Having problems with your PC Desktops ?

Computer will not boot up. Box in center reads: No input signal.


Answers :

You are not getting a signal which would suggest you check your power supply first .....next would be hard drive ...
Repair Help & Product Troubleshooting for PC Desktops

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Computer will not boot up. Box in center reads: No input signal.


You are not getting a signal which would suggest you check your power supply first .....next would be hard drive ... ... PC Desktops

Unable to restore computers original factory settings with Dells suggestion of control f11 when computer starts up


If you have already used the cd's to install the os, this will not work. there is another option which you can try.\015\012\015\012Manual Reinstallation\015\012 \015\012Manual reinstallation can be the most time consumi ... PC Desktops

I put the computer on and it says tht an error occured while attempting to read boot it and the error code is 0x000000f and it was my daughters christmas box please can u help.


I'm assuming you have vista installed.If not,please reply and I will update this info.\015\012 \015\012Method 1: Startup Repair from the Windows Recovery Environment (WinRE) ... PC Desktops

Blue box I have been given a flatscreen monitor which on installation has a blue box in the middle of the screen saying "Input signal out of range". How do i remove this?


You need to set the screen resolution or refresh rate of your windows. I am assuming you have XP.\015\012PLEASE READ THE WHOLE OF THIS FIRST, BECAUSE YOU MAY WISH TO DO THE BIT AT THE BOTTOM FIRST, LABELLED 'IF ALL ELSE FAILS'\015\012 ... Relisys TL 766 Monitor

I have just installed a crucial x1600 pro graphics card,when i fired up the computor the monitor displayed multi coloured vertical lines and a box appeared saying it was in analog mode, how do i configure the targa visionary monitor to digital mode. regds A Gough


I'm assuming "it" is the monitor rather than the video card, and that you are using some flavor of windows as your operating system. 1. Digital vs Analog mode is determined by the cable input plug on the monitor that use. Your cable fr ... PC Desktops

I have a 24" acer monitor that I was setting the display settings via computer, wwhen a box appeared in middle of screen(rest is black) and it read"input signal out of range, please selcet 1920x1200x 60hz for best performance. The problem is that now nothing works on monitor. I have tuned it off, along with computer, thinking it may reset, checke the cables, reattached them, tried different monitor(which is working fine) I am at a loss what to do. Help!!


Your screen resolution is set incorrectly, boot up in either safe mode or VGA mode and change it from there. ... Computer Monitors

Inout signal out of range Answer Failed: retry


It shows out of range because the PC is sending out the video signal that is higher than the monitor can display, you need to set the PC video resolution to the native resolution: 1024 x 768 @60Hz. You can reboot the PC into save mode (hitting F8 key ... IBM ThinkVision L151 15" LCD Monitor

No display on SyncMaster 710N


I used 2 resistor of 100 ohms (1/8W) to make one of 50 ohms. Like others instruction, just put the 50 ohms resistor between pins 5 and 6 of this chip and the problem is solved. ... Samsung SyncMaster 710N 17" LCD Monitor

I have an e-machine w 3052. When I turn it on my screen comes on then microsoft's privacy center box pops up with all it's boxes reading privacy violations, virus alerts, and registry doctor reads system crash and then it start scan. Finally a gray box pops up reading not enough storage to process. It will not fix or cancel. It stops and then disappears. The screen saver stays but there is nothing on it. I can go to safe mode but cannot connect to internet even when clicking on safe mode with in


Insert disc 1 into the cdrom drive and restart your computer.\015\012Watch the boot screen for the option to boot to cd or to select boot options. \015\012\015\012If onscreen boot options are not available. Enter your bios setup and ... E-Machines W3052 PC Desktop

We r having a problem with a software we purchased from shockwave. The game is called saints and sinners bowling The graphics flash and when u roll the ball u only c the result u don't c the ball rolling down the lane. My computer is far less advanced that my dads computer and this game works fine on mine. One other thing, is the game works fine for several hours after I reset the computer then lets say when I shut the game off for a few hours it does the same thing. I have thought about resetti


Hello, Jason.If your problem began after Windows XP SP3 was installed, I'd suggest using System Restore to roll back your system to an earlier time. Go to Start - Programs - Accessories - System Restore.You had mentioned Facto ... Gateway GM5088 PC Desktop

I have a Dell Inspirion 1525, All of my wireless connections and signals are good and working fine. I get signal from the router on my home computer. But it will not do anything internet related. When opening Explorer, the diognostics says The Domain Server may be down. Can anyone translate?


This is quite a long reply and may appear very technical - however, have a read through and see what you can do / answer \015\012\015\012| |All of my wireless connections and signals are good and working fine.||I will assume by this you m ... Dell Inspiron 1525 Notebook

"No signal detected" when LCD connected with DVI-D Cable


Thank you for providing your configuration details.\015\012You have failed to specify wheather or not your LCD Display is under Warrenty.\015\012\015\012Perhaps these simple trouble shooting procedures will get the job done.\0 ... BenQ FP71E 17" LCD Monitor

Missing NTLDR file


The first thing to do is try to change back whatever hardware or software change you just made (this could be as simple as leaving a floppy disk in the drive or you need to reseat the IDE cables). If the contents of the drive are especially important ... ASUS Eee PC 2G Surf Notebook

Get dish network to work with hp SR5505F COMPAQ PRESARIO COMPUTER


You can not change channels on Satellite with your TV tuner card. The satellite box decodes the sat signal (it is sent encrypted) you can run S-Video/RCA/HDMI depending on the video card input, but you will be required to change the channel on the Di ... HP PC Desktops

Dell 5650 speaker wire adapter


As I understand it, this adapter is used ONLY to adapt a standard 2-channel stereo output to the 3, 1/8" plugs of the Dell 5650 5.1 system. These 3 plugs would normally plug into the front, rear, and center/sub outputs on a computer designed to outpu ... Dell 5650 Computer Speakers

Driver needed for TSST Corp CDDVDW TS-H653N SCSI CdRom Device please. DVD drive shown in My Computer, and MS says I have the correct driver for this device. But, it doesn't work.


If the computer still cannot read a disc, there may be a problem with the drive. Go to method 3 to troubleshoot the CD or DVD drive.\015\012If the computer can read the other disc, there is a problem with original CD or DVD. Contact the manufacturer ... Compaq PC Desktops

I was tring to Connect Two Computers to One Monitor, but i didnt get it, does someone know how to do so? I bought a KVM switch, USB to use between a new Acer running Win XP and old Dell with Win 98. Could not get the Dell to show up on the monitor, although the correct light shows up on the KVM and the USB mouse lights up when the computer boots. -- Read a few minutes ago about a source switch and found that my flat panel has a menu item to switch from analog to digital input. Could that be the


I guessing that since **-one responded you've given up and returned the whole mess but what the hey.A lot depends on the KVM you're using. There are some high end units that will match different sources to the monitor but most work best ... AOC 19LVWK LCD Monitor

Does my inspiron b130 laptop support s video output to my tv? I would like to find an adaptor from the 15 hole jack to an s video plug so that I can hook the laptop to a tv with an S video outlet. Do you know of anything like that?


Hi \015\012\015\012\015\012You need a vga to RCA/SVideo conversion adapter.You do not have to install any driver to use S-video port. Connect the S-Video cable to the back of your TV and turn it on. Using TV remote ... Dell Inspiron 9300 PC Notebook

I have just set up new desktop Acer. Error message: No input signal.


Check the website for drivers. But it seems to me that there is another problem most computer boot up no matter what screen is hook up. have you tried any other monitors ? If you have and the work im not sure what your issue is but i would say that ... Acer Aspire™ T180 PC Desktop

Start up problem


I've checked your media center model on the net and it appears to be a known BIOS problem. Keep in mind that this is most likely video card or motherboard failure. But we can try resetting it\015\012Try booting into the BIOS using the F10 key and the ... HP Media Center m7060n PC Desktop

I want to reeboot my windows xp - Dell Inspiron 6000 Notebook


That is both EASY and FUN!.... if you have all your stuff.Before you do ANYTHING. Make sure you have all your discs. You need the Operating system disc (usually green or purple, says DELL on it). And you need your DRIVER DISCS. (usually b ... Dell Inspiron 6000 Notebook

Signal out of range


1: Signal out of range meas the monitor can't handle the input refresh rate. lcd and Tft monitors usually supports 60 and 75Hz refresh rates.2: The Resolution you are using to view the desktop is too high, this number is depending on the size o ... Kogi L7CH Monitor

Toshiba Qosmio g15 av501 Bios password lost


This information is intended for experienced users. It is not intended for basic users, hackers, or computer thieves. Please do not try any of following procedures if you are not familiar with computer hardware. I'll not be responsible for the use or ... Toshiba G15-AV501 Qosmio Notebook

Cannot get Toshiba Netbook connected to wireless network


Ok. try this:\015\012open a computer on your network that connects to the network. start -> run -> type cmd and click enter.\015\012then type ipconfig /all\015\012then open your laptop.. go to local area connection and click p ... Toshiba Mini NB205-N313/P Netbook

My E drive is not working. how can i fix it. - HP Pavilion dv9000z Notebook


Have you tried cleaning the laser assembly? If your OS still sees the drive then it may just be having trouble reading.\012Try thisFirst try to boot from your xp cd. If it fails to boot from the cd then your drive is screwed. If it ... HP Pavilion dv9000z Notebook
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.9915 seconds