Having problems with your PC Desktops ?

Wiring Problem with emachines t3624

\015 Color Placing ?\015

Answers :

What windows operating system do you have? More information needed.
Repair Help & Product Troubleshooting for PC Desktops

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Wiring Problem with emachines t3624

What windows operating system do you have? More information needed. ... PC Desktops

Problem with power connections on emachine T2596

Take a peek at this link,http://www.duxcw.com/faq/mb/frontpanel.htmit may assist you in your problem ... eMachines PC Desktops

EMachine no power

Ok for a start the power switch is not green and white that is the power led, you need to look for a red and black wire normally marked on the connector and motherboard as pwrsw or pswitch.\015\012if you believe it to be the switch unplug the c ... E-Machines eMachines Desktop PC

Emachine t1840 wiring diagram power switch wire to mother board ?

Because there are so many different case and motherboard combinations\015\012sometimes it can be difficult following the instructions for connecting\015\012the front panel, USB header and audio header.\015\012\015\012Below is a few generi ... PC Desktops

Emachine t2742 I also have a wiring problem!

Gtater,It's ironic that you ask me this question today-- i am just now carrying in another eMachine computer to fix. Anyway, unfortunately I do not have one that is the same model as yours (T2742). However, I did some quick research and found t ... E-Machines eMachines Desktop PC


I don't see that this problem was solved. Adding additional information.The eMachines T6410 Desktop PC uses an MSI MS-7145 motherboard.(MicroStar International ), ... E-Machines eMachines Desktop PC

T2642 eMachine - does not turn on

... PC Desktops

Emachine t3256 turns on and off --is there a thermal switch ?

Not likely. What IS likely is that your CPU is overheating and is sending a signal causing the system to shut down to prevent damage to it. Pull the side cover off (right side panel as you're facing the rear of the PC, typically 2 screws or a movab ... E-Machines eMachines Desktop PC

Emachines problem... PSU works but comp doesnt turn on

Hi,\015\012I don't want to tell you a color because it could be different than the actual. Look at the front of the computer and trace the wire that goes to the switch and follow it to the mother board. If you have a volt meter you could measure the ... E-Machines eMachines Desktop PC

Emachine 5210 had this machine a few years now , but it has gone off only the fans are running and a yellow light on the front , and no other response or screen coming up , the only way to stop the fan is to pull the plug out , got any sugestions please

Emachines used to use a poor quality power supply made by Bestec, I believe the quality is supposed to have improved in the last few years but inconsidering the number of dead Emachines that wind up in my workshop I doubt it.\015\012The problem ... E-Machines eMachines Desktop PC

Powering up problems.

Try using another monitor that you know works. Then try another video card. The fans are running because the computer is running ---but the monitor is not. Green to Amber means monitor is not on.\015\012A lot can go wrong with loose wires that ... E-Machines eMachines Desktop PC

Bad power supply, installed new one, get green light on mother board; but doesn't boot up. Bad start up button?

Yes, it is my belief that it is the Power On button. To test this, there is a simple solution. I however, would like to caution you at this point.You will have the power supply plugged in. There will be a small spark. I wouldn't advise how to t ... PC Desktops


Hi eakesj:A number of things here should be checked.First shut down and remove all cards, and power connections to all the drives such as cdroms, hard drives. The power supply should also be looked at and tested for correct voltage ... eMachines T6534 PC Desktop

My Samsung LCD TV/Computer Monitor just went deadOnly 14pins/15

It sounds to me like the monitor/TV needs to either be replaced or sent in for repair but there are a few things we can test. \015\012\015\012The first thing would be to set the TV to connect a cable line to the TV and see if you can get ... Samsung SyncMaster 204B 20.1" LCD Monitor

Getting sound with new emachine!!! I am new to all this and for the life of me cant get any sound bought lead for connection but where or what do I do with it?


POWER SUPPLY NOT RUNNING T3065 - E-Machines T3065 PC Desktop

Dead in the water?Power supplies, depending on your demand, can cost you as little as 35 bucks. However, eMachines, power supply physical design is a bit different than most. Here is how you can bench test your supply to rule out any ot ... E-Machines T3065 PC Desktop

On the emachine w3615, there is a red/white & a green/white wire that says ''LED'' - next to it is a black/white wire that says ''power sw''. my question: where does this black/white wire go? i was cleaning out the dust & it came unplugged - now i have lights, but no power.

You have no power on your pc what so ever? those wires are strictly for LED function. if you have no power at all then there's another problem possibly a power supply or a disconnected wire on the mobo ... Gateway PC Desktops

Front Power switch wire is broken

As long as the rating is the same as the power supply you should have no problems\015\012Make sure to check your wiring and all the connections are correct or you could have one expensive paper weight. ... E-Machines T2893 PC Desktop

E-Machine T2862 Will Not Power UP

Regarding the power + power LED +HDD LED connections, if you haven't tossed the unit yet -- looking straight down with the box laying on side (e.g. CPU fan blades pointed straight at you) -- GreenWhite + BlackWhite (start with left pin, row nearest t ... E-Machines T2682 (000002965) PC Desktop

I forgot my bios password. How may I reset it? Is there a standard bios password on an eMachines E520 series?

If you have forgotten your BIOS or system password, there are no software tricks or magical gimmicks that will get the password cleared. Laptops are different in that they are designed to not work with “backdoors” etc. for security reason ... eMachines eMD620-5133 Notebook

No monitor signal and hard drive not spinning? (eMachines T3025)

Wiring diagram? Usually you just plug in the 4 pin molex connector. If its not spinning the HDD is damaged and needs to be replaced.Also I can tell you the Wires are Yellow=12v Black=ground RED=5v and orange=3.3v ... E-Machines T3025 PC Desktop

Emachine W2047 No BIOS Start Screen

You can test the power button. Remove the wires from the power on pins on the motherboard. Momentarily jump the two pins with a small screwdriver. If the computer starts the power button is bad. If it still doesn't start then something else is wrong. ... E-Machines eMachines Desktop PC

My external cabinet fan is not working ;it revolves only in the starting after that it doesn't revolve i changed it's power supply wire also but no use  i think it is having problem with the conducting wires  is their any way to repair it???

Sorry. I see you provided the information, eMachines T2682. Their website does not provide service manuals, but you can ask eMachines if the fan is thermally-controlled by sending them eMail at ... E-Machines T2682 (000002965) PC Desktop

Emachine W3400/ front panel connections

They have to be plugged in horizontally although it is possible to plug them in vertically because the pins are evenly spaced either way. they are color coded just not like you would expect for example one plug has a green wire and a white wire the ... AMD eMachines Desktop System w/ 17'' CRT Display, 2.0 GHz Athlon 64 3000+ (W3400)

I was in the process of updating my Emachine W2888 when I thought about how I was going to put all the wires back in the correct place. I pretty much unplugged all the wires and now have forgotten how to put them back.

You will not have too much problems to get your cables back.The mouse is PS/2 the green one, the violet one PS/2 is the keyboard, the USB could be placed on any port USB, the printer has only one port (LPT1 DB25) big connector if you have and U ... PC Desktops
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.6987 seconds