Having problems with your Computer Monitors ?

The screen says no signal

\015 All cords are hooked up and power is on, but says no signal.. had this problem before, and they replaced the monitor. was working, now encountering same problem\015

Answers :

Do you have another computer to try this monitor on? Usually the no signal means that the video, on the computer, isn't doing anything.
Repair Help & Product Troubleshooting for Computer Monitors

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Emachine T6410 turns on but the screen says ''No Signal''


When you get the no signal ..this is just the cable that plug into the monitor...either on the video card ..or on the monitor side...but it is sure the cable ...whenever that signal is on ...this means that it do not detects any video signal came fro ... PC Desktops

LG screen goes in stand by. I was using two monitors for several months, everything OK, now I decided to get a new LG Flatron instead of one of the monitors... and only this one goes in safe mode!! Two screens plugged in: Philips analogical working fine no problems. New LG Flatron digital goes in power save mode after few minutes Tried to plug in ONLY the LG, same problem after few minutes. Philips monitor no problems. So it HAS to be a screen function or problem of the LG? Computer: AMD + 3Ghz


Oke having a similar problem atm, this is what i have found so far. was trying to help a friend who has bought the same 19" LG monitor. When i connected the monitor to her PC i noticed that it was not the same connection as the previous one but it ha ... LG 19" Widescreen Flat Panel LCD Monitor

Fujitsu-Siemens P15 TFT power/picture problem. it take time to turn on.


It does indeed sounds like the capacitors, I had this problem last year with a Medion monitor where it would turn on and off, when I spoke to Medion they did say that it would need a repair but at the time I wasn't enclined to pay the repair fees for ... Fujitsu Siemens Premium Line P15-1 15" LCD Monitor

Screen says no signal input.


Well,this probably implies a lot of problems. 1.Check the video adapter cable,make sure the pins are not bent or broken. 2. Open the case panel of the left side and disconnect and remove components such as Vga card,rams,hdd,roms,floopy drive,other ag ... Compaq Presario 5000 PC Desktop

Monitor screen begins as computer is booting up and then screen goes black. Message says there is no signal.


If the power light dims or changes color after the no signal message comes up, that means the monitor went to sleep.While the monitor is plugged in and on and the computer is also on, Try unplugging the VGA cable from the monitor. wait 30 secon ... ViewSonic VG2230WM LCD Monitor

Gateway LCD powers on but has no picture


I have a Gateway FPD1730 LCD monitor. When I plug it into my Gateway 500x desktop the power light turns green and then says "Power Saving Mode" and then it goes black. It will occasionally flash on and have a picture and then go off. When I unplug th ... Sceptre X9G Komodo IV 19" Flat Panel LCD Monitor

Computer turns on but does not boot windows, no bios screen


My neighbors e machines goes to the start windows normally screen, and then pops up this bright blue screen, but you can't read anything cause its like in a nanosecond gone, then says no signal, then to the bios screen and keeps repeating and repeati ... Dell Dimension 2400 PC Desktop

NO SIGNAL What do I do?


These messages are normal when the computer truly goes into suspend mode or loses the video signal (such as when the computer is suddenly turned off).If the monitor displays any of these messages when the computer should be displaying vid ... HP PAVILION A6230N DESKTOP PC

Viewsonic VA712b issuses


Digital-to-Analog Converter - DAC\015\012\015\012\015\012\015\012\015\012When referring to Audio, DAC is also short for Digital-to-Analog Converter and is the pro ... ViewSonic VA712B 17" Flat Panel LCD Monitor

Lcd monitor power light flashing with no img. seems 2 be frozen


The display is in safe mode and you will need to reset the display to get the display out of the safe mode. There are 2 different model revisions. Please choose the method that will match your revision. Depending on the revision of the monitor, one ... Planar PL1910M (Black) 19 in. Flat Panel LCD Monitor

Screen comes on says Acer then No Signal, and goes out. if shut power off and then back on get same result.


This means the monitor believes it's not connected to the computer. Verify the cables first of all. Then try booting in safe mode (F8 key at PC startup) in order to verify that the PC is sending data to the proper video port (you might have a dual VG ... Acer AL2223W 22" LCD Monitor

Problm with viewsonic va712b


Sounds like the operating mode is at a frequency or refresh rate that is outside the viewsonic operating specifications when in normal mode. possible solution: in safe mode access control panel, system, devices (hardware) and look for display. do a r ... ViewSonic VA721 17" LCD Monitor

Vx1932wm-3 monitor has stopped working properly,it will only stay on for around 2sec then lose digital signal and go black,same with analog.cant seem to make it stay on,the light on monitor is blue when it says lost signal, the graphics card is working fine 9400 series nvidia


I had the exact same problem. It's a bad capacitor on your power board. It's most likely the 1000uF 25v one towards the center of the board. I noticed it on mine because the top of the capacitor was pushed out more than usual and it has some residue, ... ViewSonic VX1932WM LCD Monitor

Dell 2407WFP Monitor losing signal and having colored line artifacts


... Dell UltraSharp 2407WFP 24" LCD Monitor

My monitor ( with less that 6 months use) has been going off while someone is using it--- says out of signal and i have to restart the comouter... and this is not stopping even with a restart


Julezj, You will need to connect your monitor to a KNOWN GOOD pc that DOES NOT have the screen saver set to do a time out when the keyboard is inactive. Whenever you state a problem with a monitor on fixya, please mention the monitor technology you a ... Gateway Computer Monitors

W17e says "input not supported"


Hi - here's what I found about your wide screen monitor:The HP Pavilion w17e LCD wide-screen monitor has the following features:\015\012 \015\012\015\0121440 x 900 factory-set resolutio ... Acer AL1916W 19" LCD Monitor

My monitor says no signal


A friend gave me this computer because he got another and was tired of messing with this one ... he says he turned it off one night and it would never boot back up , sso i had a new 160 gig hd which is the same that was in it and i installed it think ... E-Machines eMachines Monitor E15T4

When it powers up the screen is fine then it goes black with no signal box, then if you turn it off and on again screens comes back for few seconds and then off again, sying no signal. Viewsonic LCD monitor VP720b


The lcd has three parts the screen plate(windows)/the logic(vga)/the inverter(power plug). Parts that go are the backlight ccfl's, behind the plate, and parts of the inverter, ie capacitors, all three take a bit of power from the inverter. The self t ... ViewSonic VA720 17" LCD Flat Panel Monitor

PC or monitor, signal problems


Your monitor is telling you it's on it's last legs..either that or your compaq has a bad video section. either is more vital than a video cable being loose. ... PC Desktops

Computer screen says no signal


It could be that the monitor is out of range. plug in an old crt monitor if it works go to display options (where you change your background) click on the settings tab and move the res. to 1024x768 ... Acer P191WBD LCD Monitor

No Composite Input Signal Message on Screen


Push the PIP button until it says off ... Dell UltraSharp 1907FP 19" LCD Monitor

Black screen saying no signal


Turn off the computer and get a can of compressed air blow out all the dust and make sure everything is tight put back together and see iff it works. geek squad charges 99.99 to do this in store. ... AOC LM729 17" LCD Monitor

Samsung SyncMaster 913N screen not working


There are two places to look for the problems, the backlight inverter board and the power supply. Look at the power supply first since it is easier to get to, look for burnt parts, bad capacitors, etc.\015\012 ... Samsung SyncMaster 2233BW 22" LCD Monitor

Dell Inspiron 6000 to TV


On a dell laptop, the key combo FN  F8 cycles through the display options. Laptop screen, External screen, Laptop and External screen at the same time.  Try pressing the FN F8 key to get the video to display on both laptop and lcd and the s ... Dell Inspiron 6000 Notebook
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 0.6572 seconds