Having problems with your Computer Monitors ?

I recently plugged in second monitor and set in display mode to extend desktop. My second monitor is cacthing some sort of signal due to the green light on it but the screen stays black. why?


Answers :

You need to go to xp screen settings and set a resolution on your screen + you need to mark extended screen
Repair Help & Product Troubleshooting for Computer Monitors

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

ViewSonic VX922 monitor - black screen - green power light flashes


PLEASE read Carefully so here is a fix for the green blinking light ...the monitor is going into shutdown....protect mode......THIS is ...Only for the seasoned electronic service tech ......YOU NEED TO BE into Electronics ..or have electronic backgro ... ViewSonic VX922 19" Monitor Flat Panel

Monitor sleeps after one second


... AcerView F51 15 in. Flat Panel LCD Monitor

Microtek 997M monitor doesn't stay on...


The inverter is the most common item to fail on a LCd monitor. Capacitors usally fail the most. Are the tops of any of them popped up. If you had any shorted transistors the fuse would probably be blown. Usally labeled F1. I would replace all the cap ... Computer Monitors

Computer monitor flashes on then turns off


Try the monitor with another computer. If it works, the video circuitry (whether it is on-board or a separate adapter) in the Gateway is the problem and needs to be replaced. Otherwise, the problem is with the monitor itself. From your description ... Computer Monitors

Monitor comes on, I can see everything perfect then goes black


"Most" newer monitors will let you know if the are no longer receiving a signal. Sounds like the backlight is burnt out. Try getting a bright (LED works best) flashlight and shining it at the screen at all angles to see if you can see any of what you ... Westinghouse L2046NV Monitor

Lcd monitor power light flashing with no img. seems 2 be frozen


The display is in safe mode and you will need to reset the display to get the display out of the safe mode. There are 2 different model revisions. Please choose the method that will match your revision. Depending on the revision of the monitor, one ... Planar PL1910M (Black) 19 in. Flat Panel LCD Monitor

Screen Not Staying On


Hi TontBrowne,\015\012\015\012I'm not sure exactly what causes this problem. However it seems that lowering the 'Brightness' and 'Contrast' fixes things. The problem is, you can't see the menu without the backlight. However, try this, as ... Dell Dimension 4600 PC Desktop

I recently plugged in second monitor and set in display mode to extend desktop. My second monitor is cacthing some sort of signal due to the green light on it but the screen stays black. why?


You need to go to xp screen settings and set a resolution on your screen + you need to mark extended screen ... Computer Monitors

Powering up problems.


Try using another monitor that you know works. Then try another video card. The fans are running because the computer is running ---but the monitor is not. Green to Amber means monitor is not on.\015\012A lot can go wrong with loose wires that ... E-Machines eMachines Desktop PC

ACER AL1914 LCD Monitor goes black but green light stays on


The monitor is doing a self test a finding an error.\015\012The lcd has three parts, the screen plate(windows)/the logic(vga)/the\015\012inverter(power plug). Parts that go are the backlight ccfl's, behind\015\012the plate, and parts of the inv ... Acer AL1914 19" LCD Monitor

Monitor goes black but the green light stays on. I turn the power button off and then back on and it comes back on. It may stay on for a few seconds to several minutes.


Check to see if the image is Dimmed. Chances are the power supply on the FPD is either dead or not supplying power to the back lights.\015\012Your problem is the back lights are not being powered. There is a signal going to your FPD becau ... PC Desktops

Monitor goes black, green light stays on.


How do I change the backlight ... Dell E173FP 17" LCD Flat Panel Monitor

LG StudioWorks 700s Monitor NO SIGNAL


First of all I would check your video card. Do you have another monitor that works fine? If so I would hook the good monitor to your video card and see if you are getting a signal. If you still do not have a signal in the good monitor there is someth ... LG Studioworks 700S 17" CRT Monitor

SDM-HS73P Screen Flashes


This is a problem I have seen with a few LG monitors.\015\012Your Inverter circuit is fine (that powers the lights to your screen so you can see the image on the LCD panel) but the monitor does not like having a video signal attached to it. ... Sony SDM-HS73P 17" LCD Monitor

Screen stays blank


I'm seeing the same problem as the original poster. that delaying the power-on helps, seems to be related to the video mode - it fails in the vga text mode the bios boots up with, but works fine with the later activated graphics mode. switching to te ... iiyama Vision Master Pro 450 Monitor

My monitor comes on for one second then goes black. The green light stays on the whole time.


Check the cables, make sure it is secure on both ends. Also see if you pull up the Monitors on screen menu.As long as the light is green, that means there is a signal. it could be a bad monitor. Shut off all the lights in the room, then g ... PC Desktops

Proview Monitor Blank display after 3 seconds issue


First place to look will be the power supply section, look for bad caps (bulging tops or bottom seals), the post back what you see so we can guide you further for direction such as voltage checking, see example of failed monitors due to bead caps: ... Xerox XG-91D 19" LCD Monitor

StudioWorks 700s Monitor No Signal


It could be that the resolution settings that you had with the old monitor are not compatible with the new monitor. Try hooking up your old monitor and either lowering or highering the resolution and see if that corrects the problem. Can you give ... Proview PL926WBi 19" LCD Monitor

StudioWorks 700s Monitor No Signal


Try to connect the monitor to a different desktop/laptop, to see if it works at all.\012\012Try a different monitor on your computer, to see if the video-card in your computer is the problem.\012\012Or, spend $50 to $100 to bu ... Computer Monitors

Second monitor is black


Simply hooked up to my onboardchipset and my graphics card. Should have tryed it sooner. Thankyou for all your help ... Dell Computer Monitors

I moved my computer to another room and now the monitor won't work. When I turn the computer on, the light turns green on the monitor for about 2 seconds then goes to orange and the screen stays black. If I unplug the blue cable, the light turns green and the screen displays no signal. Can you help me please?


On the back of your computer do you have 2 vga connections? 1 will be onboard and the second if you have it will be a graphics card, could you have plugged your vga into your onboard when you have a graphics card plugged in? if so youll need to plug ... PC Desktops

Monitor goes blank less than a second after turning on.


I start my computer and turn it on, and everything looks fine for about 1/4 of a second and then it goes black while leaving the power light green. I can only see the screen again after turning it off and on, but that's only for another 1/4 second. W ... Rosewill R700J 17" Flat Panel LCD Monitor

Screen not lighting up and staying black.


I have this monitor for 5 years now, and the same problem you described just happened to me. I attached another monitor that a friend of mine lend me, and this one worked just fine. So, I concluded that my monitor broke down, and also consulted with ... BenQ FP567s 15" LCD Monitor

X2gen mw19u 19'' widescreen monitor going black


X2GEN - MW19U, same problem as described in the other posts. A week ago after a reboot it did not turn on. Pressed the power button, it turned off. Pressed it again after about a minute, all was fine until this morning. Same as before except t ... X2Gen MG19MY 19" LCD Monitor

Benq FP937s Monitor - no display


Usually this type of problem is due to a faulty electrolytic capacitor on the monitor's power supply board or the inverter board that powers the backlight lamps. If you have a soldering iron and some technical skill it's possible to repair this your ... Gateway FPD2275W LCD Monitor
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.8639 seconds