Having problems with your PC Desktops ?

I dont know where the wires go for the power switch, not labled on mother board.gateway emachine T3828


Answers :

It should be labelled on the motherboard yes near the small pins, I think 2 pins, look closely the writing is very small, near the reset switch, should say power or something along them lines
Repair Help & Product Troubleshooting for PC Desktops

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My emachines T3828 will not power up. I changed the power supply, but that didn't help. my next suspect was the power switch. I found that the wires wer a little loose. Thinking that the power switch wires were one unit, I pulled them. Imagine my surprise when I saw that they wer actuall three seperate wires, One black and white, One blue and wdhite, and one red and white. I need to know how to reconnect them, and in which order. I also noticed that a green light comes on. I assume this is for t


Hello there,The green light on the motherboard is there to indicate that you are in fact getting power to the board, which is good. The wires you refer to are in fact the power switch, reset switch, and probably some type of ... E-Machines T2742 PC Desktop

I dont know where the wires go for the power switch, not labled on mother board.gateway emachine T3828


It should be labelled on the motherboard yes near the small pins, I think 2 pins, look closely the writing is very small, near the reset switch, should say power or something along them lines ... PC Desktops

Computer Case ULT33180 Powers down about 4 seconds after started


Ive done something similar, I took the CMOS battery off the motherboard and put it back in after about a minute to reset the bios. Unplugged the power supply from the motherboard and flipped the power switch on the back of the power supply (on and o ... PSA E-Torque (ULT33180)

Emachine t1840 wiring diagram power switch wire to mother board ?


Because there are so many different case and motherboard combinations\015\012sometimes it can be difficult following the instructions for connecting\015\012the front panel, USB header and audio header.\015\012\015\012Below is a few generi ... PC Desktops

Installed an Upgrated Mother Brd,in my Hp Desktop Tower,but the power Switch receptacle in the New Mother Brd has 16 pns


You need to track the wires from the case front panel to thier locations: one will be your power switch, one your reset, one hard drive activity light, and one your power light. You want to note and label which light or switch they go to then go to t ... PC Desktops

EMachine no power


Ok for a start the power switch is not green and white that is the power led, you need to look for a red and black wire normally marked on the connector and motherboard as pwrsw or pswitch.\015\012if you believe it to be the switch unplug the c ... E-Machines eMachines Desktop PC

T2958 motherboard connections


Guest Solution #5You are also an apprentice speller I see. I'll never know how you can just go online and display your illiteracy like that. Five spelling errors in one sentence. Didn't go to school or didn't pay attention did you? How can ... E-Machines (T2958) PC Desktop

Need where pwr sw and pwr led and hdd led plug onto au31 motherboard


FIC AU31 mb (a.k.a K7m-NF18G mb)Pin Configuration = PinoutThe Front plastic panel of the computer is the Front Panel.The area of pins on the motherboard that the cables (Wires) go to, is the Front Panel header.Front Panel head ... E-Machines T3092 PC Desktop

Had to replace power switch on emachine computer need to know where wires go


I'd like you to look at this motherboard, and compare it to yours. It's an Intel Seabreeze T3 motherboard. My data states it was used in many computers, and the eMachines T3830 being one of them. ... E-Machines eMachines T3830 PC Desktop

Emachines problem... PSU works but comp doesnt turn on


Hi,\015\012I don't want to tell you a color because it could be different than the actual. Look at the front of the computer and trace the wire that goes to the switch and follow it to the mother board. If you have a volt meter you could measure the ... E-Machines eMachines Desktop PC

Pinout on t6410 gATEWAY CONNECTING POWER BUTTON


I don't see that this problem was solved. Adding additional information.The eMachines T6410 Desktop PC uses an MSI MS-7145 motherboard.(MicroStar International ), ... E-Machines eMachines Desktop PC

My computer wont turn on


Take out the psu completely from the cpu/tower, plug in the power cord,if there is a switch on the psu turn it on, next locate the main power connector (24pin) and find green wire,take a piece of wire and insert it into the green wire connector,next ... PC Desktops

Front panel leads Emachine model T2862


E-machine model T2862 pin-out for the 10-pin front panel header is screen-printed on my Emachine's motherboard, but is so small and far away from the actual pin location, that it is likely being overlooked. If looking into the computer case from the ... PC Desktops

Removed monitor for cleaning


Unsoldered the master power switch and the reverse scan button (micro switchs) from the mother board and traded each others place, (the reverse scan switch into with the master power switchposition and vice versa.) Allowed the two confused wires to h ... Toshiba Satellite A135-S4427 Notebook

Emachine D2880 no power clarification


Your getting power to your PSU, via the green light on your mobo. \015\012verify the PSU has a green light(most emachines do) \015\012it sort of sounds stupid but, check the connection of the cable coming from the front of the case(the wi ... E-Machines eMachines Desktop PC

E-Machine T2862 Will Not Power UP


Regarding the power + power LED +HDD LED connections, if you haven't tossed the unit yet -- looking straight down with the box laying on side (e.g. CPU fan blades pointed straight at you) -- GreenWhite + BlackWhite (start with left pin, row nearest t ... E-Machines T2682 (000002965) PC Desktop

NO POWER TO THE MOTHER BOARD OF MY EMACHINE


The Wires goes on the motherboard, check your motherboard manual for reference ... E-Machines eMachines T3830 PC Desktop

Bad power supply, installed new one, get green light on mother board; but doesn't boot up. Bad start up button?


Yes, it is my belief that it is the Power On button. To test this, there is a simple solution. I however, would like to caution you at this point.You will have the power supply plugged in. There will be a small spark. I wouldn't advise how to t ... PC Desktops

TRYING TO HOOK UP MU POWER BUTTON NEED TO KNOW


Hi there\015\012The front panel connectors are\015\012 mainly,\015\012\015\012\015\012\015\012\015\012harddisk activity connector\015\012power switch connector\015\012 ... eMachines T6420 PC Desktop

My Gateway 7330 works now, but the power button doesn't


If you go to where the start button connects to the computer mother board and disconnect it. YOu can put a screwdriver across the two spikes coming from the board and it should start. That wil confirm that it is not a board problem.Next get a small b ... Gateway 7330GZ Notebook

Reconnecting power swith, LED light for power and hard drives on emachine


Yes that is true if you look at your wires ahnd you will see that one says hdd and one says spkr and so on now look closley at the board and you will see the same thing on the moboard if you are not abloe to read it you should be able to go ... E-Machines eMachines Desktop PC

I have a VPR Matrix model 2250 since new. I was vacuuming the inside of it and all circuit boards and accidently knocked the connection cable loose on the mother board which goes from the start push button to the mother board and I'm not real sure which pins the cable connector goes to. Do you have information on this?


No, VPR Matrix doesn't show information. http://www.vprmatrix.com/products_desktop_2250.aspThat's okay though. I would like you to take a flashlight, and view the motherboard closely. I need to know who made the motherboard, a ... Matrix PC Desktops

Wiring a P4M80-M4 mother board


You can download the manual for the motherboard here, just click on the "manual" link:http://www.biostar.com.tw/app/en-us/mb/driver.php?S_ID=246This will list the front panel connections, which are 2 pins. Each of the jumpers ... PC Desktops

Wireless button won't switch to on and i can't access web wirelessly. how to i repair this


Their is a possibility that your laptop went into a low power state, and someone accidentally switched the wireless switch off physically then powered back on. if this is the case the issue would be the laptop had a image of the files and how they we ... PC Laptops

I got an emachines w3650 it wont power on i don't know really anything about computers but i opened the side of it to look in side and saw a wire with P6 written on it hanging and not plugged into anything. should that be plugged in to something? could that be y the comp wont turn on? any ideas or suggestions i would appreciate


In the most basic system setup the power supply will have two wires power the motherboard, one for the CD/DVD drive, and one for the hard drive. there will be extra ones for future upgrades...i.e.2nd hard drive/DVD burner and so on.... On my PC there ... PC Desktops
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 1.1658 seconds