Having problems with your PC Desktops ?

Fuse 11 93 Bonneville

\015 I have a 93 Bonneville. When fuse 11 is in place there is a beep that will not stop. Did anybody experience this?\015

Answers :

Put your seat belt on and the beep will stop. Also, turn your lights on at night.
Repair Help & Product Troubleshooting for PC Desktops

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Fuse 11 93 Bonneville

Put your seat belt on and the beep will stop. Also, turn your lights on at night. ... PC Desktops

Soyo 17'' Monitor (DYLM017A)(VT17N71), identity of fuse.

Orange color of the ring means number 3. Part of marking also contains "3A" so I'm pretty much sure it is 3 Amps rated fuse. But before replacing it measure the resistance on the PCB where that fuse was blown, between common mask (usually metalized m ... Computer Monitors

No power in Z-5500 logitech speakers

The logitech z 5500 digital is very sensitive to power peaks. One of the most know problems is that the fuse breaks because of these peaks. I´ll show you how to replace the system´s fuse.\015\012\015\012First of all, you just ... Logitech Z-5500 Computer Speakers

The whole system won't turn on

Go to Logitech support and check the faq's on your speakers. You must replace with the same fuse and it may be a 3amp slow blow fuse. If so replace with the same fuse or you will just keep blowing them out. ... Logitech Z-5300 Computer Speakers

Logitech X-530 5.1 speaker set blows internal fuse

Thats because its a 5amp 250Volts. You must have an older model and the beefed up the fuse later in production. mine just blew, unsoldered and about to replace. It states LF.T5AL250V. Hope that helps everyone. Takes about ten minutes to unscrew a goo ... Logitech X-530 Computer Speakers

Fuse in laptop

Normally the fuse rating is stamped on the end caps of the fuse. It would be rated in amps. Just get one that has the same rating and length.\015\012The fuse will be held in place by spring clips that clip on the end caps of the fuse. Look for ... Compaq PC Laptops

Thinkpad T40 will not turn on if the adapter is connected but it will work fine with battery and without power connected. this is happening because by mistake some water was spilled on it, is there any work around to resolve this problem

Yes. One possibility exists for you:If the PSU (whatt you call adapter) has an internal fuse, you can HOPE it burned BEFORE any critical PSU components.1 UNPLUG THE PSU from ANY AC/WALL SOCKET !!!!!.2 Open the PSU, ... IBM ThinkPad T40 2373 Notebook

I am having a ard time finding the right fuse for my MOTU 828 Mk1

Take the original to your local tv repair shop - they will be happy to suppy the correct replacement\015\012there are subtle differences between time lag, slo blow and antisurge fuses so be careful ... Computer Processors

Lost my fuse + fuse cap for altec Lansing 621 during a move, does anyone know a place to get one and part #? I would assume they are still using the same fuse cap and fuse in most their other models so if you've had the same problem but with a different model please do tell, atleast it will give me a lead. I haven't yet hauled the subwoofer to radio shack but given their limited selection I doubt they would have what I'm looking for. Altec Lansing themselves have provided no help. Thanks a lot,

Most fuse holders tend to be STANDARD sizes with regard to mounting holes and fuse sizes\015\012\015\012Your idea of going to radio shack is the best as the ones they stock are also STANDARD and even though you may end up buying the whole ... Altec Lansing 621 Computer Speakers

Have a Dell XPS 200. Computer was on overnight when our power went out and then came back on. It was plugged into a power strip with surge protector. Now it will not turn on, no power, no lights, no fan comes on. It's just dead. Unplugged it, plugged directly into wall, turned the switch on the back of & on. NOTHING. What could cause this? Power supply, mobo? Could the bios battery cause this? Thanks!

Most probably, the fuse in the power supply has been burnt out when the power came back. Surge protectors only protect against voltage surges, not against rise in electric current (Amperes). The fuse inside your computer's power supply protects again ... PC Desktops

Atp3 wont power up why?

There is an internal fuse in the Altec Lansing Speakers ..BUT BE CERTAIN TO DISCONNECT THE POWER LEAD BEFORE MAKING THE FOLLOWING REPAIR.AS IT CAN BE DEADLY!!! \015\012If you remove the larger screws from the back of the unit then remove the to ... Altec Lansing ATP 3W Computer Speakers

VX924 Blown Fuse

What are the symptoms? How do you know the fuse was blown on the monitor you bought? The fuse on vx924 is soldered onto the circuit board. If you have any symptoms that require power its probably not the fuse. T ... ViewSonic VX924 19" LCD Monitor

Won't turn on - PS light on but no PS fan

Surely sounds like the power supply is in need or replacement, or fuse replacement at absolute least.  the fuse that you will be in search of will be located inside of the power supply unit.  Use caution when working inside the power supply ... PC Desktops

Viewsonic VP201b, power light but no menu or picture

Hello,The fuse on the inverter is very small usually small that a grain of rice. It will be labeled F something such as F101 F205 etc. The other thing to look for is blown capacitors, they are anywhere from 1/4 to 1/2 inch in diameter and ... ViewSonic VP201s 20.1" LCD Monitor

How do you restart a nec lcd monitor, had power surge everything but monitor gets power?

The power surge probably blew the fuse inside the tv, first check the fuse inside the mains plug, if that is good then you will have to take the back cover off the tv, you are looking for the power board follow the mains cable into the tv and you wil ... NEC MultiSync 1760NX 17" LCD Monitor

Blown fuse in Subwoofer unit, what amperage to

FOR FUTURE REFERENCE:\012The fuse is a 5 amp 125 volt (250 volt can be used too) slow blow pigtail fuse. Use standard techniques to desolder the old fuse and solder new one into circuit board. Jay is correct, if it blows again, board may be shorted.. ... Logitech X-530 5.1 Channel Speaker System Computer Speakers

PC power supply fuse - T6.3h 250v engraved on end

T = time delay (slow blow)\015\0126.3A = 6.3 Amperes maximum load\015\012H = HRC - high rupture current (as you specified a ceramic fuse)\015\012250V = 250V AC rated\015\012\015\012other letters you may see\015\012 ... Dell PC Desktops

Is it possible to change the electrical fuse ? since this morning the monitor does nor light when i switch on and i presume a fuse has failed

If you mean the fuse in the actually plug then this is easy. Just unplug from the power supply and remove the screws that hold the plug together. You will see the fuse immedatly, Just use a pencil to lift it out and replace it with a new one. As this ... Sony SDM-HX73 17" Flat Panel LCD Monitor

Compaq Armada E500 shut off and won't restart.

The notebook does have an overvoltage and overcurrent protection inside the computer itself. The problem is definitely in your low voltage power supply section of your notebook. Since you do have a multimeter and know how to use it. Take your note ... Compaq Armada E500 Notebook

Cambridge megaworks 250D won't power up.

Yes, Hi there, as junk996 say, check for the FUSE , and carefully see if burn, or something is bad waired, other than this, if you can RMS the unit is better, or with warranty.\015\012If not, check with s tech guru , for open the panel and chec ... Creative Labs MegaWorks THX 250D Computer Speakers

Altec Lansing ada745 fuse

Yes, it's a 1A 250V glass fuse, 0.75" (1.9cm) long. The only other number on the fuse is "239", if that means anything. You take it out by putting a flat screwdriver in the slot on the fuse holder cap, turn counter-clockwise, and pull out once i ... Altec Lansing Multimedia Computer Speakers

Fuse blows after turning on control center

I have a similar problem on the Gigaworks S750 system. Upon opening, I have found that the IC driving the switch mode power supply becomes basically a short, and that the transformer becomes damaged as a result there of as well. Then you have about ... Creative Labs Gigaworks S750 Computer Speakers

When I change the fuse in the z-5500 it

At this point your hands are tied to fix these due to a capacitor failure or whatever. you can try wrapping the fuse in aluminum foil but this may cause even further problems but i have seen it work before. be sure to keep a close eye on these if thi ... Logitech Z-5500 Computer Speakers

Backenlight inverter panel failure formac gallery 1900 oxyg

Mine had the same problem, replaced the fuse with a T2.5 amp. \015\012Ammeter gave a reading of 1.6A across the fuse pads so we shall see if its pops... ... Formac Gallery 1900 Oxygen 19" LCD Monitor


Generally inside there is a fuse on the power board. This fuse is soldered in on the board. Before taking this apart and testing the fuse or replacing power board or inverter, test the power supply to make sure it is producing the correct voltage and ... PC Desktops
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0345 seconds