable file may be missing from the hard disk drive. Follow the below steps to possible resolve your issue.
\015\012Windows 95, Windows 98, and Windows ME users
\015\012
    \015\012
  1. Boot from a bootable floppy diskette. \015\012
  2. At the A:\\> type fdisk <press enter> \015\012
  3. If you receive a message no fixed disk present, read Hard Disk drive is bad or not connected properly. \015\012
  4. If you are able to get into fdisk, choose option 4 to display the partition information. In the partition information, if the System is listed as FAT16 or FAT32 then continue to step 5. If you have a message indicating no partitions defined, no information is on your hard disk drive and you will need to create a new partition. See our fdisk page for additional information. \015\012
  5. If you see FAT16 or FAT32 in fdisk press the ESC key until back at the A:\\> \015\012
  6. Once at the A:\\> type, sys c: <press enter> (only do this command if you are using the same operating system that this diskette was created on). \015\012
  7. This should return a message 'System Transferred', if you receive bad command or file name and have verified you have typed the command properly, you will need to obtain a bootable diskette with the file sys.com on it. \015\012
  8. If system was transferred successfully, reboot the computer and issue should be resolved.
\015\012Windows 2000 and Windows XP users
\015\012
    \015\012
  1. Boot from either your ERD, your bootable Windows CD, or your bootable restore CD. \015\012
  2. Once boot attempt to repair Windows. If you're able to repair Windows remove the disks and reboot the computer.
\015\012All users
\015\012If your operating system is not listed above or the above steps did not resolve your issue you can also try erasing the hard disk drive and starting over.The hard disk drive is bad or not connected properly
\015\012\015\012If you have attempted all above suggestions and you are still encountering the same issues, verify the connections are properly connected to the computer if the hard drive was recently installed or the computer was moved. 
\015\012
\015\012Unfortunately, if all connections are setup properly and all the above recommendations have been attempted, it is likely that the hard disk drive is bad and it will need to be replaced.
Repair Help & Product Troubleshooting for PC Laptops

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

No go toshiba p30-110  will not boot pxe-e61 media test failure tried new hard drive still the same turn off network boot still the same put in new dvd still the same tried to boot from cd but no go any help thanks


This error can be caused by one or more of the below possibilities.\015\012\015\012Floppy or CD that is not bootable is current ... PC Laptops

Acer l100 will not boot up


To all of those out there with an Acer Aspire L100 SFF that has decided it will no longer boot - Symptoms: fans spin up, DVD spins up, possibly HD spinning up - no power, HD or network lights on front panel. Previous Fixes: Changing out 3 ... Acer Aspire 5610-4648 Notebook

Can't set up network w linksys modem


Video card:Your computer has an integrated video card but has a "PCI Express" expansion slot for an upgrade. After the upgrade you will be able to play most games without the choppy frame rate...depending on what card you buy. Since ... PC Desktops

Cannot get new Motherboard to boot up in Normal Mode


What u may have done is wwhen u were installing the new board, gave a static shock to the system...that will cause only the fans to come on and nothing more...this is a bad problem bc u cannot fix it...if u figure out something else is wrong, and it ... Gateway PC Desktops

Acer Aspire 5920 alt f10 to use my recovery dsk mismatch d2d32


This a very common error. I too have suffered from this but after about 15 hours of fighting with it.. I fix it. I could not use the ALT + F10 keys as I would get the D2D32 Type Mismatch Error. So lucky me when I got my laptop from acer I made the re ... Acer Aspire 5610-4648 Notebook

Cannot restore Operating System files to Averatec 5110p,DVDfail?


Hi, An alternative; why force the issue? If the laptop will only boot on the HD C:, why not make C fully bootable with DOS. Remove the HD in question from the laptop, fit it to a 2.5 IDE/SATA to USB adapter; hook the combo to a USB port ... Averatec PC Laptops

PXE-E61 Media Test Failure PXE-M0F Exiting PXE ROM


The laptop not recognizing the boot devices except the network boot that it found but there was no connection so it exit the pxe rom. first you need to open up the laptop and see what is running around inside maybe metal and your in for trouble if it ... Acer Aspire 5100 Notebook

The laptop did not boot


No I help you get both "puters" running fast as they can, let's start with the Tosh, it sounds like you had a "Board virus,and or BOT, those are about the ONLY two viruses, that'll wipe out the Cmos try this turn it on then off then back on again an ... Toshiba Satellite A135-S2276 Notebook

How to access windows drive to backup data through using the recovery disk


You are in luck. There is a wide variety of solutions available to you, but which you can use will depend upon your configuration. You will need access to another computer that is working, and has a cd-burner and an Internet connection.Go ... Toshiba Satellite M30 Notebook

How to get information from an old XP computer to a new Windows 7 computer


If the XP computer has service pack 3 and will boot then you can use Microsoft Easy Transfer. You will need to download the XP version of the software, http://go.microsoft.com/fwlink/?LinkId=160881 (either directly to the old computer with it on your ... Gateway ONE GZ7108 All-in-One Desktop PC

How to increase the system's process speed?


Hi im josh in cebu phils may i helped you?This is a very common question about a very common problem: My computer is slow, what can I do?Rest\015\012assured that while there are indeed plenty of things you can do to\015\012speed up your P ... Computer Processors

CD Drive problems


To run the dell diagnostic from CD, do the following:\015\012\015\012Insert your Dell Resource CD into the CD or DVD drive.\015\012Turn the computer off. Press the Power Button to turn the computer back on. \015\012Press ... Dell Dimension 5100 (D51L1) PC Desktop

My dvd-r does not read discs or anything, i've tried looking at my computer management bit and it says its working fine, and i've uninstalled it and re-installed it and it still don't work, a friend has said to try remove it and start my computer then turn my computer back off , put it back in and then it might work again, what do you think? how do i remove it? its an acer aspire 5520


I found this page that describes how to remove the drive in a 3000, it should be similar to the computer you are running\015\012\015\0121) remove the side panels from your case.2) disconnect the drive cables from the back of the old ... Acer Aspire 5520-5908 Notebook

Missing NTLDR file


The first thing to do is try to change back whatever hardware or software change you just made (this could be as simple as leaving a floppy disk in the drive or you need to reseat the IDE cables). If the contents of the drive are especially important ... ASUS Eee PC 2G Surf Notebook

Blank screen after boot up


This issue may occur if one of the following conditions is true: \015\012Cause 1\015\012\015\012 loadTOCNode(3, 'cause');\015\012 \015\012This issue may occur if you have a CD, a DVD or a floppy disk in your CD, DVD, or floppy drive ... Dell Dimension 3000 PC Desktop

Poweredge1300 no post


Good news, you can save the machine, although it may take a while. There are a few ways to do this. If you are lucky enough that the boot sector of your BIOS didn't get corrupt and your computer still posts and you can put in a floppy. Then all you ... Dell PowerEdge 1300 Server

I have an acer aspire 5315. i want to change my os from vista to xp, is this possible and how can i do it?


Hi there,yes this is possible ... but i must say its a bit tricky ...u will need to follow my steps closely .....if you have not tried to do this your self already...first download your drivers:- Open this PDF with Acer Driver ... PC Desktops

My HP a420n won't start after replacing cd-rw drive


Please try to remove all the connections from your computer and also connections inside the motherboard, the power cord for your hard drives and also the power cord from the power supply to your motherboard.After that, remove the memory and clean the ... PC Desktops

LG e500 won't boot up, black screen!!


I think this is a bios problem. Locate the bios lithium cell and replace it and try again ... LG E500 Express Dual Series Notebook PC

Dropped laptop...damaged hdd or something else?


Hello\015\012\015\012\015\012the problem with the recovery cd is most likely that your computer is set to start from HDD and not CDROM FIRST.\015\012\015\012\015\012I've written detailed instructions on how to change the boot ... Compaq Armada E500 Notebook

Computer won't load anything


You stated you removed the CPU. Did you clean the old theraml grease off & apply new before you reconnected your heat sink & fan? Did you reconnect the ATX 12V JPW1? power. This 12V power connector is used to provide power to the CPU? Lastly ... PC Desktops

Dell e510 won't make it to post


Unplug computer, disconnect all usb/monitor/internet, open it, hold power button until green led on the inside on the motherboard turns off, pop out the BIOS battery (looks like a big watch battery and use a small flathead screwdriver to depress the ... Dell Dimension E510 Dual Core 2.8 Ghz (847403171179) PC Desktop

My computer w2686 do not start


I'm assuming that when you say "unplugged" that are you are meaning to say that you're unplugging the IDE ribbon but still leaving the power plugged in to the device.Try resetting your CMOS settings by using the jumper on the motherboard. ... E-Machines eMachines W2686 PC Desktop

COMPAQ SPS-BD 1394 Motherboard - replacing microprocessor and memory


I normally ask for more information when people post problems but I can't even be bothered to go through all this driver to get to the root of your problem. Cut out the c**p and give the necessary.\015\012\015\012As a former tech, you should know wha ... Compaq Presario 5000 PC Desktop

Monitor goes blank less than a second after turning on.


If you put bright light at an angle close to lcd can you see a windows shadow, text icons etc, ie still logic power passing,then .... (from a.n. other) after two weeks searching I finally find doctor living stone http://www.aplusperfect.com/articles/ ... Dell E176FP 17" LCD Monitor
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 1.1607 seconds