Having problems with your Computer Monitors ?

Samsung syncmaster 730b blinking. switches from

\015 Samsung syncmaster 730b blinking. switches from digital to analog and back again. is there a way to fix this. not sure if it is compatable with my tower.\015

Answers :

Oct 23, 2009\015\012- This is how it went for me..I have a Samsung SYNCMASTER2.gif 2053BW. I leave my monitor on and let it hybernate when I shut down PC. I'm 3 months outside of my warranty. Two weeks ago something started happening. I boot PC and video doesn't come up for 10 minutes, and when it came up it worked perfect. VC/Monitor/MB?? It became 20 minutes and ...now..I have the analog/digital box in top left screen, power light on monitor flashing, no menu available on monitor and none of the other buttons work for anything. I test the monitor on Laptop..nothing(same as above)..I break out the old(working) monitor from deep within the closet. Plug it in and I'm up and running. So...

HOW TO OPEN A SYNCMASTER 2053BW

NO SCREWS!!! Assuming that the stand mount has been pulled out..The seam around the screen frame is where you start. The frame has the prongs, the back cover has what the prongs slip over.The frame is coming off first! I got the side to open by finger, then used a small standard screwdriver to pry ever so gently(lifting frame from rearcover). Leave the power button assembly on the frame, pull wire only a little to relax any tension..you get about 3/4" in extra taped to panel. The hard part is done.;) Still holding the frame...Now lift the panel (where the power button assembly wiring goes under panel) with the power housing that is under it as a whole and you will see where the powerbuttonassemble detaches.Remove frame. Now..holding edges of panel into back cover, lift and flip the whole thing over and place panel face down on a perfectly flat surface..a towel on my desk works. Lift and remove back cover.Your now looking at the back of the board housing. The ribon is simple, on the panel end of the ribon, squeez the outer clips together and slide it away against the panel..The secondary tin plate is removable, two clips super close to where the sets of wires come around the housing and into the panel.Unhook the 4 plugs(pink inside/blue outside)...Now lift the power housing off of the panel. The big board has the power. One screw to remove a ground plate first. Two screws to remove power board. Pics from phone.56ec44b.jpg
aae8fab.jpg
Reassemble but DO NOT re-snap the frame into place....yet... Test it! There is a reason the caps got hot in the first place, therfore it has a good chance of happening again. This is not fullproof...but.....mine has been on now for close to 6 hours with no glitches whatsoever. So I have resnapped mine back together. I hope you can too.\015\012- I must also add that this is one of the best producing monitors I have ever seen...in 60hz. The clarity is top notch. If you purchase one get the extended warranty. FYI...I paid $4.00 for those caps.
I did this on my Samsung SyncMaster 204B, Worked like a charm!! The two caps on my board were 820mf 25V. My local electronics store didn't have them (forget radio shack, they **** now), I substituted 1000mf 25v caps. Works great !!
\015\012
\015\012I have to admit I was skeptical but the monitor was worthless at that point anyway. I'm thrilled I was able to save it!!
\015\012
\015\012Thanks for the outstanding advice. I owe you a beer!
\015\012
\015\012
\015\012
\015\012Scott
Repair Help & Product Troubleshooting for Computer Monitors

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My acer laptop with windows xp will not allow me to select the optimal resolution for my samsung moniter. How do I fix this?


The Samsung SyncMaster 730b is a 17-inch analog and digital TFT-LCD monitor delivering crisp, clean text and bright, vivid colors. This display offers a 600:1 contrast ratio, 300 cd/m2 brightness, 1280 x 1024 resolution, 160/160 degree viewing angle, ... PC Desktops

Samsung syncmaster 730b blinking. switches from


Oct 23, 2009\015\012- This is how it went for me..I have a Samsung SYNCMASTER ... Computer Monitors

Ground Noise Problem Possibly Attributed to Samsung Monitor


Do you have another power adapter to try? Sometimes those go bad, and are pretty cheap to test out (around $35-$50). Otherwise it is the DC-in board on your PowerBook. I replace about 2 of those per month with our clients up here on the PowerBooks ... Samsung Syncmaster 730B 17" Flat Panel LCD Monitor

Samsung SyncMaster 730B monitor green color problem


Video controller card has gone bad need new video controller card. ... Samsung Syncmaster 730B 17" Flat Panel LCD Monitor

Samsung syncmaster My son's lava lamp fell behind his desk and in the process banged up against the top of the monitor. Then his screen turned everything to a blueish cast. He can still read and see everything it's just tinted blue now. Is there a reset button on the monitor. He has a brand new computer and it appears the same with each CPU attached to it.


My samsung 730B moniter will not run how do I fix it? ... Samsung Syncmaster 730B 17" Flat Panel LCD Monitor

Help I have a Samsung Syncmaster 730B LCD Monitor. It won't turn on. The green power light just flashes on and off. Can you help?


... Samsung Syncmaster 730B 17" Flat Panel LCD Monitor

Samsung Syncmaster 730B 17 in. Flat Panel LCD problem. While viewing email screen went black. Any suggestions on how to fix? All connections are good and restarting hasn't helped. Monitor is only a few years old.


Try it on another computer, it could be your video card that died. ... Samsung Syncmaster 730B 17" Flat Panel LCD Monitor

Vertical line that won't go away - Samsung Syncmaster 730B 17" Flat Panel LCD Monitor


Try another monitor just in case your video card is doing something funny - if that display works fine, you need to replace your monitor\015\012\015\012Hope this helps,\015\012Sherwin ... Samsung Syncmaster 730B 17" Flat Panel LCD Monitor

Picture not filling monitor screen


For that problem, you should try to system restore your computer to the point before the problem occurred.That's the way I fixed mine. ... Samsung Syncmaster 730B 17" Flat Panel LCD Monitor

Monitor; Power light on, screen blank - Samsung Syncmaster 730B 17" Flat Panel LCD Monitor


Do you have a second monitor you can switch out? Have you checked the monitor itself to make sure it's not set for digital vs. analog (or vice-versa)? Are all cables and plugs tight and secure? Has the brightness level been turned down? These are all ... Samsung Syncmaster 730B 17" Flat Panel LCD Monitor

Green light just flashes on and off and there is no displ


Try to check your screen resolution maybe not compatible to your System. if green flashing there no signal from cpu to VGA cable monitor. ... Samsung Syncmaster 730B 17" Flat Panel LCD Monitor

Samsung syncmaster 953bw


Oct 23, 2009- This is how it went for me..I have a Samsung SYNCMASTER ... PC Desktops

Samsung syncmaster 245b plus


Oct 23, 2009- This is how it went for me..I have a Samsung SYNCMASTER ... Samsung 226BW Monitor

Samsung SyncMaster 713BM


I have the same monitor with same probelm. I dont know if this is problem with samsungs specific model but the only way to work is the follow.1. connect your pc to another monitor and set the resolution to 1024x768. ... Samsung SyncMaster 713BM 17" LCD Monitor

Syncmaster paower button blinking and no display


First of all plug another monitor to the VC on your PC and do the same for the SamSung"I over heat"SyncMaster2 053BW. \015\012 \015\012\015\0 ... Samsung SyncMaster 204B 20.1" LCD Monitor

Hi, I'm having an issue with a Samsung monitor. On


Oct 23, 2009- This is how it went for me..I have a Samsung SYNCMASTER ... Samsung SyncMaster 920NW Monitor

Cannot find VESA holes...Samsung Syncmaster 970p


I have looked at the specification for this, and although it does show as being VESA compatible (This is a display standard)\015\012\015\012There is no mention of any "wall mounting" capabilities at all, which would lead me to believe that this is no ... Samsung SyncMaster 970P 19" LCD Monitor

My samsung monitor syncmaster 743nx is not turning on..plss help me...tnx


How to troubleshoot a Samsung SyncMaster 743NX LCD \015\012Monitor?\015\012 My Samsung SyncMaster 743NX \015\012monitor turns on slowly. I mean,last week when I started up my pc,it \015\012took 5-10 mins before my monitor displayed a ... Computer Monitors

Samsung SyncMaster 214T flickers


Hi There,I managed to fix my Samsung SyncMaster 214T from that flickering. Just changed 3 capacitors and it worked fine!! ... Samsung SyncMaster 214T (Silver) Monitor

Samsung SyncMaster 226bw 22inch flickers/blinks on startup


The Samsung 226BW is to nice of a monitor to trash. The problem you are having is a known symptom of a failure on the power supply board and is an easy fix. Here is a link to repair information on the 226BW. To rebuild the power supply board you just ... Computer Monitors

Samsung lcd 913v self test ok, no image when vga connected


This problem often occurs in samsung SyncMaster LCD monitors.The\015\012solution is open your look for the LCD monitor power supply module\015\012(which have PCB connector to the AC power), on that board look for\ ... Samsung SyncMaster 913V 19" LCD Monitor

Samsung syncmaster 713bm hoe can i reset it to factory settings?


I have the same monitor with same probelm. I dont know if this is problem with samsungs specific model but the only way to work is the follow.1. connect your pc to another monitor and set the resolution to 1024x768. 2. set the herz to 60mhz. ... Samsung SyncMaster 713BM 17" LCD Monitor

Drivers lcd samsung syncmaster 740n for Xp


... Samsung SyncMaster 740N 17" LCD Monitor

I have a Samsung Syncmaster 2053bw. Screen


First of all plug another monitor to the VC on your PC and do the same for the SamSung"I over heat"SyncMaster2 053BW. Reply! ... Samsung Computer Monitors
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0373 seconds