Having problems with your PC Desktops ?

I need jumper settings for samsung hd080hg/j drive

Answers :

Setting the order of the hard disk drive (Master, Slave) \015\012\015\012\011\011\011\011\015\012Jumper Location\015\012\011\011\011\011\015\012\011\011\011\011\015\012\015\012\011\011\011\011\011\015\012\011\011\011\011\011\011There are three cases of the installing jumper(shunt) if the jumper is located in the middle of connectors as above.
\015\012\011\011\011\011\011\011They are Lower 32GB, Upper 32GB and With capacity limitation in upper 32GB.



Repair Help & Product Troubleshooting for PC Desktops

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

New HDD Install Prob

Basic Troubleshooting Tips after Installing a New Hard DriveBased on Seagate IDE hard drives.If you have installed your drive and it does not function properly, perform the following basic checks:Additional Troubleshooting Tip ... PC Desktops

Dell Dimension 2400 - Adding second HD

I presume that the hard drives are ATA drives, and if the WD and Maxtor are installed on the same IDE cable then the boot drive, the WD HD needs to have the jumper set to Master or Master with Slave drive, and the Maxtor needs the jumper set to Slave ... Dell Dimension 2400 PC Desktop

How do you set a samsung ide hd to master mode

Hello arrowllc\015\012\015\012That will depend on (1) the model hard disk drive (HDD) and (2) whether or not the HDD is the only drive on that IDE channel.\015\012\015\012If you'd still l ... PC Desktops

Installation of a 2nd hard drive steps & tips

Step 1: Back up and scout around\015\012 First,\015\012back up your critical files (don't forget your Outlook .PST archive) to\015\012optical discs, an external drive, or online storage. Then check whether\015\012a CD comes with t ... HP Pavilion a1410n (ER890AA) PC Desktop

Hard drive problem

Although I covered most of the ways to speed up Windows boot time in another article, I encountered a unique roadblock recently that made me write this article. During the last week I was asked by a customer to upgrade one of their office ... PC Desktops

Swap two hard drives

Jumpers on disk drives are the little plastic squares fitted over metal pegs back near where the IDE connection is made on the drive. Sometimes, an abscence of a jumper implies a certain setting. To change the jumper settings, you physically move t ... IBM ThinkPad T22 2647 Notebook

DVD drive How do you change out the DVD drive in a northgate pc?

This is a pretty simple procedure, and is basically the same for any desktop pc. Firstly you need to open the case, MAKE SURE THE POWER IS OFF, find the DVD drive you want to take out, it should have 2 screws on either side or clips. disconnect the r ... Northgate (STAX2517C2) PC Desktop

Dell Poweredge 4300 Bootup problem after cmos battery replacement

Check the version for the Raid Controller. This may need to have the firmware to be upgraded. If the controller is removable, take the controller out and then see if the computer will continue past the bios. If the controller is built-in, then disabl ... PC Desktops

Installed a new Optical Drive and require assistance in the wiring

What kind of optical drive? Is this a CD, DVD?, Blue ray,or an opto-ferro-magnetic floppy?Generally:1) External drive: ============ a) just power it up and connect it to the PC using an USB or ... PC Desktops

I have a dell 4600 that I got from my daughter . which I had to re-install and It has a password in the bios for the set up and my daughter dont know

\015\012 \015\012Hi katmbutts;\015\012 \015\012 \015\012Before attempting to bypass the BIOS password on a computer, please take a minute to contact the hardware ... Dell Dimension 4600 PC Desktop

HP m7060n Media Center PC had boot problem: now won't display any

Lets try to repair it using the windows installation disc. First things first, look at the motherboard down on the right lower side. I would like you to find the CMOS jumper, it will be three pins sticking up with a plastic jumper made of plastic fit ... HP Media Center m7060n PC Desktop

When two drives are connecting cd or dvd it detects only one.

If they are IDE drives, then you need to set the jumpers on the rear of the drives. You should set one to master and the other to slave. ... ASUS PC Desktops


Be sure that SATA is enabled in your BIOS settings. Sometimes if the\015\012computer ships with an IDE drive, the company that builds them will\015\012disable SATA in the BIOS. Also, while you are in your BIOS, if you decide to use just the SATA driv ... E-Machines eMachines Refurbished EMA MSI-6741 W/1394 eMachines (100891) PC Desktop

My Motherboard wont recognize my Hard Drive

Is it Sata or IDE?.Also is your boot order set to the CD rom as the first device.The O.S is bootable only if the CD runs it first. Windows should format it later in the install process. ... PC Desktops

Forgotten motherboard password of dell laptop model pp01l and system no. 7HYDT1-595B

Daustie, you don't read much, do you? What betenikomila is looking for \012an answer to is the BIOS/CMOS password, not the windows pass as you \012misguidedly offered bad advice to fixing.What is needed is to do a \012procedure called "clearing ... Dell Latitude C640 Notebook

Dell xps m1530 formatted hdd now it wont boot

You might find part of this general trouble shooting process might help? Especially the part of changing you Primary Boot drive so you can load Windows.\012\012Assuming you are Windows based and not knowing your specific OS? \012 Your p ... Dell XPS M1530 Laptop

I bought the samsung 250gb hard drive and it wont boot up

Hello johnfogert,1. First make sure that your motherboard supports a 250Gb hard disk. 2. Make sure that the drive is properly connected to the mother board and the jumper settings are set to Primary.3. In the BIOS ... PC Desktops

Dvd rom won't work

You forgot to check the jumper settings of the Hard Disk and the DVD Drive found at the back near the IDE and power cables. If you are using one IDE cable, then one jumper should be a Master, that's the Harddisk, and the DVD drive a Slave. If you are ... Compaq Presario 5000 PC Desktop

Cannot Boot up Computer: sends me to the bio screens

I presume you know how to get into the BIOS, but you don't say if this is a new drive being replaced or a second drive being added etc., but I'm guessing that you don't have the drive configured correctly. There are three jumper positions on most ... Sony VAIO PCV-RS530G PC Desktop


If this drive is only for storage it can be set as a slave drive. If it will have the OS installed and will be the boot drive it has to be set as master. Set the jumpers accordingly. If a different drive is the master you might check the jumpers on t ... PC Desktops

How to install a second dvd player in my compaq

The computer needs to be opened up to properly install the CD or DVD drive into the computer. The method for opening the case will vary depending upon the case. Most new systems will use a panel or door on the side of the system while older systems m ... Compaq PC Desktops

Have rs480m motherboard need the 2pin sequence to hook up the hard drive ''e-machine t6520''

I assume you are looking to connect another hard drive in your computer.\015\012Most desktop computers have two IDE controllers.\015\012The 1st controller will have the "C" drive set to Master (MA) and there maybe another drive CD or DVD ... E-Machines T6520 PC Desktop

Need jumper diagram for motherboard

Hi,Check that the hard drive is set to "slave" on the jumper settings where you connect it (if it's IDE). Also, check the boot order in the BIOS (or setup as it may be called when booting up) to make sure that they computer's not trying t ... Dell OptiPlex GX520 PC Desktop

I want to put in an additional dvd-rom drive in my desktop in the expansion slot. Do I need software for this. I have a Phillips dvd-rom drive from my old desktop..year 2005? thanks

Windows xp vista or W7 should auto install any drivers needed for DVD/CD playersthe one thing you will need to, if you keep your existing drive when adding the additional drive is set one to slave and one as master.At th ... Gateway GT5220 PC Desktop

Im looking for the jumper settings on a compaq motherboared. its a presario 7478

Hello CAVdesert, I don't think you ever have to change the jumper settings on the motherboard.You may need to change in few cases but otherwise, changing motherboard jumper settings is not recommended. However, if you need to configure th ... Compaq PC Desktops
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.8461 seconds