Having problems with your Computer Monitors ?

Montor black with power light red no signal input

Answers :

Did you try to check the VGA connector maybe cause a damage or not properly connected due encounter block screen or no signal or question mark sign like this (?) color yellow
or use other VGA connector try to do it
Repair Help & Product Troubleshooting for Computer Monitors

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dell E173FP Screen blinking red, green, blue, white

The monitor is probably on protection.To start unplug monitor\015\012from power and from computer and test computer with different monitor\015\012to find out if it is monitor or computer fault.If it is computer fault and no vi ... Dell E173FP 17" LCD Monitor

ViewSonic VX922 monitor - black screen - green power light flashes

PLEASE read Carefully so here is a fix for the green blinking light ...the monitor is going into shutdown....protect mode......THIS is ...Only for the seasoned electronic service tech ......YOU NEED TO BE into Electronics ..or have electronic backgro ... ViewSonic VX922 19" Monitor Flat Panel

No power and auxiliary power led on in orange

Could be a bad power supply, bad motherboard, bed device such as a disk drive dragging your system down, or a bad card plugged into the motherboard. Easiest thing is to remove devices such as PCI cards and hard drives one at a time to se ... Dell OptiPlex GX620 PC Desktop

Power light on& status light on

The power red led indicates that your device is "power on" , but the status led still red and turn to green if the device ( video input )received video signal ( from DVD player, Laptop etc. ) . ... PC Desktops

Gateway MT3421 Laptop start-up Issues

Start by removing the battery completely, and plugging the power cord into the wall socket. If the power indicator light comes on at the converter on the cord, your power cord is fine. Then plug the power cord into the computer. If the computer star ... Gateway MT3422 RTL Notebook

Hp pavilion dv5-1002nr will not power up - HP Pavilion dv1000 Notebook

Let's run through a basic flow chart.1.Plug the AC adapter, (Charger), into the laptop.Is the Power LED light on, and the Battery charging light?[The Power LED light is on the front edge of your laptop, all the way ... HP Pavilion dv1000 Notebook

Dell E171FP Monitor goes black after 2 secs

Hi, I don't think the problem is with your monitor. Your monitor sounds like it's doing exactly what it's supposed to do. The monitor is supposed to turn off if there's no cable attached, which means there's no signal input. When the screen goes b ... Dell E171FP 17" Flat Panel LCD Monitor

Directions for setup tascam 1641 audio interface, with g5 os 10.5.6 processor name: PowerPC 970 (2.2)

Hi Dear we are provide some of the link for "TASCAM 1641 AUDIO INTERFACE "\015\012\015\012\015\012http://www.tascam.com/details;9,15, ... PC Desktops

Sony Monitor says "No Input Signal, switch to Power Save"

Hi. there has been a surge that has tripped the surge protector. this surge may have destroyed the mother board , in return, rendering the ICs dormant. you can test this theory but unplugging the CPU and moniter from this blown surge protector and pl ... Sony SDM-HS75/B 17" LCD Monitor

I have a Cornea 1702. It just stopped working altogether. It doesn't even show the menu nor does it search for a signal as it used to while scrolling thru options or select input! I think it's fried, but I remember some time ago i thought it was all done then it started working again. any thoughts?

OK, first off, I'd like to say that I've never worked on the Cornea 1702, but most monitors follow similar designs, especially generic brand monitors.So there are a few things I need to know: What exactly happens when you press the ... Cornea CT 1700 17" Flat Panel LCD Monitor

Montor black with power light red no signal input

Did you try to check the VGA connector maybe cause a damage or not properly connected due encounter block screen or no signal or question mark sign like this (?) color yellowor use other VGA connector try to do it ... Computer Monitors

HP f2104 LCD black screen

My tv power light comes on,but the screen stay black,and in the back of the tv there is a red light that flashes. ... HP f2105 21" LCD Monitor

My monitor will not come on when power is applied automatically. the monitor does not come up when my system comes on. I just replaced the monitor which i swapped same exact monitor, but this one will not boot when the system comes up.

Please work through the following steps to troubleshoot your no power problem with a ViewSonic Monitor:\015\012\015\012Troubleshooting Power Issues: \015\012\015\012Disconnect and securely reconnect ... ViewSonic E70f 17" CRT Monitor

Sony VAIO VGC-RB50 No Power

Most likely you have a problem with your power supply. First off make sure your Input voltage selector switch is properly set. This switch should be located next to the power cord. In most cases it is red in color, and will have "115V" and "230V" ... Sony VAIO VGC-RB50 PC Desktop

Monitor not wrking

Sounds like you may have had a power surge.??\015\012Disconnect power and signal input. \015\012Turn the unit off for 20 minutes or so. Check the outlet against another device. ( Light )\015\012Turn unit on without connection to PC ... Samsung SyncMaster 2233BW 22" LCD Monitor

Dc jack How do I replace the dc jack input on the Sony PCGK37

The PCG-K37 (Sony VAIO Laptop) uses a DC Jack soldered to a two-wire jacketed (shielding) cable that is routed under the DVD (tray) and towards the back to the Voltage Board located under the Touch Pad (Mouse) via a white polarized plug. The wires ar ... Sony PCGK37 Notebook

Turned it on a minute later went black - Westinghouse L1975NW Monitor

Good day sir/ma'am hi, if you monitor turns black, here are the more common probable reasons;\015\012\015\012\015\012Your PC went to standby the screen saver kicks in, just reset your PC then the monitor will power on again. ... Westinghouse L1975NW Monitor

The blue light is blinking and the monitor is black

The monitor is probably on protection.To start unplug monitor\015\012from power and from computer and test computer with different monitor\015\012to find out if it is monitor or computer fault.If it is computer fault and no vi ... Envision 19" Widescreen Flat Panel TFT LCD Monitor

Gateway Monitor keeps going black

Alicia, Your monitor digital board is OK. The problem is with the power supply/ Inverter board(s) in back of the LCD/LPD Panel that you look at. You will need to question Gateway to see if they have a swapout program where you send them $30-$60 and y ... Gateway FPD1760 Monitor

Monitor Display Problem.

The first Polyview has a power supply problem (a short) and locks out the power until it is unplugged. You need to check the voltages inside the Monitor to determine which component/s are faulty. I hope you know electronics if not leave it to the r ... Polyview V17E 17" LCD Flat Panel Monitor

My monitor stays white it wont show any display

Hi,\015\012\015\012\015\012\015\012This icon indicates the BRIGHTNESS control, more properly called\015\012BLACK LEVEL. It adds or subtracts an offs ... Computer Monitors

Hp pavilion dv6000 Blank SCREEN

OK, if you had the problem I had, I have a solutionI had a problem where i could turn it on, i could hear the fan and disk spinning but the screen would stay black and blank. The keyboard lights and wireless connection light turned on, bu ... HP Pavilion dv6000z Notebook

-Orange light on Power-up button stays lit. -No Video, just black screen. using AGP Video card TNT 32mb / Model CT5823 I've replaced the battery, double checked the cables, Power supply is good. Gatew

This is typical of a failed power supply. Look on the back of the power supply, there may be a red switch for input voltage. Unplug the power cord, flip that switch a few times and then plug the cable in and try again. If nothing changes, see if t ... Gateway PC Desktops

Power on - blank (black) screen

Disconnect the monitor signal cable from PC and switch on your monitor. It should show some logo with Red, Green and Blue colors with a message similar to "No signal". If so, your monitor is working fine. Sometimes if the brightness and contrast is ... Dell E152FP 15" Flat Panel LCD Monitor

Westinghouse LCM-19V7 powers on, but picture only stays for a sec

It's probably bad capacitors on the power supply board. These monitors are notorious for having the electrolytic capacitors blow out; cheap components! I would suggest replacing the two 1000 mfd capacitors and the three 220 mfd capacitors w ... Westinghouse Computer Monitors
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.6517 seconds