Having problems with your PC Desktops ?

Hi all i have lg lcd monitor L1720B turns on (blue led) after two seconds it goes to power save mode (yellow led) all signal video from pc are ok pleas help!!! thanks ron

Answers :

Sounds like the monitor expired :((
Repair Help & Product Troubleshooting for PC Desktops

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

LCD Flatron 21inch going into power save mode problem

This is not a problem with the monitor, it looks as your computer is not sending any video signals to the monitor thus it goes into saving mode. Take a look at the computer, check the video card. Pull it out then turn it on, turn it off again and pla ... LG 22" FLATRON LCD Monitor

I have a dell demension 4300 that recently started having issues, slow cutain effect, freeze ups. harddrive clicking away. Then one day I had the blue screen that said an error was detected. Then it wouldn't reconize the harddrive but it would go into the bios screen and then not do anything else. So I took it in to have it diagnosed and they said the edie circuit on the board was fried. They offered me a card option for the back but I opted to replace the motherboard with one that was listed as

CaSmogTech,There is a No Signal on the monitor because the monitor is not receiving a Video Signal.Your computer is not producing a video signal.In essence, your computer isn't working, because there is no Operating System on ... Dell Dimension 4300 PC Desktop

Computer monitor comes on for 1 seconds, flashes "analog power save mode" and then goes black.

Most monitors will say "Power save mode" when they can tell through residual voltage that the signal lead is plugged into a machine, but there's no picture being transmitted. The four states of a monitor are:* Off entirely.* Switch ... PC Desktops

All of the sudden, no picture vis DVI interface.

... Dell UltraSharp 2407WFP 24" LCD Monitor

Gateway LCD powers on but has no picture

I have a Gateway FPD1730 LCD monitor. When I plug it into my Gateway 500x desktop the power light turns green and then says "Power Saving Mode" and then it goes black. It will occasionally flash on and have a picture and then go off. When I unplug th ... Sceptre X9G Komodo IV 19" Flat Panel LCD Monitor

Desktop monitor port not working. processor, keyboard, mouse all powered on & working, you can hear it boot up. I use this with other computers, it works fine. monitor has power but goes to sleep. Is there another way to connect monitor with a different adapter, as usb port or to serial port?

Ha, no kidding! I just had a HP Pavilion a705w come in for repair at my shop!Small world.Okay, let's go with your theory that the power supply is okay, and the Processor is indeed operating.Your theory is that the ... PC Desktops

LG LCD Monitor won't exit Power Saving Mode

Does your desktop/PC display show anything before the monitor goes into power save mode? If nothing comes up, its possible that you have a loose VGA connection or that your video card/ ... LG Computer Monitors

HP desktop monitor problem

Hi try this ,,,\015\012\015\012\015\012Ensure the video cable is connected (and connected to the correct video port).\015\012\015\012Turn off the monitor using the monitor's power button and then restart th ... HP Pavilion a305w (DM181AR) PC Desktop

When I turn boot up my gt5220 the monitor briefly flashes and then goes into power saving mode- desktop stays on, fans running and all, until turned off by holding power button down or unplugging it.... my gateway 820GM started doing the same thing, monitor just going into power saving mode.... but the monitor is fine, works on a dell desktop, and the dell monitor works on my gateway- so does an older EV700 monitor....WTF??? video card? motherboard? driver update? power source? heard 15 differen

In this case if you monitor say no input or no signal it means the\015\012monitor connector cord are not connected properly to the motherboard.\015\012Or if you have a video card you need to plug your monitor connector to\015\012the video card. Becau ... Gateway GT5220 PC Desktop

Computer screen goes into "digital power saving mode"

You should be able to adjust the settings on the monitor to prevent it from going into power save mode, or at least to delay how long it takes before it goes into power save mode. Press the menu button and look for settings that might disable or chan ... LG L1915S 19" LCD Monitor

Screen goes to sleep after "no signal" message

If you do not move the mouse or press any key on the keyboard it could be just going into video power save. Confirm it by moving the mouse or pressing a key on the keyboard. If the monitor comes back on, adjust the power settings in control panel a ... ViewSonic VA1930WM LCD Monitor

In power save mode

The monitor is not receiving signal from the computer. Is the power light on on the computer? If so - press and hold power button on computer until the power light goes off, then press again to restart. If the computer starts and you still have no ... Dell E173FP 17" LCD Monitor

NO SIGNAL What do I do?

These messages are normal when the computer truly goes into suspend mode or loses the video signal (such as when the computer is suddenly turned off).If the monitor displays any of these messages when the computer should be displaying vid ... HP PAVILION A6230N DESKTOP PC

LG LCD monitor goes in power saving mode

That means theres no signal coming from the PC. either the PC is not booting up or the VGA coard is faulty. ... LG L1915S 19" LCD Monitor

Hi all i have lg lcd monitor L1720B turns on (blue led) after two seconds it goes to power save mode (yellow led) all signal video from pc are ok pleas help!!! thanks ron

Sounds like the monitor expired :(( ... PC Desktops

I have the same problem!

Hi Robert,\015\012\015\012The monitor is on protect mode because an internal fault had been detected.\015\012\015\012To start unplug monitor from power and from computer and test computer with different monitor to find out if it is ... Microtek C893 18.1" Flat Panel LCD Monitor

On my 997sd lcd the screen after about a second goes blk but the power light stays on also stays on on the power cord when unplug and plug back in again stays on for a second then goes blk

It may be going into power save mode or its not getting a signal from your comp.\015\012\015\012Check this by using the monitor control menu on the monitor.\015\012\015\012Does it give you a message at all?\015\012 ... PC Desktops

LG 2542T goes dark after showing "analog power saving mode" message

If it is saying analog signal power saving... I am wondering do you have it hooked into you computer with the white DVI cable?Is there an option on your monitor to switch modes? Analog-Digital? If you are using the white DVI cable to hoo ... LG L1717S-BN 17" LCD Monitor

Laptop to tv

\012Right, well, IF your TV has a DB15 Female Plug on it then you CAN, connect it up and it will work, as a second "Monitor". OR If the laptop, has a "Composite Video" a Yellow RCA socket, then you ... Acer Aspire 5500 5570-2609 Laptop

LG screen goes in stand by. I was using two monitors for several months, everything OK, now I decided to get a new LG Flatron instead of one of the monitors... and only this one goes in safe mode!! Two screens plugged in: Philips analogical working fine no problems. New LG Flatron digital goes in power save mode after few minutes Tried to plug in ONLY the LG, same problem after few minutes. Philips monitor no problems. So it HAS to be a screen function or problem of the LG? Computer: AMD + 3Ghz

Oke having a similar problem atm, this is what i have found so far. was trying to help a friend who has bought the same 19" LG monitor. When i connected the monitor to her PC i noticed that it was not the same connection as the previous one but it ha ... LG 19" Widescreen Flat Panel LCD Monitor

Flatron W2252TQ goes into 'power saving mode'

I had a similar problem with an LG monitor that I resolved by connecting the analogue cable as well as the digital cable from the pc. This problem must be caused by the monitor not receiving a digital signal. ... LG W2252TQ Monitor

When i turn my monitor on my monitor goes into power save why

It might very well be an issue with the new PC's video hardware. If the monitor gets no signal within the first few minutes then it will automatically go into power save mode. Also, just as a troubleshooting idea, recheck the vga/dvi connection on ... Rosewill R900J 19" Flat Panel LCD Monitor

LG Flatron - Power button flashing blue

I get a similar thing, i accidently entered sleep mode then turned off my computer at the power button on the back, now i turn on my monitor( i dont get blue flasjhing but it jsut goes on and it doesnt register, then says going into power saving mode ... Computer Monitors

Power light steady green but monitor goes dark after 4 secs of video

... NEC MultiSync LCD1770V - Flat panel display - TFT - 17" - 1280 x 1024 / 75 Hz - 0.264 mm - VGA (... Monitor

I have a lcd 195vxm hooked up to a laptop because the laptop screen failed. It has been working fine for several months, but now it comes on and says "video signal 1 dsub no signal". That is the same message it has always said, but now it just goes back into standby mode (yellow light on power button) and won't stay in active mode. I have rebooted, unplugged for a few minutes, but it hasn't helped.

Go to safe mode and decrease the screen resolution,if still doesn't help go to safe mode again then go to system restore under system tools, restore back to early good restor point ... NEC PC Desktops
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 1.0480 seconds